Summary of the content on the page No. 1
User’s Manual
Office Series UPS
OP650
ADDITIONAL INSTALLATION TIPS CAN BE FOUND AT:
www.cyberpowersystems.com/FAQs.htm
Summary of the content on the page No. 2
TABLE OF CONTENTS IMPORTANT SAFETY WARNINGS…………….……………………………………….………1 INSTALLING YOUR UPS SYSTEM…………………….………………………………….……2 - UNPACKING…… ………………………………………………………………..2 - HARDWARE INSTALLATION GUIDE…………………………………….……2 BASIC OPERATION…………………………………………...................................................2 - FRONT PANEL AND REAR PANEL DESCRIPTION....................................2 BATTERY REPLACEMENT AND STORAGE………………………………………….…...….4 - BATTERY REPLACE
Summary of the content on the page No. 3
OP650 Guaranteed Uninterruptible Power System IMPORTANT SAFETY WARNINGS (SAVE THESE INSTRUCTIONS) This manual contains important instructions that should be followed during installation and maintenance of the UPS and batteries. Please read and follow all instructions carefully during installation and operation of the unit. Read this manual thoroughly before attempting to unpack, install, or operate. CAUTION! UPS must be live parts inside can be energized by the
Summary of the content on the page No. 4
INSTALLING YOUR UPS SYSTEM UNPACKING Inspect the UPS upon receipt. The box should contain the following: (1) UPS Unit; (1) User’s Manual for UPS; (1) Warranty Registration Card; TM TM (1) PowerPanel Plus Software Disk; (1) User’s Manual for PowerPanel Plus ; (1) Serial Interface Cable (DB-9); (1) Serial-to-USB cable; (1) Telephone Cable HARDWARE INSTALLATION GUIDE 1. Connect the equipment to your UPS outlets. Items such as copiers, laser printers, vacuums, space heaters, or o
Summary of the content on the page No. 5
OP650 Guaranteed Uninterruptible Power System ◆ Power Switch Press the power button to turn the UPS ON or OFF ◆ Power On Indicator This LED is illuminated when the utility condition is normal and the UPS outlets are providing “clean power”, free of surges and spikes ◆ Using Battery Indicator This illuminates during utility failure, indicating that the battery is supplying power to the battery-power supplied outlets. ◆ BOOST Indicator This LED indicates that the UPS
Summary of the content on the page No. 6
◆ Circuit Breaker Reset for Overload Protection Circuit breakers provide optimal overload protection. When overload occurs, the circuit breaker will switch to battery mode. You will need to reset the circuit breaker so UPS will provide the power from utility. ◆ Serial Port to PC This port allows connection and communication from the DB-9 serial or USB port on the computer to the UPS unit. The UPS communicates its status to the PowerPanel Plus™ software. This interface is also c
Summary of the content on the page No. 7
OP650 Guaranteed Uninterruptible Power System BATTERY REPLACEMENT PROCEDURE: 1. Turn off and unplug all connected equipment. 2. Turn the UPS off and unplug it from the AC power source. 3. Turn the UPS upside down. 4. Remove the 4 retaining screws and remove the cover. 5. Remove the battery from the compartment. 6. Disconnect the battery wires from the battery. 7. Install the replacement battery by connecting the red wire to the positive (+) termin
Summary of the content on the page No. 8
TROUBLESHOOTING Problem Possible Cause Solution The UPS does not Batteries are not fully charged. Recharge the battery by leaving the perform expected UPS plugged in. runtime. Battery is slightly worn out. Contact CyberPower Systems at tech@cyberpowersystems.com The UPS will not The on/off switch is designed to Turn the UPS off. Wait 10 seconds turn on. prevent damage by rapidly turning and then turn the UPS on. it off and on. The unit is not connected to an AC The unit must b
Summary of the content on the page No. 9
OP650 Guaranteed Uninterruptible Power System TECHNICAL SPECIFICATIONS Model OP650 Capacity (VA) 650VA Capacity (Watts) 350W Input Input Voltage Range 85Vac – 145Vac Frequency Range 47 – 63 Hz Output On Battery Output Voltage Simulated Sine Wave at 120Vac +/- 5% On Battery Output Frequency 60 Hz +/- 1% Transfer Time (Typical) 4ms Overload Protection On Utility: Circuit Breaker, On Battery: Internal Current Limiting Surge Protection and Filtering Li
Summary of the content on the page No. 10
DEFINITIONS FOR ILLUMINATED LED INDICATORS Condition Power Using Circuit Wiring On Battery Boost Buck Breaker Alarm Fault On Off Off Off Off Set Off Normal Max. boost 15% of input voltage for output On Off Off Flash Off Set Off regulation while input voltage is from 8% to 30% under nominal. Max. buck 15% of input voltage for output On Off Off Off Flash Set Off regulation while input voltage is from 8% to 26% over nominal. Utility Failure
Summary of the content on the page No. 11
OP650 Guaranteed Uninterruptible Power System LIMITED WARRANTY AND POWER CONTROL GUARANTEE In purchasing OP650 in the United States or Canada, the original end user receives a Limited Warranty and CyberPower's Power Control Guarantee from Cyber Power Systems (USA), Inc. (for ease of reading, referred to as "CyberPower"). The Limited Warranty and the Power Control Guarantee are intended to be the original end-user's exclusive rights and remedies. The Limited Warranty and the Power Cont
Summary of the content on the page No. 12
Exclusive Remedies Under Limited Warranty. Your exclusive remedy and CyberPower's' sole obligations are as follows for the Product: If (a) the CyberPower Product you purchased and still own is defective in material or workmanship under this Limited Warranty or any applicable warranty imposed by law, and (b) all Limited Warranty requirements have been met, CyberPower will repair or replace the Product if it proves to be defective in material or workmanship during the Warranty Per
Summary of the content on the page No. 13
OP650 Guaranteed Uninterruptible Power System the three year limit), CyberPower will (as CyberPower elects, as permitted by law), repair, replace, or pay the Agreed Damage Amount (defined below) for, the item(s) of your electronic equipment directly and properly connected to the product (the "Connected Equipment") if that Connected Equipment is (x) damaged by AC power line transients, spikes, or surges on properly installed, grounded, and code-compliant 120 volt power lines in the Uni
Summary of the content on the page No. 14
2. The aggregate ceiling amount for all Connected Equipment: CyberPower UP650 --$125,000 3. The amount(s) of all payment you have or are entitled to receive from insurance, other warranties, extended warranties, or from other sources or persons for the Connected Equipment or damage to such equipment so that CyberPower’s maximum liability shall be reduced to reflect all such other payments or sources of recovery If CyberPower replaces the connected equipment or pays to the Initial
Summary of the content on the page No. 15
OP650 Guaranteed Uninterruptible Power System properly installed, grounded and code-compliant 120 volt power lines in the United States and Canada; transients, surges or spikes on standard telephone land lines, PBX telephone equipment lines or Base 10T Ethernet lines, when properly installed and connected. (This exclusion applies, for example, to fluctuations in data transmission or reception, by CATV or Therefore transmission or fluctuations, or by transients in such transmission. 3.
Summary of the content on the page No. 16
FCC Notice: This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee tha
