Summary of the content on the page No. 1
6410KF
Ceramic hob
Installation and Operating Instructions
Summary of the content on the page No. 2
Dear Customer, Please read these user instructions carefully and keep them to refer to later. Please pass the user instructions on to any future owner of the appli- ance. The following symbols are used in the text: 1 Safety instructions Warning! Notes that concern your personal safety. Important! Notes that show how to avoid damage to the appliance. 3 Useful tips and hints 2 Environmental information 2
Summary of the content on the page No. 3
Contents Operating Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Description of the Appliance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Cooking surface layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Control panel layout . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
Operating Instructions 1 Safety 3 Please comply with these instructions. If you do not, any damage re- sulting is not covered by the warranty. 5 This appliance conforms with the following EU Directives: – 73/23/EEC dated 19.02.1973 Low Voltage Directive – 89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending Directive 92/31/EEC – 93/68/EEC dated 22.07.1993 CE Marking Directive Correct use This appliance should be used only for normal domestic cooking and frying of food. The appli
Summary of the content on the page No. 5
Safety during use Remove stickers and film from the glass ceramic. There is the risk of burns from the appliance if used carelessly. Cables from electrical appliances must not touch the hot surface of the appliance or hot cookware. Overheated fat and oil can ignite quickly. When cooking with fat or oil (e.g. frying chips) do not leave the appliance unattended. Switch the cooking zones off after each use. Safety when cleaning For cleaning, the appliance must be switched off and cool
Summary of the content on the page No. 6
Description of the Appliance Cooking surface layout Single ring cooking zone Single ring cooking zone 1200W 1800W Double ring cooking zone Control panel Single ring cooking zone 750/2200W 1200W Control panel layout Cooking zones and heat setting selection Display Pilot light Dual zone Second ring On/Off On/Off 6
Summary of the content on the page No. 7
Touch Control sensor fields The appliance is operated using the Touch Control sensor fields. Func- tions are controlled by touching sensor fields and confirmed by dis- plays. Touch the sensor fields from above, without covering other sensor fields. Sensor field Function On / Off Switches appliance on and off Increase settings Select cooking zone Increases heat setting Reduce settings Reduces heat setting Dual zone touch control Switches outside zone on and off Displays Display Description ¾
Summary of the content on the page No. 8
Operating the appliance Switching the appliance on and off Control panel Display Switch on Touch for 2 seconds. ¾ / Decimal point flashes Switch off Touch for 1 second h / none Selecting the cooking zone Control panel Display Select Touch ¾ Decimal point illumi- nates 3 The decimal point is displayed by the selected cooking zone. Then a heat setting must be set for this cooking zone within 6 seconds, other- wise it must be re-selected. Selecting the heat setting 3 After selecting the co
Summary of the content on the page No. 9
Switching the double ring cooking zone on and off With the dual cooking zone the heating surface can be matched to the size of the cookware. 3 When a heat setting is selected, both zones are switched on and the pi- lot light illuminates. Control panel Pilot light Switch off Touch for 1 second goes out Switch on Touch for 1 second illuminates Using the child safety device The child safety device prevents unintentional use of the appliance. Setting the child safety device Step Control panel
Summary of the content on the page No. 10
Overriding the child safety lock The child safety device can be released in this way for a single cooking session; it remains activated afterwards. Step Control panel Display 1. Switch on the appliance l / h (if hot) Touch of the front right 4 x ¾ Decimal points flash 2. cooking zone and at the same time Until the appliance is next switched off, it can used as normal. Safety cut-out Cooking surface If after switching on the appliance a heat setting is not set for a cooking zone within
Summary of the content on the page No. 11
Tips on cooking and frying 3 Information about acrylamides According to the latest scientific research, intensive browning of food, especially in products containing stark, may present a health risk due to acrylamide. Therefore we recommend cooking at low temperatures and not browning foods too much. Cookware You can recognise good cookware from the bottoms of the pans. The bottom should be as thick and flat as possible. Cookware made of enamelled steel or with aluminium or copper bot-
Summary of the content on the page No. 12
Examples of cooking applications The information given in the following table is for guidance only. Heat Cooking set- suitable for Cook time Tips/Hints process ting Residual heat, setting, Off 0 position Keeping Keeping cooked foods 1 food as required Cover warm warm Hollandaise sauce, Melting melting butter, chocolate, 5-25 mins. Stir occasionally gelatine 1-2 Solidify- Fluffy omelettes, baked 10-40 mins. Cook with lid on ing eggs Simmering rice and milk- Add at least twice as Simmer- ba
Summary of the content on the page No. 13
Cleaning and care 1 Take care! Risk of burns from residual heat. Let the appliance cool down. 1 Important Sharp objects and abrasive cleaning materials will damage the appliance. Clean with water and washing up liquid. 1 Important Residues from cleaning agents will damage the appliance. Remove residues with water and washing up liquid. Cleaning the appliance after each use 1.Wipe the appliance with a damp cloth and a little washing up liquid. 2.Rub the appliance dry using a clean cloth. Remov
Summary of the content on the page No. 14
What to do if… Problem Possible cause Remedy The cooking zones are not No cooking zone selected Select cooking zone within functioning. 10 seconds of switching on (Decimal point lights up) The cooking zones cannot More than 10 seconds has Switch on the appliance be selected / Appliance passed since the appliance again. does not react to the con- was switched on Select cooking zone within trol panel input 10 seconds of switching on The child safety device is Deactivate the child safety activ
Summary of the content on the page No. 15
1 Warning! Repairs to the appliance are only to be carried out by quali- fied service engineers. Considerable danger to the user may result from improper repairs. 3 If the appliance has been wrongly operated, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. Disposal 2 Packaging material The packaging materials are environmentally friendly and can be recy- cled. The plastic components are identified by markings, e.g.
Summary of the content on the page No. 16
Installation Instructions Safety instructions The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accord- ance with the regulations, etc.) Installation may only be carried out by a qualified electrician. The minimum distances to other appliances are to be observed. Drawers may only be installed with a protective board directly un- der the appliance. The cut surfaces of the work top are to be protected against
Summary of the content on the page No. 17
Appliance dimensions Width 590 mm Depth 520mm Height 47mm Installation proud of the work surface Clean the worktop in the area of the cut-out section. Stick the one-sided self-adhesive sealing tape supplied all the way round the lower edge of the cooking surface along the outer edge of the glass ceramic panel. Do not stretch it. The cut ends should lie in the middle of one side. When you have cut it to length (add a few mm), press the two ends flush up against one another. 17
Summary of the content on the page No. 18
Assembly 18
Summary of the content on the page No. 19
19
Summary of the content on the page No. 20
20
