Summary of the content on the page No. 1
Installation Instructions
®
Epicure 36-Inch Gas Range
For use with models ER36G and ER36GI
THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION
OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES.
Part No. 106554 Rev. B
Summary of the content on the page No. 2
Table of Contents Important Safety Instructions .....................................................1 Self-Rimming Trim Installation ....................................................7 Important Information About Safety Instructions.........................2 Adjust the Range Height .............................................................8 General Safety Precautions ........................................................2 Install the Anti-Tip Bracket ..................................
Summary of the content on the page No. 3
Important Safety Instructions Important Information About Safety WARNING WARNING – NEVER use this appliance as a space Instructions heater to heat or warm the room. Doing so may result The Important Safety Instructions and warnings in this in carbon monoxide poisoning and overheating of the Manual are not meant to cover all possible problems and appliance. conditions that can occur. Use common sense and caution when installing, maintaining or operating this appliance. WARNING Always con
Summary of the content on the page No. 4
Important Safety Instructions General Safety Precautions To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: WARNING • Read the accompanying use and care manual completely before operating this appliance. • Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • If you receive a damaged product, immediately contact your dealer o
Summary of the content on the page No. 5
Important Safety Instructions WARNING • Do not operate the cooktop without the knobs and trim rings in place. • Non-stick coatings, when heated, can be harmful to birds. Remove birds to a separate, well-ventilated room during cooking. IMPORTANT - This appliance is equipped with a three-prong grounding plug for your protection against possible electric shock hazards. Plug it only into a dedicated, grounded three- prong electrical outlet. It is the responsibility of the customer to make sure
Summary of the content on the page No. 6
Installation Specifications Gas Supply Requirements WARNING • Be certain that the range being installed is correct for • Observe all governing codes and ordinances during the gas service being provided (natural gas or LP gas). planning and installation. Contact your local building • Check your local building codes for the proper method department for further information. of installation. In the absence of local codes, this • To prevent an electric shock hazard, the power supply appli
Summary of the content on the page No. 7
Installation Specifications • Any openings in the wall behind the appliance or in the Cabinet Layout floor underneath it must be sealed. • If cabinet storage space is to be provided directly WARNING above the range, the risk of personal injury may be Failure to meet or exceed the maximum and minimum reduced by installing a ventilating hood that projects dimensions/clearances stated may result in a fire hazard. horizontally a minimum of 5 inches beyond the face of • Carefully check the
Summary of the content on the page No. 8
Installation Specifications Gas and Electrical Locations • The installation must allow for the following: ◊ Access to the gas shut-off valve when the unit is installed. ◊ Access to the electrical outlet, when the range is in place. ◊ The gas supply piping, gas shut-off valve and the electrical junction box or receptacle must be located so they do not interfere with the range when it is C L installed. ◊ The electrical outlet and gas shut off valve must be located so that the range can
Summary of the content on the page No. 9
Installation Instructions 5) Slide the provided left and right trim pieces onto the Backguard Kit Installation range. The overhang on each piece goes toward the See page 3 for available model numbers and compatibility. back. If installing a backguard other than the standard size, 6) Fasten the new trim pieces in place using the provided install it before pushing the range into place. Install the kit #8 x 1/4 Torx screws (3 each side). IMPORTANT: To according to the accompanying installation
Summary of the content on the page No. 10
Installation Instructions 11) Attach the self-rimming side panels included with the Self-Rimming Trim Installation (cont.) unit by snapping the ball studs on the front into the 8) Re-attach the backguard using the supplied #8 x 1/4” back of the control panel and kick panel. The finished Torx screws. If there is a countertop overhang to the side of each side panel faces out. rear of the range of 3/4” or greater, attach the rear 12) Fasten the top of each side panel to the control panel tri
Summary of the content on the page No. 11
Installation Instructions Install the Anti-Tip Bracket Door Removal 1) Locate the anti-tip foot on the back of the range and Remove the door to make the range easier to move during turn it until the bottom of it is 1/16” (2 mm) off the floor. the installation process. WARNING • Do not attempt to disengage the hinge catches with the door removed from the oven. The hinge springs could release causing personal injury. • The door is heavy. Door removal requires two people. Do not lift or carr
Summary of the content on the page No. 12
Installation Instructions Gas Connection IMPORTANT: The installed gas pressure regulator is pre- WARNING set at the factory for the type of gas intended for use with • Make sure the gas is turned off at the gas supply the appliance. Verify that the appliance is compatible with valve before connecting the gas line. the type of gas available by checking the product data label attached to the appliance. Ranges intended for use with • Verify that the gas supply meets specifications before L
Summary of the content on the page No. 13
Installation Instructions 3) Carefully slide the range into position taking the slack Moving the Range to Final Location out of the power cord as you push the unit into place. 1) Peel the protective plastic coating off of the range, Be careful not to kink the power cord or gas line as you including the range door. push the unit back. The anti-tip foot should engage the anti-tip bracket as you slide it back. 2) Uncoil the power cord and route it to the electrical outlet so that it does not
Summary of the content on the page No. 14
Installation Instructions Cooktop Assembly WARNING Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed. 1) Remove the burner rings, burner caps and grates from their shipping cartons. 2) Install the burners as shown. Gently twist each piece back and forth after installation to make sure it is properly seated. A small gap below the bottom of the burner ring is normal. 3) Gently set the grates on top of the spill tray. Put the legs of ea
Summary of the content on the page No. 15
Installation Instructions If the range does not operate properly, follow these Verifying Proper Operation troubleshooting steps: 1) Verify that the circuit breaker for the range electrical WARNING outlet is on and not tripped. Make sure the power cord Before operating the range, read the accompanying use is connected. and care manual completely. 2) Make sure the gas supply valve is in the on position 1) Before beginning the test procedure, and that the main gas valve to the building is op
Summary of the content on the page No. 16
W 6 5 4 3 2 1 LED LED LED LED LED LED INDICATOR INDICATOR INDICATOR INDICATOR INDICATOR INDICATOR RF CF CR LF LR RR B B B B B B B 120 VAC from Burner Switches 3-PRONG PLUG GR B W OVEN ASSEMBLY (REF.) SUPPLY B W B W B W B W B W B W CORD Single Point Single Point Single Point Single Point Single Point Single Point W Spark Module Spark Module Spark Module Spark Module Spark Module Spark Module GR B W W IGNITOR, IGNITOR, IGNITOR, IGNITOR, IGNITOR, IGNITOR, OVEN TEMPERATURE SENSOR LR BURNER RR BURN
Summary of the content on the page No. 17
Notes 15
Summary of the content on the page No. 18
Notes 16
Summary of the content on the page No. 19
Summary of the content on the page No. 20
Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com
