Grizzly G1127 user manual

Summary of the content on the page No. 1

G1127 EXTENSION BLOCK KIT
FOR THE G1019 BANDSAW
•Review this instruction
sheet in its entirety before
beginning installation.
Failure to follow these
Grizzly’s G1127 Extension Block increases the cutting height of the Model
guidelines will result in
G1019 Bandsaw by six inches. With the extension block installed, the saw is
serious personal injury.
capable of cutting stock up to 12" in height.
•Unplug the bandsaw
before beginning this
For best results while installing the Extension Bloc

Summary of the content on the page No. 2

7. Remove the table (see the Manual Instructions regarding “Table”). Straight Edge Roughly align the upper and lower wheels by laying a straight edge across both wheels See Figure 2. Tighten the bolt until it is tight, 1 1 then loosen it ⁄4 to ⁄2 turn. 8. Install the 105" blade supplied in the kit Ref #10 following the instructions in the G1019 Manual. Apply tension to the blade as described in the manual. Adjust the tracking knob until the upper and lower wheels are parallel. 9. Check whe

Summary of the content on the page No. 3

G1127 Extension Block Kit Parts List A C 4 F 5 1 8 2 D D G H 5 7 K 6 E 3 J B 10 Ref. # Part # Description 001 P1127001 Extension Block 002 P1127002 Extension Guide Post 003 P1127003 Extension Blade Guard 5 004 P1127004 Hex Bolt ⁄8"-11 x 8" 5 005 PW14 Flat Washer ⁄8" 5 006 PN06 Hex Nut ⁄8"-11 5 007 PLW06 Lock Washer ⁄8" 008 P1127008 Guard 009 P1127009 Pin 010 P1127010 105" Blade Model G1127