Pro-Ject GENIE RPM 1 user manual

Summary of the content on the page No. 1

INSTRUCTIONS FOR USE
Pro-Ject RPM 1 Genie

Summary of the content on the page No. 2

9 8 4 1 11 5 6 2 16 7 3 10 Controls, features and connections 1/11 Motor unit with stepped drive pulley and power switch 2 Drive belt * 3 Platter 4 Tonearm counterweight * 5 Tonearm lift lever 6/16 Tonearm rest and removable transport lock 7 Tonearm tube 8 Power supply socket 9 Phono output sockets and earth connection 10 Headshell with finger lift and fitted Ortofon OM 3E cartridge Connection cable (not shown) * Power supply with power switch (not shown) * Stylus pressure ga

Summary of the content on the page No. 3

PRO-JECT RPM 1 Genie Dear music lover, thank you for purchasing a PRO-JECT AUDIO record player. In order to achieve maximum performance and reliability with this record player you should study these instructions for use carefully. Warning of a hazard for the user, the unit or possible misuse. Important notice. The record player is supplied with a factory fitted and adjusted cartridge. ** The following instructions for adjusting the cartridge are provided in case the cartridge is rep

Summary of the content on the page No. 4

Adjusting the azimuth ** The cartridge needle must be vertical in the record groove in order to trace the groove wall modulations correctly. A small screw at the bearing end of the arm allows incorrect azimuth to be corrected if your needle is not mounted exactly perpendicular to the cartridge body (which is often the case). Screw Slacken off the screw just enough to be able to revolve the arm tube without applying force. Please note: do not remove the screw completely! With the aid of

Summary of the content on the page No. 5

Maintenance and cleaning Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage. If the player is not used over

Summary of the content on the page No. 6

Potential incorrect use and fault conditions PRO-JECT turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the m

Summary of the content on the page No. 7

Platter Chassis Motor © Audio Trade GmbH · Pro-Ject RPM 1 / Ortofon OM 3E · Revision 1.3.08/1.5.08 7 Power supply Interconnect cables