Summary of the content on the page No. 1
Dell™ PowerEdge™ R310
Systems
Getting Started
With Your System
Guide de mise en route
Primeiros passos com o sistema
Procedimientos iniciales con el sistema
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Dell™ PowerEdge™ R310 Systems Getting Started With Your System Regulatory Model: E07S Series Regulatory Type: E07S002
Summary of the content on the page No. 4
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates potential damage to hardware or loss of data if instructions are not followed. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. ____________________ Information in this document is subject to change without notice. © 2010 Dell Inc. All rights reserved. Reproduction of these materials in any manner w
Summary of the content on the page No. 5
Installation and Configuration WARNING: Before performing the following procedure, review the safety instructions that came with the system. Unpacking the System Unpack your system and identify each item. Installing the Rails and System in a Rack Assemble the rails and install the system in the rack following the safety instructions and the rack installation instructions provided with your system. Getting Started With Your System 3
Summary of the content on the page No. 6
Optional – Connecting the Keyboard, Mouse, and Monitor Connect the keyboard, mouse, and monitor (optional). The connectors on the back of your system have icons indicating which cable to plug into each connector. Be sure to tighten the screws (if any) on the monitor's cable connector. Connecting the Power Cable(s) Connect the system's power cable(s) to the system and, if a monitor is used, connect the monitor's power cable to the monitor. 4 Getting Started With Your System
Summary of the content on the page No. 7
Securing the Power Cables Bend the system power cables into a loop as shown in the illustration and secure the cables to the brackets using the provided strap. Plug the other end of the power cables into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribution unit (PDU). Turning On the System Press the power button on the system and on the optional monitor if used. The power indicators should light. Getting Started With You
Summary of the content on the page No. 8
Installing the Optional Bezel Install the bezel (optional). Complete the Operating System Setup If you purchased a preinstalled operating system, see the operating system documentation that ships with your system. To install an operating system for the first time, see the installation and configuration documentation for your operating system. Be sure the operating system is installed before installing hardware or software not purchased with the system. 6 Getting Started With Your System
Summary of the content on the page No. 9
Supported Operating Systems ® ® Microsoft Windows Small Business Server 2008 Standard and Premium ( x64) editions Microsoft Windows Essential Business Server 2008 Standard and Premium ( x64) editions Microsoft Windows Essential Business Server 2008 Premium ( x86) edition Windows Web Server 2008 (x86) with SP2 Windows Server 2008 Standard and Enterprise (x86) editions with SP2 Windows Server 2008 Standard and Enterprise (x64) editions with SP2 Windows Server 2008 R2 Standard and E
Summary of the content on the page No. 10
Other Information You May Need WARNING: See the safety and regulatory information that shipped with your system. Warranty information may be included within this document or as a separate document. The rack documentation included with your rack solution describes how to install your system into a rack. The Hardware Owner’s Manual provides information about system features and describes how to troubleshoot the system and install or replace system components. This document is available o
Summary of the content on the page No. 11
Technical Specifications Processor ® ® Processor type Intel Xeon processor 3400 series or Intel Core™ i3 processor, or ® Intel Pentium processor Expansion Bus Bus type PCI Express Generation 2 Expansion slots One x16 half-length slot One x8 half-length slot NOTE: Both the slots support x8 routing. Memory Architecture 1066-MHz and 1333-MHz registered parity and non registered DDR-III memory modules Memory module sockets Six 240-pin Memory module capacities 1 GB, 2 GB, 4 GB, and 8 GB (RDIMMs on
Summary of the content on the page No. 12
Connectors Back NIC Two RJ-45 (for integrated 1-GB NICs) Serial 9-pin, DTE, 16550-compatible USB Two 4-pin, USB 2.0-compliant Video 15-pin VGA Front Video 15-pin VGA USB Two 4-pin, USB 2.0-compliant Internal USB Two 4-pin, USB 2.0-compliant Video Video type Matrox G200, integrated in BMC Video memory 8 MB graphics memory Power AC power supply (per power supply) Wattage 350 W (non-redundant power supply) 400 W (redundant power supply) Voltage 100–240 VAC, 50/60 Hz Heat dissipation 1571 BTU/hr max
Summary of the content on the page No. 13
Physical Height 4.29 cm (1.69 in) Width 43.4 cm (17.09 in) Depth 61.26 cm (24.12 in) Weight (maximum configuration) 15 kg (33.02 lbs) Weight (empty configuration) 5.96 kg (13.12 lbs) Environmental NOTE: For additional information about environmental measurements for specific system configurations, see www.dell.com/environmental_datasheets. Temperature Operating 10° to 35°C (50° to 95°F) with a maximum temperature gradation of 10°C per hour NOTE: For altitudes above 2950 feet, the maximum oper
Summary of the content on the page No. 14
Environmental (continued) Altitude Operating –16 to 3,048 m (–50 to 10,000 ft) NOTE: For altitudes above 2950 feet, the maximum operating temperature is derated 1ºF/550 ft. Storage –16 to 10,600 m (–50 to 35,000 ft) Airborne Contaminant Level Class G2 or lower as defined by ISA-S71.04-1985 12 Getting Started With Your System
Summary of the content on the page No. 15
Systèmes Dell™ PowerEdge™ R310 Guide de mise en route Modèle réglementaire : Série E07S Type réglementaire : E07S002
Summary of the content on the page No. 16
Remarques, précautions et avertissements REMARQUE : Une REMARQUE indique des informations importantes qui peuvent vous aider à mieux utiliser votre ordinateur. PRÉCAUTION : Une PRÉCAUTION vous avertit d'un risque de dommage matériel ou de perte de données en cas de non-respect des instructions données. AVERTISSEMENT : Un AVERTISSEMENT vous avertit d’un risque d'endommagement du matériel, de blessure corporelle ou de mort. ____________________ Les informations contenues dans ce document son
Summary of the content on the page No. 17
Installation et configuration AVERTISSEMENT : Avant d'exécuter la procédure ci-dessous, lisez les consignes de sécurité fournies avec le système. Déballage du système Sortez le système de son emballage et identifiez chaque élément. Installation des rails et du système dans un rack Assemblez les rails et installez le système dans le rack en suivant les consignes de sécurité et les instructions d'installation du rack fournies avec votre système. Guide de mise en route 15
Summary of the content on the page No. 18
Facultatif – Connexion du clavier, de la souris et du moniteur Connectez le clavier, la souris et le moniteur (si nécessaire). Aidez-vous des icônes des connecteurs situés à l'arrière du système pour savoir où insérer chaque câble. N'oubliez pas de serrer les vis situées sur le connecteur du câble du moniteur, s'il en est équipé. Branchement du ou des câbles d'alimentation Connectez le ou les câbles d'alimentation au système et, si vous utilisez un moniteur, connectez son câble d'alimentation
Summary of the content on the page No. 19
Fixation des câbles d'alimentation Faites une boucle avec chaque câble (voir l'illustration), puis fixez-le à l'aide de l'armature prévue à cet effet. Branchez ensuite l'autre extrémité de chaque câble d'alimentation sur une prise secteur mise à la terre ou sur une source d'alimentation autonome (onduleur ou unité de distribution de l'alimen- tation). Mise sous tension du système Appuyez sur le bouton d'alimentation du système et sur celui du moniteur en option, si vous l'utilisez. Les voyan
Summary of the content on the page No. 20
Installation du cadre en option Installez le cadre (si nécessaire). Finalisation de l'installation du système d'exploitation Si vous avez acheté un système d'exploitation préinstallé, voir la documentation connexe fournie avec le système. Voir la documentation relative à l'installation et à la configuration du système d'exploitation si vous installez celui-ci pour la première fois. Installez le système d'exploitation avant tout élément matériel ou logiciel acheté séparément. 18 Guide de mis
