Summary of the content on the page No. 1
VOD808 Drop Down DVD Video Monitor
Installation Guide
Summary of the content on the page No. 2
IMPORTANT An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function then the vehicle is in ‘park’ or when the vehicle’s parking brake is applied. An LCD panel
Summary of the content on the page No. 3
MATERIALS INCLUDED IN THIS PACKAGE: 1) VOD808 DVD Video Monitor with TV Tuner (P/N 136D2402) (1 pc) 2) Accessory 8 pin FM Transmitter Harness (P/N112B3262) (1 pc) 3) 2 Pin Power Wire Harness with choke (P/N 112B3143) (1 pc) 4) 12 Pin Power / Signal Harness (P/N 112B2821) (1 pc) 5) Protective Covers (2pcs) Left Protective Cover for IR sensor (P/N 102B3689) (1pc) Right Protective Cover for Headphone Jacks (P/N 102B3690) (1pc) 6) Hardware Package #4 x 3/8” Screws (12 pcs) #8 x 5/8” Self Dr
Summary of the content on the page No. 4
GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, Satellite nd Radio, VCP, Tuner, RF Modulator/external amp, remote headphones, 2 VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups. 3) Decide upon mounting locations of all components and method of mounting. 4) Prep the vehicle by removing any interior trim necessary to gain access to vehicle's wiring as well as all areas where
Summary of the content on the page No. 5
VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), constant power source (+12 Vdc at all times). Also locate a good grounding point. Generally, these connection points can be found at the Ignition Switch, Fusebox, Radio etc. 2) The mounting method and location will vary from vehicle to vehicle, so this manual will only focus on the installation of the video monitor and related console accessories. 3) Generally, the
Summary of the content on the page No. 6
MINI CONSOLE INSTALLATION: This page only covers special installation considerations for the mini-console installation. If the video monitor is to be installed in a vehicle with the mini console, the console may need to be trimmed to fit the contour of the vehicle headliner. 1) In this installation, the video monitor is mounted directly to the overhead cross-member in the roof using the mounting screw bosses. These screw bosses should contact the cross-member di- rectly (i.e.: no gap between th
Summary of the content on the page No. 7
MOUNTING THE MINI-CONSOLE Roof Roof Support Headliner 12"x9"x3/4" Plywood Block (4) Self-Tapping Screws (not supplied) Mini-Console Video Unit (5) #8 Flat Washers (5) #8x5/8" Self-Tapping Screws (1) Rubber Plug -5-
Summary of the content on the page No. 8
Sold Seperately VOD808 Male (white) RCA Jack Audio Input For Audio Source with Car Audio In Low Level Output L/R (Ex. Satellite Radio) Male (red) Hard Wired FM Modulator Output RCA Jack Am/Fm Antenna TO FM FACTORY Modulator Dash Radio FM Modulator RADIO 8 Pin Modulator Hardness Battery Red: +12VDC Power Harness (Accessory Cir.) Mini-Din Connectors Choke Black: Ground Dome Light Connection. Refer to connecting the 1 Dome Light. TV antenna (If applicable) LEFT WHITE For Receivers with Low Leve
Summary of the content on the page No. 9
CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of dome light circuits used, positive or negative switched. Positive systems supply voltage to the interior lights to turn them on, negative switched systems apply ground to illuminate the bulbs. To determine which system you have you must locate the wires at the dome light. On a positive switched system, with all the doors closed and the lights out, b
Summary of the content on the page No. 10
Negative Switched Dome lighting Red / black - Lamp on To 12 pin Black / red - Lamp common connector Purple / brown - Lamp Auto To constant Factory Dome light circuit To constant Factory Door ajar switch or Body Troubleshooting: SYMPTOM: REMEDY: No power at Video Monitor -Verify +12 VDC on Red wire at 2 pin Power Harness behind video monitor. Verify ground connection with continuity test from known good ground to black wire at 2 pin Power Harness Power but no video or -Verify that the corre
Summary of the content on the page No. 11
This page blank intentionally -9-
Summary of the content on the page No. 12
For Customer Service Visit Our Website At WWW.audiovox.com Product Information, Photos, FAQ’s Owner’s Manuals 128-6703 © Copyright 2003 Audiovox Electronics Corp. 150 Marcus Blvd. Hauppauge, NY 11788
