Summary of the content on the page No. 1
Summary of the content on the page No. 2
Things You Should Know Thank you for choosing Panasonic! Date of Purchase You have purchased one of the most sophisticated and reliable products on the Dealer Purchased From market today. Used properly, it will bring Dealer Address you years of enjoyment. Please take time to fill in the information to the right. Dealer Phone No. The serial number is on the tag located on Model No. the rear side of your Camcorder. Be sure to retain this manual as your convenient Serial No. Camcorder information s
Summary of the content on the page No. 3
Summary of the content on the page No. 4
Summary of the content on the page No. 5
Getting Started Important Safeguards b.If any liquid has been spilled into, or 15. Power Lines – An outside antenna system should not be located in the vicinity of overhead objects have fallen onto, the video unit. power lines or other electric light or power c.If the video unit has been exposed to rain circuits, or where it can fall into such power or water. lines or circuits. When installing an outside d.If the video unit does not operate normally antenna system, extreme care should be taken b
Summary of the content on the page No. 6
Getting Started Basic Operation Special Features For Your Information Table of Contents Things You Should Know .............................................................................2~3 Important Safeguards ...................................................................................4~5 Precautions........................................................................................................5 Quick Operation Guide .............................................................
Summary of the content on the page No. 7
Summary of the content on the page No. 8
Supplying Power Charging the Battery Pack 1 Plug in AC Adaptor. Charge Battery Pack fully before use. POWER Lamp lights. 3 2 Insert Battery. 2 A Align left side of Battery with left edge of AC Adaptor. B Press Battery down and slide in direction of arrow. POWER The CHARGE Lamp flashes, then stays lit 1 Lamp when charging is complete. 3 Remove Battery. Slide Battery to the left and lift off. CHARGE Note: • Charging takes about 1 hour. Lamp • While the DC Power Cable (supplied) is connected to the
Summary of the content on the page No. 9
Summary of the content on the page No. 10
Cassette Information Cassette Insertion/Removal 1 Turn Tape Wheel in direction of arrow until there is no slack. 1 2 Attach Battery (page 8). 2 3 3 Slide TAPE EJECT to open door. 4 Insert cassette as shown. 5 Press here to close door. 4 • To remove the cassette, slide the TAPE 5 EJECT switch. Record/Playback Time Use tapes with the mark in this unit. Cassette type Tape Speed Selector Position TC-20 TC-30 TC-40 SP 20 minutes 30 minutes 40 minutes (Standard Play) SLP 1 hour 1 hour 2 hours (Super
Summary of the content on the page No. 11
Summary of the content on the page No. 12
Summary of the content on the page No. 13
Summary of the content on the page No. 14
Setting the Clock Setting the Time Zone 3a Press UP or DOWN to The Camcorder is preset to Eastern time. select local time zone. [ Time Zone chart ] Press DISPLAY to confirm entry. • When traveling, repeat this operation and select one of the 8 listed time zones to set the clock to local time. Note : • Clock may lose or gain up to 2 minutes per month. • When traveling outside the listed time zones, set clock to local time manually. • To adjust or set clock, see “Setting Date and Time” bottom of p
Summary of the content on the page No. 15
Getting Started Built-in Auto Light Before you begin... Using the Light • Connect Camcorder to power source. For recording in dim lighting. • Set POWER to CAMERA. 1 Press MENU for MENU mode. Press UP or DOWN to select LIGHT MODE . 2 Press DISPLAY to set OFF/ON or LIGHT OFF/ON/AUTO. Press MENU to exit. 1, 2, 3 3 Press LIGHT repeatedly for Light ON, CAUTION: OFF, or AUTO. Light becomes hot. • In AUTO, light turns itself on/off Never cover Light while on. according to lighting conditions. Note: EV
Summary of the content on the page No. 16
Summary of the content on the page No. 17
Summary of the content on the page No. 18
Summary of the content on the page No. 19
Summary of the content on the page No. 20
