Summary of the content on the page No. 1
300_CoverGN_Eng.fm 1 ページ ２００５年１１月２３日 水曜日 午後１０時０分
Operating Instructions
Digital Video Camera
Model No. NV-GS300
Before use, please read these instructions completely.
GN
VQT0T29
Summary of the content on the page No. 2
Safety.fm 2 ページ ２００５年１１月２３日 水曜日 午前１１時５７分 ≥The Movie Camera uses copyright-protected Information for your safety technologies and is protected by the patented technologies and intellectual properties of Japan and the U.S. To use these copyright- As this equipment gets hot during use, protected technologies, authorization of the operate it in a well-ventilated place; do Macrovision Company is required. It is not install this equipment in a confined prohibited to disassemble or modify the
Summary of the content on the page No. 3
VQT0T29_ENG.book 3 ページ ２００５年１１月２２日 火曜日 午後１１時５分 -If you see this symbol- Information on Disposal in other Countries outside the European Union This symbol is only valid in the European Union. If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal. 3 VQT0T29
Summary of the content on the page No. 4
dvc_nextTOC.fm 4 ページ ２００５年１１月２５日 金曜日 午後６時３０分 Contents Information for your safety ................................... 2 Recording in natural colours (White balance) ............................................... 37 Manual focus adjustment ................................... 38 Before using Manual shutter speed/aperture adjustment........ 38 Accessories.......................................................... 5 Optional................................................................ 5 Playba
Summary of the content on the page No. 5
VQT0T29_ENG.book 5 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using Before using Optional 1) AC adaptor (VW-AD11GN) Accessories 2) Battery pack (lithium/CGR-DU06/640mAh) The followings are the accessories supplied with 3) Battery pack (lithium/CGA-DU07/680mAh) this product. 4) Battery pack (lithium/CGA-DU12/1150mAh) 5) Battery pack (lithium/CGA-DU14/1360mAh) 1) 6) Battery pack (lithium/CGA-DU21/2040mAh) 7) Wide conversion lens (VW-LW3707M3E) 8) Tele conversion lens (VW-LT3714ME) 9) Filter kit
Summary of the content on the page No. 6
body.fm 6 ページ ２００５年１１月２５日 金曜日 午後６時２６分 Before using (22) (8) (23) A/V (9) (20) REMOTE/MIC (21) (24) (10) (25) (26) (8) Speaker -40- (27) (9) Audio-video/S-Video output terminal (28) [A/V] -46- (29) ≥Use the supplied Multi cable only, otherwise audio may not be played back normally. (20) LCD monitor -12-, -64- (10) Terminal for free style remote control [REMOTE] -23- Due to limitations in LCD production Microphone terminal [MIC] technology, there may be some tiny bright or ≥A compatible plu
Summary of the content on the page No. 7
VQT0T29_ENG.book 7 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using 2 1 (38) (38) Lens hood In order to remove the lens hood, rotate it (36) counterclockwise 1. In order to fit it, put into slot 2, and then rotate it clockwise. ≥Fit the MC protector or the ND filter of the Filter (36) Tripod receptacle Kit (VW-LF37WE; optional) in front of the lens This is a hole for attaching the camera to optional hood. Do not fit the other accessories on the tripod/VW-CT45E. (Please carefully read the hood.
Summary of the content on the page No. 8
VQT0T29_ENG.book 8 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using Fitting the lens cap The one-touch free-style grip belt (VW-LF37WE; optional) ª To use as a grip belt Fit the lens cap to protect the surface of the lens. Adjust the belt length so it fits your hand. The lens cap is included in the Filter Kit 1 Adjust the belt length and the pad position. (VW-LF37WE; optional). If you do not use the movie camera when the MC protector or the ND filter of the Filter Kit (VW-LF37WE; optional) is attac
Summary of the content on the page No. 9
VQT0T29_ENG.book 9 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using 1 Connect the AC mains lead to the AC Power supply adaptor and the AC mains socket. 2 Connect the DC input lead to the AC ª Charging the battery When this product is purchased, the battery is not adaptor. 3 Connect the DC input lead to this product. charged. Charge the battery before using this product. ≥The output plug of the AC mains lead is not completely connected to the AC adaptor ≥Battery charging time (-10-) ≥We recommend
Summary of the content on the page No. 10
VQT0T29_ENG.book 10 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using ≥The recordable time will become shorter in the Charging time and recordable time following cases: The times shown in the tables below are for when ≥When you use both the viewfinder and the the temperature is 25 oC and the humidity is 60%. LCD monitor simultaneously while rotating If the temperature is higher or lower than 25 oC, the LCD monitor frontward to record yourself, the charging time will become longer. using the 0 Lu
Summary of the content on the page No. 11
VQT0T29_ENG.book 11 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using ª How to turn the power on and off with Setting date and time the LCD monitor/viewfinder When the movie camera is turned on for the first When the power switch is set to [ON], the power time, [SET DATE AND TIME] will appear. can be turned on and off with the LCD monitor and the viewfinder when the unit is in Tape Recording Mode or Card Recording Mode. 1 Open the LCD monitor out or extend the ≥Select [YES] and press the centre o
Summary of the content on the page No. 12
VQT0T29_ENG.book 12 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using WARNING Using the viewfinder THE LITHIUM BATTERY IN THIS UNIT MUST ONLY BE REPLACED BY QUALIFIED ª Extending the viewfinder PERSONNEL. IF THIS IS NECESSARY, 1 Pull out the viewfinder and extend it by CONTACT THE PANASONIC CUSTOMER pinching the extension knob. CARE CENTRE ON 132600 FOR YOUR NEAREST AUTHORIZED SERVICE CENTRE. Using the LCD monitor You can record the image while viewing it on the opened LCD monitor. 1 Place your f
Summary of the content on the page No. 13
VQT0T29_ENG.book 13 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using ª To cancel Quick Start Quick Start 1 Set [SETUP] >> [QUICK START] >> [OFF]. When quick start is ON the battery power is still (-18-) being consumed, even when the LCD monitor ≥If the [OFF/ON] switch is set to [OFF] while the and the viewfinder are closed. unit is in quick start standby, the lens cover The movie camera will resume recording/pause closes and the power turns off. mode about 1.7 seconds after the LCD monitor or ≥I
Summary of the content on the page No. 14
VQT0T29_ENG.book 14 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using ≥When inserting a previously recorded cassette, Inserting/removing a cassette use the blank search function to find the position 1 Fit the AC adaptor or the battery and turn on where you want to continue recording. If you are the power. overwriting a previously recorded cassette, be 2 Slide the [OPEN/EJECT] lever and open the sure to find the position where you want to cassette cover. continue recording. ≥When closing the cass
Summary of the content on the page No. 15
VQT0T29_ENG.book 15 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using ª Card access lamp Inserting/removing a card Before inserting/removing a card, set the [OFF/ ON] switch to [OFF]. ≥If the card is inserted or removed with the power turned on, this camera may malfunction or the data recorded on the card may be lost. 1 Turn off the power 1. ≥When the camera accesses the card (reading, 1 recording, playback, erasing, etc.), the access lamp lights up. ≥If the following operations are performed when
Summary of the content on the page No. 16
PC VQT0T29_ENG.book 16 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using ª Joystick and screen display Selecting a mode Push the centre of the joystick, and icons will be Rotate the mode dial to select the desired mode. displayed on the screen. Each time the joystick is 1 Rotate the mode dial. moved down, the indication changes. ≥Set your desired mode to 1. (In the Tape playback mode or the Card Playback Mode, the icons will be automatically displayed on 1 the screen.) 1) Tape recording mode ([AUTO
Summary of the content on the page No. 17
VQT0T29_ENG.book 17 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using 2) Tape recording mode 4) Card recording mode ([AUTO/MANUAL/FOCUS] switch is set to ([AUTO/MANUAL/FOCUS] switch is set to [MANUAL]) [AUTO]) 2 Self-timer recording -34- 3 Backlight compensation -30- 1/2 1 Help mode -18- 2 2 Soft skin mode -31- 2/2 1 Tele macro -31- 1 5) Card recording mode ([AUTO/MANUAL/FOCUS] switch is set to 2 [MANUAL]) 2 Iris or gain value -38- 5/5 3 White balance -37- 1 Shutter speed -38- 2
Summary of the content on the page No. 18
VQT0T29_ENG.book 18 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using Help mode Switching the language Select an icon for an explanation of the function. You can switch the language on the screen ≥Set to Tape/Card Recording Mode. display or the menu screen. 1 Press the joystick to display the icon during 1 Set [LANGUAGE] >> select the desired the recording pause. Move the joystick language. down until icon 1 appears. 1 Using the menu screen 2 Move the joystick right to select the Help mode icon [ ].
Summary of the content on the page No. 19
VQT0T29_ENG.book 19 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using 5 Move the joystick right or press it to set the ª Operating with remote control selection. The menu screen transition is the same as when the buttons on the main unit are used. 1 Press the [MENU] button. 6 Move the joystick up or down in order to select the item to be set. 2 Select a menu item. ≥Use the direction buttons (3, 2, 1, 4) and [ENTER] button in place of the joystick on the main unit. 7 Press the joystick to determine
Summary of the content on the page No. 20
VQT0T29_ENG.book 20 ページ ２００５年１１月２２日 火曜日 午後１１時５分 Before using ª In order to increase the brightness of Adjusting LCD monitor/viewfinder the entire LCD monitor ª Adjusting the brightness and colour 1 Press the [POWER LCD] button. level 1 Set [SETUP] >> [LCD SET] or [EVF SET] >> [YES]. POWER LCD ≥The [ ] indication appears on the LCD monitor. ≥If the [POWER LCD] button is pressed, the 2 Move the joystick up or down in order to entire LCD monitor will become approx. twice select the item to
