Summary of the content on the page No. 1
LC-IO
COLOUR
NOT INTENDED FOR SALE
PN 8082025 I
MANUAL USERS
PRINTER
Summary of the content on the page No. 2
Federal Communications Commission Radio Frequency Interference Statement 15 l l l l 20402, 004-000-00345-4. above statement applies only marketed Self Declaration 1046/1984 1046/1984. above statement applies only marketed Germany. Trademark Acknowledgements LC-10, NL.40, NP-10, NX-10/15, ND-lo/H, M-10/15: IBM PC, IBM Proprinter BASIC, MSDOS: EX400, LX&l/W l l l l 1987 Star Ltd. Co., Micronics @Copyright manual. this in errors any for responsibility no assume can STAR not
Summary of the content on the page No. 3
HOW manual is and all 1 5. as 1 and up. this 2 up, this and 3 tips using and this this manual. 4 is shows using DOS and 5 and this what as A lists B and C a and D sets. character printer’s the of tables presents Appendix characters. new download define to use can you program BASIC presents Appendix commands. printer other sequences escape of functions the details Appendix specifications. technical printer’s the Appendix later. necessary it to refer then contains, it see t
Summary of the content on the page No. 4
is a that and sets. An and A a is With this l is and that and and l and l lamp and a surprising and l and a l handling and ail and A l Fast At 120 a than l an and a up 18 23 l and has and and small plus all plus cover. back the inside sample print the print-see quadruple-sized print, double-sized print, bold print, condensed styles, for italics case), lower or capitals with Orator Sanserif, (Courier, styles NLQ four style draht one printer The sizes styles type o
Summary of the content on the page No. 5
TABLE OF CONTENTS 1 1 1 1 and 3 up Install 6 Manual 9 and 12 14 Adjusting gap 14 19 2 19 and On 23 26 feed Page parking Paper functions combination Switch dump Hexadecimal style panel in Stay pitch panel in Stay pattern test Long pattern test Short functions Power-up switch Style Type NLQ switch Pitch Print switch Feed Paper switch Line indicator Power indicators Switches Chapter OPERATIONS PANEL CONTROL settings switch DIP printing the test Interface
Summary of the content on the page No. 6
Forward margin margin the USING THE 3 31 SOFTWARE 31 your Printer menu Printer command options Page width 33 the 33 your Page and pitch printer commands USING THE 4 37 DOS BASIC the (MS and 37 38 the printer with commands 40 the printer with A7 5 47 the printer 47 the ribbon 48 the print head 50 53 - Appendix A 59 Appendix B 59 Font commands 64 printing commands 64 Character set commands 66 Character and pitch commands 71 commands 76 commands
Summary of the content on the page No. 7
I C DOWNLOAD CHARACTER 89 D CHARACTER 97 98 #2 100 102 103 sets 104 INDEX 105 CARD cover the Inside REFERENCE character International set character Additional #l set character IBM set character IBM set character Standard SETS Appendix character NLQ character Draft GENERATOR Appendix
Summary of the content on the page No. 8
1 - l l and 0 up l l and l l Adjusting gap l and a l a l sunlight and l l dust, l as a as a l is l using up at a hanging and against that L E . items). five be should (there everything have you sure make to l-1 Figure box the in item each check carton the Open contents carton the Check INSPECTION AND UNPACKING free. page full least with below, from it to feed can forms the where printer the place forms, fanfold be will you If plate. identification the on specified
Summary of the content on the page No. 9
Figure 1-f. to you have five items: 1) 2) guide, 3) knob, 4) Ribbon and 5) manual. an parts: and bail Bail lever: against 2 platen. the paper the holds which paper the closes opens following the of locations the Note printer. the of inspection external Make User’s cartridge, Platen Paper Printer, all sure make Check
Summary of the content on the page No. 10
Release lever: must and up and parts. Rear Power and is a its push all hand is 3 gears. printer’s the damage can on power while by platen the Turning knob. platen the turn you when off be always should Power way. the in it can you until it Turn printer. the of side right the on shaft on knob platen the Mount packing. the of disposing before knob the remove to careful Be box. packing the inside printer your held which material packing foam white the of recess into packed knob plat
Summary of the content on the page No. 11
Remove top tabs at and igure Removing the top cover 1-4. - completely. cover the remove cover the of back the the disengage Then cover. top plastic clear printer’s the of edge front the Lift cower the -
Summary of the content on the page No. 12
has a this and brass I Figure l-5. Installing the ribbon top and tabs at swing is dust and and an to as is as manual. computer the in described computer your to cable the of end other the connect then OFF, turned computer the sure Make 1-6. Figure in shown printer the of side right the on socket connector the to cable interface the of end printer the Connect computer the printer the Connect adjustment. make or ribbon the change to only cover the Open sounds. operating print
Summary of the content on the page No. 13
Figure l-6. r;onnectmg tne mtertace power cord. that at is an AC wall is using Mount and 6 position. upright the to it raise guide the Mount cover. rear the of top on holes two the into fits guide paper The guide paper the booklet. instruction ASF the read (ASF), feeder sheet automatic optional the are you If paper. of sheets single loading for procedures the through you take will section This SHEETS SINGLE LOADING on. turned printer the while cord power the unplug or plug Never
Summary of the content on the page No. 14
igure i-7. Mounting the guide for single sheets start 1. that is and and signals. a a as past this and as as 3. bail bail a inch. about of top print to in ending forward slightly will paper back. lever the Move automatically. paper feeds printer opens, When forward. the go. it down insert the Work detector paper engages paper resistance feel You slot. the into it insert guide paper on sheet Place paper-out printer’s the are These flash. panel control on indicator the beep sho
Summary of the content on the page No. 15
lever is is is: 1. that is and at is 2. a as as as 3. bail bail. 4. 5. is straight, up hand, 6. bail bail. 8 paper the close to back lever the Move down. back lever release the move then by paper the straighten position, the to lever release the move not paper the If cover. top the under from out comes paper the of edge front the until clockwise knob platen the Turn paper the open to forward printer the of top on lever the Move loading. semiautomatic for way same the go, wil
Summary of the content on the page No. 16
sides and just plain up 10” and as 1. a and at 2. 3. up is is just 4. bail bail. 5. and 6. its and upwards and as Figure 7. and units, as 8. units and align 9. and 9 platen. the under in it tuck lever detector paper the over paper the of edge front the Insert paper. the in holes the with them can you so left right freely move to sprocket two the allows This down. levers clamp the Flip l-10. Figure in shown sprocket left right the on covers sprocket the Open cover rear the
Summary of the content on the page No. 17
lever Figure Opening the sprocket covers to the sprocket teeth igure Closing the sprocket covers 10. pins. that is 11. 12. Raise place. in unit sprocket one lock to levers clamp the of one 1). l-l (Figure covers sprocket the Close even. paper the Check sprocket the over paper the in holes the Fit l-71. expose l-10. -
Summary of the content on the page No. 18
13. 14. bail bail. 15. that is 16. upward and tabs at pads and snap 17. that paper guide and want a “park” 1. starts ON, up, and bail 2. On 11 off). indicator Line (On off-line printer the set to panel control the on switch Line the Press back. lever the lever release the position, printing in loaded paper fanfold power with parking Paper below. procedure the follow you if you for it will printer The sheet. single on print to you when it unload to have not do you paper, fanf
Summary of the content on the page No. 19
3. off the at the a page the top press the Paper feed paper forward a the top tear there. 4. Press the the 5. the press the Paper feed the the paper free of the 6. the the 7. the paper the Now sheets or as paper parked at the of the paper, the as 1. sheets the the paper 2. the paper the 3. the the 4. power ON, the forward. feed the parked paper for 5. the the Now are paper, test the as a test each a are so the paper - at that 1. Check that paper for 2. power off, press
Summary of the content on the page No. 20
I Figure 1. that is 2. With and 3. ON. start a its lights is - - that a 30 70 that is this is a up and a >PRN a manual a want a this this and install 3). Chapter (see correctly printer the support to software your chapter) of end the (see switches DIP printer’s the set to have will you succeed to for but software, word-processing with printout test try to may you Next view. into come will printout the times, few command the repeat you If help. need you if computer your
