Summary of the content on the page No. 1
Register your product and get support at
www.philips.com/welcome
52PFL7704D
47PFL7704D
42PFL7704D
32PFL7704D
52PFL6704D
47PFL6704D
42PFL6704D
32PFL6704D
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Puerto Rico, or the U.S. Virgin Islands, contact Philips
EN User manual
Customer Care Center at 1-866-771-4018
• To obtain assistance in Canada, contact Philips Customer Care Center at:
• 1-800-661-6162 (French speaking)
FR Ma
Summary of the content on the page No. 2
Summary of the content on the page No. 3
9 Connect devices 28 Contents Connection o verview 28 Select y our connection quality 29 Label your connections 29 1 Notice 4 Connect y our devices 30 2 Impor tant 5 10 T roubleshooting 33 Product inf ormation 5 Screen care 5 11 Notes for the use of USB devices 34 En vironmental care 5 12 Product information 35 3 Y our TV 6 Side controls and indicator s 6 13 W arranty 36
Summary of the content on the page No. 4
Return your Product Registration Card or register online at www.philips.com/welcome today to get the very most from your purchase. Registering your model with PHILIPS makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: *Proof of *Product Safety *Additional Benefits Purchase Notification Returning the enclosed card guarantees By registering your p
Summary of the content on the page No. 5
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6.
Summary of the content on the page No. 6
Cables 1 Notice Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations. 2009 © Koninklijke Philips Electronics N.V. All rights reserved. Canadian notice Specifi cations are subject to change without notice. Trademarks are This Class B digital apparatus meets all requirements of the Canadian the property of Koninklijke Philips Electronics N.V. or their respective Interference-C
Summary of the content on the page No. 7
Environmental care 2 Impor tant Registering your model with Philips makes you eligible for all of the valuable benefi ts listed below, so don’t miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: • Proof of Purchase Returning the enclosed card guarantees that your date of purchase is on fi le, so no additional paperwork is required from you to obtain warranty service. The packaging of this p
Summary of the content on the page No. 8
Remote control 3 Y our TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at a www.philips.com/welcome. { b ACTIVE SLEEP CONTROL FAV TV Side controls and indicators z c DEMO d y e SOURCE VOLUME 5 AUTO OPTIONS MODE x f 4 MENU g BACK w OK CHANNEL 3 h EXIT INFO MENU v i u 2 POWER t j 1 s k l a Standby indicator / remote control sensor (location may vary) MUTE b POWER: Sw itches the TV on
Summary of the content on the page No. 9
c TV { ACTIVE CONTROL Sw itches back to the antenna source from EasyLink mode. T he TV continuously measures and corrects incoming signals to provide the best picture quality. d Color buttons Selects tasks or options. e SOURCE Selects connected devices. f OPTIONS Activates the quick access menu ( see ‘Use the quick access menu’ on page 13 ) . g OK Activates a selection or accesses the menu. h ( Navigation buttons) Navigates th
Summary of the content on the page No. 10
Insert the remote control batteries 4 Get started This section supplements inf ormation in the Quick Start. For information about how to mount and install your TV, refer to the Quick Start. P osition the TV Warning 1 Slide the battery cover off the back of the remote control. • D o not insert the power plug into the wall socket before all the connections are made. 2 Insert the 2 supplied batteries (AAA). Be sure the + and - ends • L arge screen TVs are heavy. Tw
Summary of the content on the page No. 11
Contact y our local DBS provider for more information about the 3 Connect the power cord plug to the power outlet. Ensure that connections and the TV channels. the cord is tightly secured at both ends. Connect to a set-top bo x A cable box or satellite set-top box can be connected to the TV through the following connections: • ANT • A/V (Composite Video and Audio) • S- Video • Y PbPr (Component Video Input) • HDMI For information about how to connect a set-top
Summary of the content on the page No. 12
Switch on and set up the TV The TV turns on automatically after the power cord is inserted into the power connector. The following screen appears: Thank you for your purchase of this PHILIPS TV. Please proceed with the following steps to set up your TV. For the BESTpossible picture performance, contact your local Cable / Satellite signal provider for High Definition signal options available in your area. Next Press the GREEN button on your remote control to proceed. Follo w t
Summary of the content on the page No. 13
5 Use your TV MUTE CH VOL CH FORMAT This section helps y ou perform basic TV operations. 123 Switch y our TV on/off or to standby 456 123 789 456 PREV. CH 0 789 POWER PREV. CH 0 • P ress CHANNEL +/ - o n the side of the TV. • F or digital channels, press a number (1 to 999) followed by a dot “.” and then the corresponding sub channel number (1 to 999). Ex. 108.30. • P ress CH +/- or enter a number on the remote control. • P ress PREV CH t o return to
Summary of the content on the page No. 14
Watch channels from a set-top box T o watch channels from a set-top box 1 Switch on the set-top box. » The picture from y our set-top box might appear automatically on your screen. 2 Use the remote control of your set-top box to select channels. I f the picture does not appear DEMO SOURCE SOURCE AUTO OPTIONS MODE 1 Press SO URCE repeatedly to select the set-top box and wait a few seconds for the picture to appear. 2 Use the remote control of your se
Summary of the content on the page No. 15
3 Press a nd to select the [Picture] menu. 6 Use more of your TV TV menu Use the quick access men u TV Settings Picture Settings assistant Contrast The quick access men u gives direct access to some often-needed menu items. Picture Brightness Sound Color Note Tint • W hen digital channels are installed and broadcast, the relevant digital options are Sharpness displayed in the quick access menu. Color temperature 1 Press OP TIONS on the remote control. Dynamic co
Summary of the content on the page No. 16
Summar y of picture settings Summar y of picture formats The following picture settings can be confi gured. Depending on the T he following picture formats can be selected. format of the picture source, some picture settings are not available. D epending on the format of the picture source, some picture formats • [C ontrast] : Adjusts the intensity of bright areas, keeping dark are not available. areas unchanged. • [Brightness] : Adjusts the intensity and details of dark a
Summary of the content on the page No. 17
2 Press or to highlight a sound setting and press to select Cr eate and use lists of favorite channels the setting. Y ou can create lists of your preferred TV channels so that you can fi nd 3 Press o r to adjust the setting, and press OK to confi rm the those channels easily. change. 4 Press MEN U/EXIT to exit. Select a list of fa vorite channels Summary of sound settings 1 Press the FAV key on the remote control. The following sound setting
Summary of the content on the page No. 18
Set the sleeptimer 2 Select [A utomatic] and press t o confi rm your choice. Sleeptimer switches the TV to standby after a pre-defi ned period of time. You can always switch off your TV earlier or reset the sleeptimer TV menu I Installation during the countdown. Clock Auto clock mode Auto clock mode Manual Press SLEEP repeatedly to select a value from 0 to 180 minutes. For example, if you select 90, the TV switches to standby in 90 minutes. Automatic Auto clock c
Summary of the content on the page No. 19
• A box with / indicates that some content ratings are 6 Press t o confi rm your choice. deselected. For example, for rating TV-14, you can deselect 7 Press t o select [Time] a nd press t o set the time. one or more of the following content ratings: [(D) Dialog] , Use the format HH:MM, and select [AM] / [PM] for morning or [(L) Language], [(S) Sex] , or [(V) Violence]. afternoon. 8 Press OK to confi rm the time. TV menu Features Child Lock 9 Press MEN U/
Summary of the content on the page No. 20
Use the mo vie ratings lock 2 Press o r to select [On], a nd press t o confi rm your choice. If you select Off , you choose not to download the region rating You can control viewing of movies based on their Motion Picture table and you cannot use the region rating lock. Association of America (MPAA) rating. 3 Press t o return to the TV menu and select [Features] > [Child 1 Press MEN U/EXIT o n the remote control and select [Features] lock] > [Region rating
