La Crosse Technology WS-7212U user manual

Summary of the content on the page No. 1

WS-7212U Wireless 433 MHz Weather Station Instruction Manual



















INVENTORY OF CONTENTS
1. Two indoor weather stations (Figure 1)
2. The remote temperature/humidity sensor (TX4U) and mounting bracket. (Figure 2)
3. Mounting hardware.
4. Instruction Manual and Warranty Card.


Figure 1




Figure 2










ADDITIONAL EQUIPMENT
(not included)
1. 1 Philips screwdriver.
2. 4 Fresh AA 1.5V batteries.
(2 for each indoor weather st

Summary of the content on the page No. 2

After both indoor temperature and outdoor temperature and humidity are displayed for 10 minutes you can place your remote temp/humidity sensor outdoors and set your time. Notes on Outdoor Sensor Placement The remote temp/humidity sensor should be placed in a dry, shaded area. Fog and mist will not harm your remote temp/humidity sensor but direct rain must be avoided. The remote temp/humidity sensor has a range of 80 feet. Any walls that the signal will have to pass through will r

Summary of the content on the page No. 3

SETTING THE TIME 6. Press and hold the “SET” button for 5 seconds. 7. The hour will begin to flash. 8. Press and release the “+” button to advance the hour to your desired hour. 9. Press and release the “SET” button to move to the minute setting. 10. The minutes will begin to flash. 11. Press and release the “+” button to set the minutes. 12. Press and release the “SET” button to activate the clock. Note: There is “PM” displayed to the left of the hour when between noon an

Summary of the content on the page No. 4

D. VIEWING AND OPERATING WITH MULTIPLE REMOTE SENSOR UNITS 1. To view the temperature of a different remote sensor unit, press and release the “CH” button. A shift from one “boxed” number to the next should be observed in the OUTDOOR LCD. 2. To view the Minimum/Maximum temperature: first select from which remote temp/humidity sensor to read data from (indicated by the “boxed” number). Pressing and releasing the “MIN/MAX” button will toggle through the minimum and maximum

Summary of the content on the page No. 5

Problem: Temperatures do not match if units are placed next to each other. Solution: Each temp/humidity sensor is manufactured to be accurate to within 2 degree plus or minus and under normal conditions. It is possible for two temp/humidity sensors to be as much as 4 degrees different. The difference can be exaggerated further because the temp/humidity sensors are designed for different working environments. The indoor sensor is less responsive to ambient air currents because of the shield

Summary of the content on the page No. 6

MAINTENANCE AND CARE INSTRUCTIONS • Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. • Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. • Do not submerge in water. • Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. • Opening the casings invalidates the warranty. Do not try to repair the unit. Contact La Crosse Technolo

Summary of the content on the page No. 7

WARRANTY INFORMATION La Crosse Technology provides a 1-year warranty on this weather station. Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the weather station in for repairs, contact La Crosse Technology. The weather station will be repaired or replaced with the same or similar model. This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the weather stations