Summary of the content on the page No. 1
DATA PROJECTOR
U5-232/U5-132
U5-112/U5-111
User’s Manual
( )
U5-111
( )
U5-112
( )
U5-232/U5-132
IMPORTANT
* DLP™ (Digital Light Processing) and DMD (Digital Micromirror Device) are registered trademarks of Texas Instru-
ments Incorporated (U.S.A.).
* DMD is an ultra-precise part developed by Texas Instruments (U.S.A.) which takes the place of liquid crystal (in the
projector).
* VGA and XGA are trademarks or registered trademarks of International Business Machines Corporation (U.S.A.).
* S-VGA
Summary of the content on the page No. 2
IMPORTANT SAFETY INFORMATION Precautions Please read this manual carefully before using your PLUS Data Projector and keep the manual handy for future reference. This User’s Manual applies to the U5-232, U5-132, U5-112 and U5-111 Data Projectors. The resolution differs from model to model, and not all models have the optical zoom function, the high brightness black/white mode or the PC mouse function. This User’s Manual describes the U5-232 (the full-function model). Also note that the included r
Summary of the content on the page No. 3
IMPORTANT SAFETY INFORMATION WARNING This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. RF Interference WARNING The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by PLUS Vision in this manual. Failure to comply with this government regulation could void your right to operate this equipment. This equipment has been tested
Summary of the content on the page No. 4
IMPORTANT SAFETY INFORMATION Important Safeguards These safety instructions are to ensure the long life of the unit and to prevent fire and shock. Please read them carefully and heed all warnings. Installation • For best results, use the unit in a darkened room. • Place the unit on a flat, level surface in a dry area away from dust and moisture. • Do not place the unit in direct sunlight, near heaters or heat radiating appliances. • Exposure to direct sunlight, smoke or steam can harm internal c
Summary of the content on the page No. 5
Major Features Lightweight high-intensity projector The synergy of the DLP™ (Digital Light Processing) display system and our own optical design serve to improve the optical utilization efficiency. The three primary colors (RGB) required in color expression are reproduced with one DMD (Digital Micromirror Device of high precision). These factors have enabled a design that offers both high intensity and small size/ lightweight features. Sharp, clear picture The DLP™ display system affords RGB
Summary of the content on the page No. 6
Table of Contents IMPORTANT SAFETY INFORMATION ................................................................................... E-2 Major Features ....................................................................................................................... E-4 Table of Contents ................................................................................................................... E-5 Checking the Supplied Accessories ......................................................
Summary of the content on the page No. 7
Table of Contents Color ...................................................................................................................................... E-49 Quick Color Adj. ........................................................................................................ E-49 Gamma ..................................................................................................................... E-49 Color Temp. ....................................................................
Summary of the content on the page No. 8
Checking the Supplied Accessories Remove the main unit and the accessories from the box and check that the following items are included. Wireless remote control unit with laser pointer [1] / S-Video cable (Mini DIN 4-pin plug, 2 m / 6.6 feet) [1] Size AAA batteries [2] This cable is used in the connection of video equipment that Applicable Projector: U5-232/U5-132 has an S-video connector. Connections are described on Page This controls the projector. (See Page E-11.) E-20. No. 777704000 * The
Summary of the content on the page No. 9
Checking the Supplied Accessories USB cable (type A, 2 m / 6.6 feet) [1] Applicable Projector: U5-232/U5-132 Used to perform mouse operations on a computer using the projector’s remote control unit. Connections are described on Page E-35. No. 777707000 * The wireless remote control is sold separately for the U5- 112 and U5-111. VR-100 remote mouse set (sold separately) (Ordering code: 28-052) Storage case (for projector and accessories) [1] HOW TO PUT THE PROJECTOR INTO THE STORAGE CASE This ca
Summary of the content on the page No. 10
Names of the Main Unit Parts Applicable Projector: U5-232/U5-132 Zoom ring [E-26] Focus ring [E-27] Exhaust vents Ventilation slots Remote control Adjuster button [E-27] sensor [E-13] (Also on opposite side) Lens Applicable Projector: U5-112 Zoom ring [E-26] Lens cap Remove before use. Attach the lens cap after use to protect the lens. Exhaust vents Focus ring [E-27] Lens Lens cap Ventilation slots Applicable Projector: U5-111 Focus ring [E-27] Exhaust vents Lamp cover [E-65] Lens Lens cap Adjus
Summary of the content on the page No. 11
STATUS STANDBY STANDBY AUTO SOURCE RGB S VIDEO VIDEO AUDIO MOUSE PC CONTROL Names of the Main Unit Parts STATUS STATUS indicator [E-23, 61] STANDBY indicator [E-23, 61] STANDBY STANDBY button [E-23] STANDBY AUTO button [E-28] AUTO SOURCE SOURCE button [E-28] Remote control sensor [E-13] AC IN connector [E-23] Speaker Built-in security slot Ventilation slots (See description below.) Applicable Projector: U5-232/U5-132 MOUSE connector [E-35] AUDIO connector [E-22] RGB S VIDEO VIDEO PC CONTROL AUDI
Summary of the content on the page No. 12
Names of the Remote Control Parts/Preparing the Remote Control There are two types of remote control units included with the U5 series of projectors. Both types are described below. Refer to the description (and diagram) for the remote control unit included with your projector. Names of Parts/Preparing the Remote Control Unit Included with the U5-232 and U5-132 Applicable Projector: U5-232/U5-132 Infrared transmitter [E-13] Laser transmitter [E-34] L-CLICK button [E-35] LASER button [E-34] STAN
Summary of the content on the page No. 13
CR2025 Names of the Remote Control Parts/Preparing the Remote Control Names of Parts/Preparing the Remote Control Unit Included with the U5-112 and U5-111 Applicable Projector: U5-112/U5-111 Names of the Remote Control Parts Infrared transmitter [E-13] STANDBY button [E-23, 25] This button is used to switch ON the power aand set the unit to the Buttons used for menu operations STANDBY mode. [E-40] The , , and buttons are the select (, , and ) buttons. Buttons used for input selection STAN
Summary of the content on the page No. 14
Names of the Remote Control Parts/Preparing the Remote Control Remote Control Range Point the infrared transmitter of the remote control toward the remote control sensor located at the front or rear of the main unit and operate. Reception of the remote control signal should generally be possible within the range illustrated below. Applicable Projector: U5-232/U5-132 Side View Top View 20° Remote control in- frared transmitter Remote control in- Remote con- Remote con- frared transmitter trol sen
Summary of the content on the page No. 15
The Procedure Up to Projecting to the Screen Perform setup adjustments in the following order. 1 Position the projector Determine the locations to set up the screen and the projector. See “Placement Guide” on Page E-15. 2 Connect the video equipment and personal computer Connect your equipment to the projector. When making connections with the personal computer’s RGB connector, see “Connections with Personal Computer” on Page E-18. When making connections with the video equipment’s video connect
Summary of the content on the page No. 16
300" h1 250" h2 200" 180" 150" 120" 100" 80" 60" 38.4" Placement Guide • Use this information as a guide to find out about the screen size when the projector is placed at a certain location, or to find out the approximate size of a screen that will be required. • Refer to the projection distance table for your projector model. • When suspending the projector from the ceiling, change the projection method. See “Vertical Flip” on E-53. U5-232/U5-132 Screen Size and Projection Distance • The projec
Summary of the content on the page No. 17
300" h1 250" h2 200" 180" 150" 120" 100" 80" 60" 40" 27.6" Placement Guide U5-112 Screen Size and Projection Distance • The projection distance over which focussing is adjustable is 1.20 m (3.94 feet) to 13.36 m (43.83 feet). The projector should be placed within this range. Screen Size Designation (Inches) Height from center of lens to top edge of the projection Height from center of lens to bottom edge of the projection Unit: m (feet) Width Lens surface of the main unit Screen size (Diagonal)
Summary of the content on the page No. 18
300" h1 250" h2 200" 180" 150" 120" 100" 80" 60" 40" 34.4" Placement Guide U5-111 Screen Size and Projection Distance • The projection distance over which focussing is adjustable is 1.20 m (3.94 feet) to 10.59 m (34.74 feet). The projector should be placed within this range. Screen Size Designation (Inches) Height from center of lens to top edge of the projection Height from center of lens to bottom edge of the projection Unit: m (feet) Width Lens surface of the main unit Screen size (Diagonal)
Summary of the content on the page No. 19
Connecting Personal Computers and Video Equipment Connecting this unit with a personal computer permits presentation data to be projected as a large screen display at conferences, lectures, and on other occasions. Furthermore, connecting this unit to a DVD player or other video equip- ment source in combination with an audio/video amplifier and speaker system will allow you to enjoy convincing home theater. Connections with Personal Computer Please check the following before making connections w
Summary of the content on the page No. 20
Connecting Personal Computers and Video Equipment To Output the External Output Signal of a Notebook Computer When projection will be with a notebook computer connected, knowledge will be required for the cable connection and notebook computer startup procedure as well as the operation that follows notebook startup. Please consult the instruction manual of your notebook computer or the on-line help while performing the following procedure. Check whether a signal is being sent from the notebook c
