Epson R210 user manual

Summary of the content on the page No. 1

Continuous Ink Supply System
for
Epson Stylus Photo R200/R210/R300/R310

Installation Instruction


For ST Prefilled Version

With Auto Reset Chips



This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and
Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole
operation is very easy. It’s really an effective tool to save your money.

Summary of the content on the page No. 2

CIS for EPSON stylus R200/R210/R300/R310 Instruction Thank you for purchasing ST Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed ST Continuous Ink Supply system on your own printer. Just imagining being able to print without regard to the ink level in those expensive little cartridges. Please take your time installing ST Contin

Summary of the content on the page No. 3

2) Print testing lines to ensure the printing head is good condition. 3) Print pictures to see whether the printing image is ok. 3、Installation Procedures: 1) First step Put the CISS on the left side Pull out the small rubber plug Place 4pcs of air filters into of the printer. In the meantime from the air hole as above air holes, the thicker side place all the tubes at correct picture shown. is d

Summary of the content on the page No. 4

Circumgyrate screwdreiver Separate the right side of Take off the cover of cartridge-car deasilly cartridge-car 4) Fourth step: Set up the Continuous Ink Supply System Remove original cartridge Insert our no-sponge cartridge Close the cover for cartridge into printer carefully 5) Fiveth step: Fix Support Arm Tear off the sticker Fix the arm on the 25cm right far from Tear off the stick

Summary of the content on the page No. 5

6) Sixth step : Install tubeline Insert tubelline through the arm Finished 7) Seventh Step: Adjust the tubeline Adjust the tubeline,remove the Make sure tubline will not meet Make sure the lengh of tubline is Cartridge-car back and forth printer when printing enough to reach the far left and right Too long twist Perfect 8) Eighth step

Summary of the content on the page No. 6

9)Nineth step: Nozzle check Usual Broken line 进入打印机喷嘴检查选项 The nozzle check patterns are in bro

Summary of the content on the page No. 7

Please pay attention to the ink level in the reservoirs; if the ink level is below 1CM as the above picture shown, please use refill kits to fill ink into Reservoir bottles. Carefully pull out the rubber plugs from the refill holes.(there is possibility of ink spattering. Be careful!) Refill ink according to the color in short supply. Then put the rubber back. (Please keep the printer and the reservoir at the same horizontal line during the process of refilling ink.) 6. H

Summary of the content on the page No. 8

Keep the reservoir bottles on the same level with the printer. 2. Try to keep at least 1/2 inch of ink in the bottles, as you don’t want to run out of ink and draw air into the cartridge. 3. Don’t place the Reservoir Bottles higher or lower much than the printer. 4. To be used in a dry place between 15 and 35 degree. Avoid exposure to direct sunlight. 5. Don’t put the continuous ink supply systems reversed or leaning during the shipment. Please make sure all the ink filling holes and Ve