Summary of the content on the page No. 1
Model No. KV-S3065CL / KV-S3065CW
These instructions contain information on operating the scanner. Before reading these
instructions, please read the installation manual enclosed with this unit.
Please carefully read these instructions, the enclosed installation manual and maintenance
manual. Keep all documentation in a safe place for future reference.
Keep the CD-ROM in the protective case. Do not expose the CD-ROM to direct sunlight or
extreme heat and do not scratch or smudge the surface of
Summary of the content on the page No. 2
Thank you for purchasing a Panasonic “High Speed Color Scanner.” ≥ Panasonic supports your imaging needs with a reliable and easy to use document scanner. ≥ Panasonic has developed Panasonic Image Enhancement Technology to improve the quality of your scanned images even beyond the quality of your original document. ∫ System requirements When using the scanner, the required host computer conditions are as follows. SCSI Connection USB Connection ® Minimum Pentium III, 1 GHz CPU Recommended Pent
Summary of the content on the page No. 3
Table of Contents Page Notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Precautions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Before Component Identification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 You Start ≥ Power turn-on sequence . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 ≥ About LED . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
Notice English WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR ANY TYPE OF MOISTURE. THE SOCKET-OUTLET MUST BE NEAR THIS EQUIPMENT AND MUST BE EASILY ACCESSIBLE. The product should be used only with a power cord that is supplied by the manufacturer. Power Source WARNING ≥ (220-240 V equipment) A certified power supply cord has to be used with this equipment. The relevant national installation and/or equipment regulations shall be considered. A certified
Summary of the content on the page No. 5
Notice (For United Kingdom only) For your safety please read the following text carefully. This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp. fuse is fitted in this plug. Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 5 ASA amps. and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover you must
Summary of the content on the page No. 6
Notice Caution Labels 6
Summary of the content on the page No. 7
Precautions The following precautions are recommended to extend the life of the unit: Prior to scanning, remove all sta- Do not place any liquids near the Do not place books, paper, or other ples and paper clips from pages. unit. items on the unit. —Accidental spillage of liquid into the unit may cause severe dam- age. If this occurs, turn the unit off, unplug the power cord and call for service. Do not place the unit in an area where there is a lot of Do not leave the power cord plugged into th
Summary of the content on the page No. 8
Precautions Operating Environment Do not place the unit in direct sunlight or in a cold draft. Do not operate or place the unit in a vertical position. Hot Cold Do not place the unit near a heating appliance or an air Do not place the unit near other appliances which gen- conditioning vent. Do not place the unit in a room with erate large electrical noise. extremely high or low humidity. Do not place the unit on a carpet. (Static electricity can Do not drink or inhale the included roller cleanin
Summary of the content on the page No. 9
Precautions ∫ CD-ROM To prevent the CD-ROMs from accidental damages: Do not touch or write on the surface Do not leave the disc out of its Do not leave the disc in direct of the disc. protective case. sunlight or near heat sources. Do not place heavy objects on the To clean the disc, hold the disc by disc case or drop the case. its edges and wipe it from the center to the edges with a dry, soft cloth. 9
Summary of the content on the page No. 10
Component Identification Exit tray Exit substopper Exit document guide Exit extension tray Power indicator When the power is turned on, Exit stopper the green indicator lights. When an error occurs, the indicator will change to red, and light steadily or flash. Document guide STOP/START button Used to stop or start scanning a document. Hopper Power switch Hopper extension tray [ : on position ± : off position Front door release Inside the front door. Front door Post-imprinter door (Back d
Summary of the content on the page No. 11
Component Identification ∫ Power turn-on sequence LED Turn on the power of the scanner. 1 ≥ The LED will now light. Turn on the power of the host 2 computer after scanner’s LED stays green. ≥In case of the USB connection, the host computer recognizes the scanner auto- matically when the scanner is powered on Power switch even after the host computer is powered on. ∫ About LED LED indicates the status of the scanner as follows: LED light Status Green Ready to scan or scanning Green (flashing) S
Summary of the content on the page No. 12
Component Identification ∫ About the SCSI setting (Not required for USB connection) When connecting the scanner to a SCSI chain using a SCSI cable, perform the SCSI ID setting correctly. The scanner is provided with a DIP switch for the SCSI ID No. setting. DIP switch SCSI ID Setting Switch ID No. Remarks #2 #1 #0 0 OFF OFF OFF 1OFF OFF ON 2 OFF ON OFF 3 OFF ON ON 4ON OFF OFF 5ON OFF ON 6 ON ON OFF Default setting 7ON ON ON 12
Summary of the content on the page No. 13
Loading Documents Acceptable documents Document size: 48~297 mm (1.9~11.7 in.) 70~431 mm (2.75~17 in.) 2 Paper thickness: Continuous paper feeding 40~157 g/m 2 Single paper feeding 20~157 g/m 2 Document smaller than A7 size 157 g/m (42 lbs.) only Maximum number of sheets loadable on the hopper tray: 2 g/m 40 52 64 75 80 90 104 157 lb. 1114172021242842 Width less than A4 short edge 350 320 300 250 240 210 180 120 Max. number of sheets Width between A4–A3 short edge 240 220 200 160 160 140 120 80
Summary of the content on the page No. 14
Loading Documents ∫ When scanning multiple sheets Cautions: ≥ Please remove any staples from the document before scanning. ≥ Curled documents may cause a paper jam or damaging the unit, so please set the document flat before scanning. ≥ When scanning very important documents, confirm if the number of scanned images matches the number of actual pages. Documents that have been stapled Prior to scanning, remove, all staples and paper clips 1 from pages. together or stacked together (as in a file f
Summary of the content on the page No. 15
A A A Loading Documents Place the documents on the hopper Portrait 4 with the side to be scanned facing up. Then push them in the direction of the A4, LTR Fill indicator arrow until they stop. (Limit mark) ≥Be sure to place the documents on the B4TA3 hopper as shown in the diagram at the right. The amount of documents should not exceed the limit mark on the document guide. This may cause a paper jam or skew. ≥The scanning document size is different for the KV-S3065CL and KV-S3065CW. Please refe
Summary of the content on the page No. 16
Loading Documents When using long paper, pull out the 6 Exit extension tray hopper extension tray from the hopper and the exit stopper from the exit extension tray. You can also extend the exit extension Exit stopper tray, if required. (See fig. 1) Hopper extension Fig. 1 tray ≥When scanning narrow documents as shown below, pull up the exit substopper. Exit substopper (See fig. 2) Fig. 2 Scanning direction Document ≥ Thin paper document may curl and not be stacked correctly. Exit substopper W
Summary of the content on the page No. 17
Paper Feed Settings ∫ Selecting the paper path for scanned document To select a U-turn path pass through to the front, set the paper path selector to the upper side. To select a straight path pass through to the back, set the paper path selector to the lower side. ≥ When scanning documents with a thickness of 0.2 mm to 1 mm, like folded documents, set the paper path selector to straight path. Paper path selector The paper path selector is located on the left side of the scanner. ∫ Setting the A
Summary of the content on the page No. 18
A B Simplex Others ∫ How to use the control sheet and separation sheet If the control sheet is used, the documents under the control sheet are scanned in Documents accordance with the code on the control sheet regardless of scanning condition that is selected previously. Control sheet ≥ Multiple control sheets can be used. Code ≥When using a control sheet, the application software required depends on the control sheet. ≥Print out control sheets from the provided CD- ROM. Documents Cautions: ≥Use
Summary of the content on the page No. 19
Changing the Reference Plate Setting You can choose a background color to be scanned from white (black) to black (white). The scanner comes from fac- tory set to black. The reference plate (B) and reference plate (F) setting must be changed simultaneously. ∫ Reference plate setting Turn the power off. 1 Use your hand to pull the front door 2 release towards you ( 1). Then open Front door 2 the front door completely ( 2). 2 1 Front door release (Inside the front door.) 1Using your finger, move t
Summary of the content on the page No. 20
Changing the Reference Plate Setting Close the front door. 4 ≥Push both sides of the front door down slowly until it clicks into place. 20
