Summary of the content on the page No. 1
VEC016
®
START-IT COMPACT
JUMP-START SYSTEM
AND 12 VOLT POWER SUPPLY
PORTABLE • CORDLESS • RECHARGEABLE
OWNER’S MANUAL
& WARRANTY INFORMATION
THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY,
OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USING,
READ AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND
PRODUCT LABELS, PLUS YOUR VEHICLE’S BATTERY MANUFACTURER GUIDELINES.
FAILURE TO DO SO COULD RESULT IN INJURY AND/OR PROPERTY DAMAGE.
4140 SW 28TH WAY, FT. LAUDERDALE, FL
Summary of the content on the page No. 2
SAFETY INFORMATION WARNINGS: WARNING STATEMENTS IDENTIFY CONDITIONS OR PRACTICES THAT MAY RESULT IN PERSONAL INJURY OR LOSS OF LIFE. 1) When working with lead acid batteries, always make sure immediate assistance is available in case of accident or emergency. 2) Always use protective eyewear when using this product: contact with battery acid may cause blindness and/or severe burns, be aware of first aid procedures in case of accidental contact with battery acid. 3) There is a risk of explosive g
Summary of the content on the page No. 3
IMPORTANT: Although this unit is delivered in a partially-charged state - you must fully charge it with the supplied 110/120 Volt AC charger for a full 24 hours before using it for the first time. You can not overcharge the unit using the AC charger method. CAUTIONS: Caution statements advise against certain conditions and practices that may result in damage to vehicles, appliances and/or The START-IT Compact Jump-start System. 1) Use only the supplied cords/adapters for recharging this unit. Do
Summary of the content on the page No. 4
CONTENTS 1. INTRODUCTION ............................................................ 5 1.1 ADDITIONAL KEY FEATURES .................................................... 6 1.2 USES OF START–IT COMPACT................................................... 7 2. USE AS JUMP-START SYSTEM........................................ 7 2.1 JUMP-START WARNINGS .......................................................... 7 2.2 FIRST AID.........................................................................
Summary of the content on the page No. 5
1. INTRODUCTION Congratulations on selecting the Vector® Model VEC016 Compact Jump Starter and DC Power System. It can jumpstart most vehicles or boats with a standard 12 volt DC electrical system: boat, small truck, car, airplane, RV, personal watercraft, snowmobile, tractor, etc. Note that this jump starter is extra safe compared to others because it has a Safety Power Switch and a self- contained Audible Polarity alarm that sounds when the cable clamps are connected to incorrect polarity. Thi
Summary of the content on the page No. 6
Moving to the left of the AC recharge port are three LEDs, called the Battery Status Display, and a Battery Status Pushbutton. Pressing the pushbutton turns on the Battery Status Display. The pushbutton is pressed to check the battery level at any time. During AC recharge, the display is automatically active. During DC recharge, the display pushbutton can be periodically pressed to monitor the recharge process. The colors of the three Battery Status Display LEDs are two red and one green. Durin
Summary of the content on the page No. 7
READ INSTRUCTION MANUAL AND PRODUCT LABELING CAREFULLY, BEFORE USING THIS PRODUCT. FOLLOW RECOMMENDED WARNINGS, CAUTIONS, AND SAFETY PROCEDURES, AND MANUFACTURER’S GUIDELINES FOR YOUR VEHICLE BATTERY. IMPORTANT This unit is delivered in a partially charged state - you must fully charge it before using it for the first time. Initial AC Charge should be for 24 hours. Refer to Sections 4.1 and 4.2 for use of AC Recharge Adapter and DC/DC Charging Adapter. 2. USE AS A JUMP-START SYSTEM 2.1 JUMPSTART
Summary of the content on the page No. 8
2.3 JUMP-START PROCEDURE FIGURE 2 CABLE CLAMP HOLSTERS CABLE CLAMP 1. Turn Off ignition and all accessories (radio, a/c, lights, cellphone, etc). If vehicle, place transmission in “park” and set the emergency brake. 2. Make sure the unit’s Power Safety Switch is turned OFF. 3. Observe jump-starting negative or positive ground system, as follows: Negative ground (negative battery Terminal connected to chassis) - most common. 4. Carefully lift negative (black) jumper cable wire from storage channe
Summary of the content on the page No. 9
3. USE AS A 12-VOLT DC PORTABLE POWER SUPPLY WARNING: NEVER INSERT A CIGARETTE LIGHTER INTO ACCESSORY SOCKET NOTE: Make sure that the Unit’s Power Safety Switch is ALWAYS in the Off position when using the unit’s 12 volt DC cigarette-lighter type accessory outlet. 1. Lift up the cover of the unit ‘s 12 volt DC socket. 2 Insert the 12 volt DC plug from the appliance into the cigarette lighter type socket on the unit. DO NOT EXCEED A 15 AMP LOAD. 3. Switch on the appliance, as usual. 4. Periodica
Summary of the content on the page No. 10
4.2 DC RECHARGE Recharging the Main Unit from an external DC power source requires the use of the DC/DC Recharge Cable. This cable has a DC connector at each end. See Figure 3B. MAKE SURE SAFETY ON/OFF SWITCH AND WORKLIGHT ARE TURNED OFF DURING RECHARGE, THIS MAY SLOW RECHARGE OF THE MAIN BATTERY. Unlike the AC Recharge method, DC Recharge does not automatically activate the Battery Status Display and provide a taper charge. To check the battery status, press the Battery Status Display Pushbutto
Summary of the content on the page No. 11
6. BATTERY DISPOSAL Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Recycling is required -contact your local authority for information. Failure to comply with local, state and federal regulations can result in fines, or imprisonment. BATTERY DISPOSAL WARNINGS • Do not dispose of the battery in fire as this may result in an Explosion • Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent s
Summary of the content on the page No. 12
If the unit is repaired, new or reconditioned replacement parts may be used, at Vector Manufacturing’s option. A unit may be replaced with a new or reconditioned unit of the same or comparable design. The repaired or replaced unit will then be warranted under the terms of the remainder of the warranty period. The customer is responsible for the shipping charges on all returned items. During the warranty period, Vector Manufacturing, Ltd. will be responsible for the return shipping charges. LIMIT
