Summary of the content on the page No. 1
The
PST-2+6
Owners Manual
Summary of the content on the page No. 2
Introduction Thank you for purchasing the Furman Power Station-2+6 Power Conditioner. For over 30 years, Furman has pioneered the development of AC power products for the most demanding audio, video, and broadcast professionals. Furman’s Ground Contamination Free Surge Protection, Advanced Filtering Technology, and Digital- HD Television Ready circuitry can signifi cantly improve your sensitive components while protecting them from spikes, surges and contaminated AC power. Today’s power gr
Summary of the content on the page No. 3
parts inside. Refer servicing to qualifi ed personnel only. Important Safety Instructions 1. Please read and observe all safety and operating instructions before installing your Power Station-2+6 (PST-2+6). Retain these instructions for future reference. 2. Your PST-2+6 should not be used near water – for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, near a swimming pool, etc. 3. Do not place your PST-2+6 near heat sources such as radiators, heat registers,
Summary of the content on the page No. 4
7. Your PST-2+6 should be serviced by qualifi ed service personnel when: • The power supply cord or the plug has been frayed, kinked, or cut. • Objects have fallen or liquid has spilled into the unit. • The unit has been exposed to rain or other moisture. • The unit does not appear to operate normally, exhibits a marked change in performance, or the Surge Protection or Ground indicator is not lit. • The unit has been dropped, or the enclosure damaged. 8. Your PST-2+6 requires that a safety gro
Summary of the content on the page No. 5
suppressors. Further, our cable and satellite suppressors are TIVO friendly as well as HD-Digital Television ready. Both DC carrier signals as well as high bandwidth signals can pass through our circuit. In fact the bandwidth is less than 0.1dB loss at 1GHz! To connect your cabling to these in-line protectors, simply follow the in and out indications marked next to the Telco, and Cable / Satellite connectors. Note: It is not possible to make an in-line cable / satellite protector “maint
Summary of the content on the page No. 6
circuit breaker button! It is the round black button adjacent to the incoming AC cord. If the circuit breaker trips immediately, there may be too great of a current load placed upon it. Simply disconnect one product at a time until this no longer happens. If the breaker trips with no components connected, there may be a wiring defect that requires Furman service. Indicators Protection OK Indicator: Although Furman’s Ground Contamination Free Surge Suppression rarely requires servicing
Summary of the content on the page No. 7
the crossed cutout on the bottom surface of the Power Station. Next, simply allow the Power Station to move down and seat into the end of its oval cut-out. Adjust the pan head screw if necessary. Warranty Furman Sound, Inc., having its principal place of business at 1997 South McDowell Blvd., Petaluma, CA 94954 (“Manufacturer”) warrants its PST- 2+6 (the “Product”) as follows: Manufacturer warrants to the original Purchaser of the Product that the Product sold hereunder will be free fr
Summary of the content on the page No. 8
THE FOREGOING IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Manufacturer does not warrant against damages or defects arising out of improper or abnormal use of handling of the Product; against defects or damages arising from improper installation, against defects in products or components not manufactured by Manufacturer, or against damages resulting from such non-Manuf
Summary of the content on the page No. 9
If any part of this Limited Warranty is determined to be void or illegal, the remainder shall remain in full force and effect. Service All equipment being returned for repair must have a Return Authorization (R/A) Number. To get an R/A number, please call the Furman Service Department at (707) 763-1010 ext 121, between the hours of 8:00 am and 5:00 pm US Pacifi c Time. When returning equipment for repair, please use the original packaging to ship the product. Also, please enclose a note giv
Summary of the content on the page No. 10
10
Summary of the content on the page No. 11
11
Summary of the content on the page No. 12
Furman Sound, Inc. 1997 South McDowell Blvd. Petaluma, California 94954-6919 USA Phone: 707-763-1010 Fax: 707-763-1310 Web: www.FurmanSound.com E-mail: info@furmansound.com 12 011104-D
