Summary of the content on the page No. 1
DLP PROJECTOR
USER’S GUIDE
Thank you for purchasing the DLP Projector.
Please read this user’s guide to ensure correct use of the device. Save this user’s
guide for future reference.
OUTLINE
This DLP Projector can display various computer signals and NTSC/PAL/SECAM video
signals.
FEATURES
1. High Brightness
2. High Resolution
3. Compact Size, Feather Weight for Portability
4. Durable Magnesium Alloy Body
5. RGB input Terminal
6. One Touch Auto-Adjustment Function
7. Easy Keystone Adjustment
Summary of the content on the page No. 2
Copyright Copyright © 2002. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of the company. Disclaimer The company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifi
Summary of the content on the page No. 3
Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 FCC Statement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Shipping Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Optional Accessories . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
DLP Personal Projector iv
Summary of the content on the page No. 5
INTRODUCTION Caution TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER –SER- VICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. PLEASE READ THIS USER’S GUIDE BEFORE YOU OPER- ATE YOUR PROJECTOR. SAVE THIS USER’S GUIDE FOR FUTURE REF- ERENCE . Safety Instructions 1. Read this user’s guide before you operate your projector and save it for future reference. 2. The lamp becomes extremely hot during operation. Allow the projector to cool for approximately 45 minutes prior to r
Summary of the content on the page No. 6
• Do not touch the ventilation grill when the projector is under operation. Save this user’s guide: The information contained in this manual will assist you in operating and maintaining your personal projector. FCC Statement FCC STATEMENT - CLASS A: This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with the limits
Summary of the content on the page No. 7
Quick Start Guide Shipping Contents The Projector is shipped with the cables required for connection to standard PC or laptop computers. Carefully unpack and verify that you have all the items shown below. If any of these items are missing, please contact personnel at the place of purchase. Projector Quick Start Guide Remote Control User’s Guide 3-2 Converter HDTV Cable Batteries Deluxe Soft Carry Case 110V 220V 240V Audio Cable India Power (S.A) Power Cord VGA Cable USB Cable S-Video Cable
Summary of the content on the page No. 8
Projector Description Projector 7 6 8 1 9 12 5 13 2 3 4 1011 14 15 External control panel Audio/ Video connector 11 1 (see next page) Projection lens Computer Audio IN 12 2 Front adjuster USB mouse connector 13 3 IR remote sensor S-Video jack 4 14 Ventilation grill RS-232C control port 5 15 Speaker Rear adjuster feet 16 6 Projection lens adjuster Kensington lock 17 7 AC power cord inlet Computer signal input 8 18 Computer signal output Main power switch 19 9 YPBPR connector Lamp door 10 20 2
Summary of the content on the page No. 9
External Control Panel 4 3 5 6 2 7 1 8 9 Source Power 1 7 Selects signal sources from Presses the Power key to turn among PC, YPBPR, Video and S- the projector on or off. Video. Auto 2 Lamp Indicator 8 Automatically determines the The Lamp Indicator will light up best picture settings for current when the lamp needs service, received signals. cooling or replacement. See Left/ Keystone - Exit 3 4 “Lamp Information” on page 20 R
Summary of the content on the page No. 10
Adjuster The projector is equipped with 2 quick-release adjuster feet. Push the buttons to adjust its tilt angle. 1. Lift the projector up and press the adjuster button to release the adjuster. 2. The adjuster will drop into position and be locked. Projector Features The projector integrates high-performance optical engine projection and a user- friendly design to deliver high reliability and ease of use. The projector offers the following features: • Small and light for portability • Ful
Summary of the content on the page No. 11
Remote Control Description The remote control sensors are located in the front/ back of the projector. The distance between the sensor and the remote control should not exceed 6 meters. LED Power Laser Pointer Source Menu Exit 3 Left/ Keystone - 4 Right/ Keystone + Blank Auto Mouse Pad L-Mouse/ R-Mouse L R Zoom in/ out Mouse Drag By pressing ZOOM IN +, the center of the picture will be Volume +/- magnified. When the + button is pressed again, the picture is Mute further magnified, up to
Summary of the content on the page No. 12
Installing or Replacing Batteries Position the lid Install batteries Push and slide the 2 3 1 over the as indicated by battery compartment the diagram compartment lid in and snap it back inside the the direction into place. compartment. Caution Avoid excessive heat and humidity. There may be danger of an explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries accord- ing to the manufac
Summary of the content on the page No. 13
INSTALLATION Screen Size Place the projector at the required distance from the screen according to the desired picture size (see the table below). L Projection Distance Screen Size (Max.) Screen Size (Min.) L. Projection Diagonal A. Width C. Height Diagonal B. Width D. Height distance (cm) (in) (cm) (cm) (in) (cm) (cm) 30.4 61.8 46.3 100 24.9 50.7 38.0 60.8 123.7 92.7 200 49.9 101.3 76.0 91.2 185.3 138.9 300 74.7 151.9 113.9 121.5 247.0 185.2 400 99.7 202.5 151.9 151.9 308.7 231.6 500 124
Summary of the content on the page No. 14
Please refer to "Menu System" on page 13 for information on the HDTV OSD selections. Connecting to Various Equipment It only takes a few seconds to connect your projector to your desktop or notebook computer, VCR, or other systems. However, a Mac adapter (an optional accessory) is needed for connection to Macintosh computers. Monitor RGB PC Audio To COMPUTER OUT To COMPUTER IN USB PC/Notebook PC Audio COMPUTER IN COMPUTER OUT COMPONENT (DVD/DTV INPUT) Pr Pb Y PC AUDIO IN DVD Player VIDEO Y
Summary of the content on the page No. 15
OPERATION Start Up 1. Plug the power cord into a wall socket. 2. Turn on the main power switch. 3. Press POWER to start the unit. The back-lit POWER key flashes green and stays green when the power is turned on. Remote Control Projector (When the power is turned off, there is a 120-second cooling period before the projector can be re-started.) 4. Switch on all connected equipment. DLP Personal Projector 11
Summary of the content on the page No. 16
Auto Digital Keystone Correction Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. To correct this, press KEYSTONE +/- (hot key) on the control panel of the projector or on the remote control, and then adjust the sliding bar labeled Keystone, as needed. Press + to correct keystoning at the top of the image. Press - to correct keystoning at the bottom of the image. Projector Remote control Auto Adjustment In some cases, you may need
Summary of the content on the page No. 17
Source Selection When several input sources are available, press the SOURCE key to make a selection from the control panel of the projector or the remote control. Remote control Projector Source Auto Source Menu System Press Menu for the main menu, and then press 3or 4 to select a sub-menu. Press Menu again to select items in the sub-menu. Menu Bar Sub-menu Display Image Source Control PIP Keystone Ratio Mirror Langauge Main page: Brightness H-position Source OSD PIP Source PC Contrast V-p
Summary of the content on the page No. 18
1. Display Menu FUNCTION DESCRIPTION Corrects any keystoning of the image. Keystone - Adjusts the brightness of the image. Brightness Adjusts the degree of difference between dark and light in the image. Contrast Adjusts to avoid the occurrence of flicker. Phase *This function is not available when the input mode is Video or S-Video. Adjusts to fit in the desired image size. H Size *This function is not available when the input mode is Video or S-Video. Increases or decreases the
Summary of the content on the page No. 19
2. Image Menu FUNCTION DESCRIPTION Users have 2 options for the image ratio. Ratio 1. 4:3 2. 16:9 Adjusts the horizontal position of the projected image. H Position Adjusts the vertical positon of the projected image. V Position Adjusts the color temperature to fit your preference. Color Temp Shows the current resolution. Information System information will be shown: System 1.NTSC 2. PAL 3.SECAM *The default setting for System is Auto. Adjusts the image to make it look sharper or sof
Summary of the content on the page No. 20
3. Source Menu FUNCTION DESCRIPTION 2. Ceiling mounted projection 1. Default Mirror 3. Rear screen projection and rear- 4. Ceiling mounted screen projection Selects the input source from among PC, YPBPR, Video and S- Source Video. Adjusts the volume level. Volume Adjusts the treble level. Treble Adjusts the bass level. Bass On Off Mute DLP Personal Projector 16
