ETA Systems ETA-S15 user manual

Summary of the content on the page No. 1

ETA-S15
Power Conditioner & Distribution Unit
ETA-S15
Power Conditioner & Distribution Unit
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
– 1 – ETAsys.com
Specifications are subject to change without notice.

Summary of the content on the page No. 2

ETA-S15 Power Conditioner & Distribution Unit TABLE OF CONTENTS Safety Instructions ...................................................................................................................................3 Introduction ..............................................................................................................................................5 Key Features .............................................................................................................

Summary of the content on the page No. 3

ETA-S15 Power Conditioner & Distribution Unit SAFETY INSTRUCTIONS The lightning flash with arrowhead symbol within an CAUTION equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage “ within the RISK OF ELECTRIC SHOCK PA Amplifier DO NOT OPEN product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Model AA35 RISQUE DE DECHARGE ELECTRIQUE ´ ATTENTION -NE PAS OUVRIR. Output Rated 35W The exclamat

Summary of the content on the page No. 4

ETA-S15 Power Conditioner & Distribution Unit CAUTION– WHEN INSTALLING THE PRODUCT • Plugging in or unplugging the power cord with wet hands may result in electric shock. • Never move the device with the power cord plugged into the wall, as damage to the power cord may result. • When unplugging the cord from the wall, grasp the plug, NOT the cord. • Never install this device in humid or dusty locations, nor in di

Summary of the content on the page No. 5

ETA-S15 Power Conditioner & Distribution Unit INTRODUCTION Thank you for purchasing the ET A Systems ET A-S15 AC Power Conditioner & Distribution Unit. The ET A-S15 has been designed to meet most installation requirements for AC power distribution and equipment power protection. The ET A-S15 features noise filtering for unwanted Radio Frequency Interference (RFI) that is commonly introduced into AC lines by nearby radio transmitters or wireless produ

Summary of the content on the page No. 6

ETA-S15 Power Conditioner & Distribution Unit FRONT PANEL FEATURES 1 2 3 1. Un-switched AC Outlet – The 120V AC outlet is always live when the ET A-S15 power cord is plugged into an AC mains power source and voltage is present. Note: The AC mains power switch does not affect the Unswitched AC Outlet. The Unswitched Outlet is protected by the surge protection circuitry. 2. AC Mains Breaker – The 15A rated breaker will open if the combined d

Summary of the content on the page No. 7

ETA-S15 Power Conditioner & Distribution Unit SPECIFICATIONS Type Power Conditioner & Suppressor Load Rating 15A Front Panel Outlets 1 Unswitched Activation Switch Rocker Circuit Breaker 15A Resettable Indicators AC Power On Rear Panel AC Outlets 8 Outlets total, 6 Switched, 2 Unswitched AC Mains Power Cord 9' (3m), 14-gauge Technical Data Current Rating 15 amps Operating Voltage 102VAC – 132VAC Min. Spike Clamping Voltage 460VRMS @ 3,000A Max. Spike Clamping Volta

Summary of the content on the page No. 8

ETA-S15 Power Conditioner & Distribution Unit LIMITED WARRANTY All products manufactured by ET A Systems are warranted to the original dealer/installer , industrial or commercial purchaser to be free from defects in material and workmanship and to be in compliance with our published specifications, if any. This warranty shall extend from the date of purchase for a period of one year . Additionally , fuses and lamps carry no warranty . ET A Systems will