Radio Shack PASC12 user manual

Summary of the content on the page No. 1










































Summary of the content on the page No. 2

Introduction Thank you for purchasing this Pyle Pro PASC series speaker. The loudspeaker is designed to provide you years of high performance in any application that you require. Please read this manual carefully to fully maximize the performance of the speaker. Features The PASC series features high- level drivers and rugged components and is designed for high-performance applications. The cabinet features heavy-duty construction with reinforced corners. It is covered with

Summary of the content on the page No. 3

parallel, which allows you to daisy chain additional speakers. Thus you can use one amplifier channel to power multiple speakers. Make certain that the wires you are using are at least 12 gauge unshielded speaker cable (the lower the number, the thicker the wire). Do not use shielded “instrument” cables. Hooking speakers up in parallel decreases the overall impedance, placing a greater load on the amplifier. Check your amplifier’s specifications to ensure that you are not overloading

Summary of the content on the page No. 4

narrow pickup pattern. You should therefore place the monitor in the rear, but at a slight angle. High frequencies are unidirectional while low frequencies are omni directional. Being that this is a full range enclosure, it is important that the speaker be placed so that the high frequencies reach the intended listeners properly. Make certain that no person or object could come to interrupt the line-of-site between the loudspeaker and the performers. When using more than one loudspeaker,

Summary of the content on the page No. 5

Troubleshooting No Sound:
 Check connections
 Try a different speaker cable
 Check levels on amplifier
 Confirm amplifier is getting a signal (check signal LED, or use headphone output) Intermittent Output:
 Check connections
 Try a different speaker cable Weak Bass:
 Check the polarity of the speaker connection. It may be reversed.
 Listen with headphones to confirm the amplifier is being sent a good signal. Distorted Sound:
 Check if the amplifi

Summary of the content on the page No. 6

Typical Setup Parallel Setup


  6

Summary of the content on the page No. 7

Recommended Accessories







 





 

 # $%

    
 
&' $

(  %
        )*+  

 !" 


















 

 





 

 # $%