Summary of the content on the page No. 1
OPERATOR’S MANUAL
Zero Clearance Insert
AC1045
(For Use With Ridgid 10 in.
Table Saws TS3650
and TS2400LS)
Your Zero Clearance Insert has been engineered and manufactured to our high standards for dependability, ease of opera-
tion, and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance.
WARNING:
To reduce the risk of injury, the user must read and understand the operator’s manual before using this product.
Thank you for buying a RIDGID product.
Summary of the content on the page No. 2
TABLE OF CONTENTS n Introduction ...................................................................................................................................................................... 2 n Rules For Safe Operation ................................................................................................................................................. 2 n Symbols..................................................................................................................
Summary of the content on the page No. 3
RULES FOR SAFE OPERATION Safe operation of this accessory requires that you read and n A SEPARATE ZERO CLEARANCE INSERT IS understand this operator's manual, the operator’s manual RECOMMENDED FOR EACH BLADE, dado blade or for the table saw and all labels affixed to the tool. different set-up. n SAVE THESE INSTRUCTIONS. Refer to them frequently READ ALL INSTRUCTIONS and use them to instruct other users. If you loan someone n KNOW YOUR ACCESSORY. Read the operator's manual this product, also
Summary of the content on the page No. 4
SYMBOLS The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention measures. SYMBOL MEANING DANGER: Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious
Summary of the content on the page No. 5
INSTALLATION n Position the zero clearance insert until the key slot drops REMOVING THE EXISTING THROAT PLATE over the flat head screw. AND INSTALLING ZERO CLEARANCE INSERT n The zero clearance insert should be flush with the table FOR THROUGH CUTS top. Adjust the four set screws as needed. (See Fig 2.) See Figures 1 and 2. NOTE: If necessary, adjust the side positioning set screw found on the edge of the zero clearance insert to eliminate WARNING: side play. Tighten the flat head screw.
Summary of the content on the page No. 6
INSTALLATION n Check all clearances for free blade rotation. INSTALLING ZERO CLEARANCE INSERT/ n Reconnect power to the saw DADO SETS n Turn the saw “ON”. See Figure 2. n Slowly and cautiously raise the dado blade into the zero WARNING: clearance insert. Make sure the switch is off and the plug is out of the outlet. Failure to do so could result in accidental WARNING: starting, resulting in serious personal injury. Never stand directly in line with the blade or allow hands to come closer th
Summary of the content on the page No. 7
NOTES 7
Summary of the content on the page No. 8
OPERATOR’S MANUAL Zero Clearance Insert AC1045 (For Use With Ridgid 10 in. Table Saws TS3650 and TS2400LS) Customer Service Information: For parts or service, contact your nearest RIDGID authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest you, please call 1-866-539-1710 or visit us online at www.ridgid.com. When ordering repair parts, always give the following information: AC1045 Model No.
