Summary of the content on the page No. 1
="~ .. --~
~c~=--
uni' en@
. PC33X
40 Channel
MobileCB Radio
.
,--_...
--'..--.-
Summary of the content on the page No. 2
.-- INTRODUCTION WARNING Your UNIDENModel PC33Xrepresents the most advanced Mobile station type radio ever designed for use in the Citiz- Beforetransmitting with your transceiv- ens Band Radio SeNice. It will operate er, you must obtain a Department of on any of the 40 frequencies designated Communications (D.O.C.) Citizens Ra- as citizens band channels by the De- dio licence. Obtain an application partment of Communications. Your form, from the D.O.C. Before complet- Model PC33Xfeatures a frequ
Summary of the content on the page No. 3
1 7. CHANNEL SELECTORSWITCH: uals or immediate protection of @ @ CD @ @ I This switch sele~ts. the desired property. Channe.I 9 also may be . channel fortransmissionand recep- used to render assistanceto a mo- tion. All channels, except channel torist. This in a D.O.C. rule and ap- 9, may be used for communications plies to all operators of citizens between stations operating under band radios. different license. Channel 9 has 8. TX INDICATOR: Light Emitting been reseNed by the D.O.C. for Diode
Summary of the content on the page No. 4
OPERATION OPERATING PROCEDURE TO surement must be performed prior to RECEIVE the use of the transmitter. A.V.S.W.R. in excess of 2 : 1may damage the trans- 1. Be sure that the power source, an- mitter. . tenna and microphoneare connect- 1. Be sure the operator has read and ed to the proper connectors before understands D.O.C. Rulesand Regul- going to the next steps. ations prior to operating the trans- 2. Turn the unit ON by rotating the Vo- mitter. lume Control clockwise. 2. Select the desired
Summary of the content on the page No. 5
INSTALLATION MOBILESTATION INSTALLATION bile, although the efficiency is less than A negative ground system is generally convenient point and connect the black Plan the location of the transceiver and a full quarter wave whip antenna. identified by the (-) battery terminal power lead to the chassis or vehicle microphone bracket before starting the being connected to the vehicle motor frame, or (-) battery terminal. installation. Select a location that is For marine installation, consult your blo
Summary of the content on the page No. 6
<:::::c '", I SPECIFICATIONS GENERAL 40. Channels: 26.965 to 27.405 MHz. FrequencyRange: FrequencyControl: Phase Locked Loop (PLL) synthesizer. + 0.005%. FrequencyTolerance: Operating Temperature - 30°C to + 50°C. Range: Microphone: Plug in DIN type: Electret Input Voltage: 13.8V DC nom. (positive or negative ground). Current Drain: Transmit: AM full mod., 1.7A(maximum). Receive:Squelched, 0.23A; full audio output I.4A (nominal). Size (W x Lx H): 4-9/16'W (116mm) x 6-II/16"L (170mm) x l-I/2"H (3
Summary of the content on the page No. 7
~..... OPERATOR TROUBLESHOOTING Should the unit malfunction or not per- We highly recommend that you consult form properly, the operator should per- a qualified radiotelephone technician form the procedures indicated below: for the seNicing and alignment of this CB radio product 1. Ifthe transceiver is completely inop- erative. Please refer to the WARNING informa- tion contained in this Owner's Guide. * Check the power cord and fuse. 2. Iftrouble is experienced with receiv- (NOTE: When ordering
Summary of the content on the page No. 8
--... :e -= ~ '"" WARRANTY WARRANTOR. SANTRON/C AGEN- its representatives in connection with the CIES PTY. LTD. 13 Garema Circuit, performance of this Warranty. In Kingsgrove NSW 2208 ("SANTRON/C"j. addition, if the Product contains a defect ELEMENTS OF WARRANTY. or malfunction which is not repaired after SANTRON/C warrants, for the duration a reasonable number of attempts by War- of this warranty, its UN/DEN CB Product rantor to repair the Product, the Product to be free from defects in materia
