Genelec HTS6 user manual

Summary of the content on the page No. 1

Operating Manual
HTS6
Genelec HTS6
Active Subwoofer

Summary of the content on the page No. 2

HTS6 Active Subwoofer unpacked, place the subwoofer in a suitable low frequencies the effects of the room are General description location (For more details see the ‘Position- strong. Even a slight change in the subwoof- Genelec HTS6 is a powerful active subwoofer ing’ section). er's location can make a marked difference designed specially for high quality digital 5.1 Before connecting the audio signals, in the frequency balance and often patient channel Home Theater systems. Its 19 to ensure

Summary of the content on the page No. 3

Figure 2. XLR to RCA connector for unbalanced operation. Subwoofer placement Bass Roll-Off setting Near to a wall -2 dB In a corner -6 dB Flush mounted -2 dB Figure 1. HTS6's connector panel, connectors and controls. Table 1. Suggested Bass Roll-Off settings symmetrically and at an equal distance from front of the grilles. subwoofer. An input voltage of -6 dBu with a the listening position. The reflex port and connector panel should -6 dBu input sensitivity setting will produce If the frequ

Summary of the content on the page No. 4

Phase Difference: 0˚ Phase Difference: 90˚ 120 Hz 120 Hz Remote Pole or Connect to control type contact remote control Phase Difference: 270˚ Phase Difference: 180˚ input pin no. 12 V DC + 1 remote - 2 control 120 Hz 120 Hz External Contact 1 3 switch or Contact 2 4 relay Connect only one remote control unit at a time Figure 4. The effect of phase difference between the subwoofer and the main speakers Table 2. Remote control connector pin sequence speakers and subwoofer at the listening To

Summary of the content on the page No. 5

GENELEC GENELEC GENELEC GENELEC Figure 6. Flush mounting the subwoofer. Note the clearance needed on the reflex port side. ABSORBING HEA VY WOODEN MA TERIAL OR CONCRETE HEA VY W ALL WOODEN OR CONCRETE W ALL VIBRA TION VIBRA TION Figure 5. The curves above show the ISOLA T ORS ISOLA T ORS f ~ 2-8 Hz harmonic distortion analysis of the HTS6 f ~ 2-8 Hz in free field. In half space the SPL will be 6 Figure 7. Flush mounting the subwoofer in a Figure 8. Correct flush mounting in a semi- dB higher.

Summary of the content on the page No. 6

HTS6 Operating Manual SYSTEM SPECIFICATIONS AMPLIFIER SECTION HTS6 HTS6 Free field frequency response 19 Hz…120 Hz Short term amplifier output (+/- 3 dB) power (Long term output power is limited by driver unit Maximum short term sine wave protection circuitry) 1000 W SPL output averaged from 30 to 85 Hz, measured in Amplifier system distortion half space at 1 meter 124 dB SPL at nominal output THD 0.05% Maximum peak SPL output with random pink noise, measured Mains vol