Tripp Lite SmartPro SLT SMART1500SLT user manual

Summary of the content on the page No. 1

200308025 Smart1050-1500SLT Owner’s Manual.qxd 11/14/2003 11:40 AM Page 1
Owner’s Manual
® ®
SmartPro SLT & SmartPro XL
Intelligent Tower (Accessory Slot-Equipped) UPS Systems
• Line-Interactive Operation  Sine-Wave Output  Extended Run (XL) Options
SmartPro SLT Models: SMART1050SLT & SMART1500SLT
SmartPro XL Model: SMART750XL
Important Safety Instructions 2
Quick Installation 3
Optional Installation 4
Basic Operation 5
Battery Replacement 9
Storage and Service 10
11
Specifications
13
Es

Summary of the content on the page No. 2

200308025 Smart1050-1500SLT Owner’s Manual.qxd 11/14/2003 11:40 AM Page 2 Important Safety Instructions Quick Installation SI 1 Using a small tool, set the Voltage SAVE THESE INSTRUCTIONS W Dip Switch to match your input FA This manual contains instructions and warnings that should be followed during the installation, operation and storage of all Tripp Lite UPS Systems. Failure to heed these voltage. (All models are preset to warnings will void your warranty. the 120V setting.) 120V Note: if

Summary of the content on the page No. 3

200308025 Smart1050-1500SLT Owner’s Manual.qxd 11/14/2003 11:40 AM Page 4 Optional Installation Basic Operation These connections are optional. Your UPS will function properly without these connections. Front Panel Switches 1 USB and RS-232 Serial “ON/TEST” Switch: This switch controls four separate UPS functions: Communications 1a UPS Power On Use the included USB cable and/or DB9 SIGNAL ON/TEST To turn power on at the outlets, press the “ON/TEST” switch, 1b serial cable to connect the com

Summary of the content on the page No. 4

200308025 Smart1050-1500SLT Owner’s Manual.qxd 11/14/2003 11:40 AM Page 6 Basic Operation (continued) Basic Operation (continued) continued Front Panel Indicator Lights Rear Panel NORMAL “BOOSTING” LED: This yellow light will be lit when the UPS is AC Outlets: These 15-amp receptacles provide your connected equip- boosting AC utility power to nominal levels and providing it to connected BOOSTING ment with voltage regulated AC output from the AC line during nor- equipment. The UPS will click

Summary of the content on the page No. 5

200308025 Smart1050-1500SLT Owner’s Manual.qxd 11/14/2003 11:40 AM Page 8 Basic Operation (continued) Battery Replacement continued Under normal conditions, the original battery in your UPS will last several Rear Panel years. Contact Tripp Lite for information about replacement batteries. Input Breaker: Protect your electrical circuit from overcurrent draw 1 Carefully pull the front panel down, out from the UPS load. If this breaker trips, remove some of the load, 1 then reset it by pressing

Summary of the content on the page No. 6

200308025 Smart1050-1500SLT Owner’s Manual.qxd 11/14/2003 11:40 AM Page 10 Storage and Service Specifications Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice. Storage First turn your UPS OFF: press the “OFF” switch to turn power off at the outlets, then discon- SmartPro SLT UPS Systems nect the power cord from the wall outlet. Next, disconnect all equipment to avoid battery drain. Model: SMART1050SLT SMART1500SLT If you plan on storing yo

Summary of the content on the page No. 7

200308025 Smart1050-1500SLT Owner’s Manual.qxd 11/14/2003 11:40 AM Page 12 Specifications (continued) Manual del propietario FCC RADIO/TV INTERFERENCE NOTICE: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if

Summary of the content on the page No. 8

1111 W. 35th Street, Chicago, IL 60609 USA 773.869.1234 (USA) • 773.869.1212 (International) www.tripplite.com