Dacor ER30DSRSCH user manual

Summary of the content on the page No. 1

RANGE MODEL: ER30DSRSCH
3-Inch Side Panel Kit, INSTALLATION
P/N ARSP3 INSTRUCTIONS
Parts included with this kit:
2 Side Panels
Hardware Kit
2 X Torx Screw (83709)
5 X Sheet Metal Screw
(83023)
Instructions:
Installing the 3-Inch Side Panel Kit
(Model ER30DSRSCH)
For self-rimming installations with non-standard countertop
depths, installation of the optional side panel kit may be
necessary to cover the sides of the range that protrude from
the cabinet.
To install the side panel kit:
STEP 1

Summary of the content on the page No. 2

3-Inch Side Panel Kit STEP 2: Close the door. Remove and retain the two screws from the back of the kick panel as shown below. Pull the kick panel free from the front of the unit. Remove and retain screw, both sides Kick Panel STEP 3: Remove the left end cap retaining screw from under the rim of the control panel and re- move the end cap. End Cap Page 

Summary of the content on the page No. 3

3-Inch Side Panel Kit STEP 4: Hold the left side panel in position on the side of the range. Locate the center mounting hole. Remove and retain the screw attached to the chassis beneath it. Hex screw STEP 5: Insert the tabs on the trim piece into the slots on the Side Panel range. Torx screw Hex screw Torx screw Hex screw Front Panel STEP 6: Use the hex head screw (80  )  removed from the side, a Torx head screw removed from the kick panel and the hex screws from the kit to attach

Summary of the content on the page No. 4

Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com