Sanyo LNS-M01 user manual

Summary of the content on the page No. 1

LCD PROJECTOR LENS
MODEL NO. LNS-M01
LNS-S01
LENS REPLACEMENT AND
INSTALLATION PROCEDURE
NOTES ON LENS INSTALLATION
Lens installation should be performed by the qualified service personnel.
It should be followed by this procedure precisely.
Before attempt to install the lens, confirm the model number (both the LCD
projector and the lens) and use the proper lens.
If you have any questions, contact to the dealers.
PARTS LIST
Following parts are contained in the packing.
· LENS
1 p

Summary of the content on the page No. 2

LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps 1 to 4 for lens replacement and installation. UPPER LENS COVER C REMOVE THE LENS COVER. (See figure-1) 1 Remove screws A (2 screws). 1. 2. Pull down the lower lens cover while pushing the part D, then remove it. B 3. Remove screws B (2 screws). 4.Remove screws C (2 screws) and remove upper lens cover. D 2 Fig-1 D ● IN CASE OF MODEL WITHOUT LENS A LOWER LENS COVER REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-2) Remove 2 screws

Summary of the content on the page No. 3

INSTALL THE LENS. (See figure-4,5.) 3 LENS MOUNTING BRACKET 1. Mount the lens at the lens mounting bracket with screws (4 screws) included with the lens. Use the driver included with the lens to fasten the screws . (After using, save it for ATTACHED DRIVER latter use.) 2. Connect the lens motor lead to the connector “K16B” of the cir- cuit board. 3. Fasten the lens motor lead at the A, B points with wire holder. Fig-4 LIGHT-BLOCK SHEET ❋ Figure shown inside of the cabinet. LENS MOTOR (D) (D) (D)