Danby DAC9007EE user manual

Summary of the content on the page No. 1

Summary of the content on the page No. 2

Summary of the content on the page No. 3

Introduction Thank you for choosing a Danby Designer Room Air Conditioner to cool your home. This Use and Care Manual provides information necessary for the proper care and maintenance of your new Room Air Conditioner. If properly maintained, your air conditioner will give you many years of trouble free operation. To avoid installation difficulties, read these instructions completely before installing/operating your unit. NOTE: This unit is NOT designed for through-the-wall installation. For

Summary of the content on the page No. 4

Summary of the content on the page No. 5

Summary of the content on the page No. 6

CAUTION Your unit is designed to evaporate condensation under normal conditions. However, under Because the compressor is located towards the extreme humidity conditions, excess condensation rear of the unit, this side will be heavier and more may cause basepan to overflow to the outside. awkward to manipulate. Therefore, it is The Unit should be installed where condensation recommended to have someone assist you run-off cannot drip on pedestrians or neighboring during the installation of thi

Summary of the content on the page No. 7

Slide down into guide 1. Assembly of the Upper Channel, to 3a. Completing the Installation (cont’d) Cabinet. (Factory installed on some models) • Carefully place the air conditioner into the window with the “L” shaped mounting bracket • "L" Shaped Top Channel: Install the "L" (on top) positioned in front of the upper window shaped channel to the top of the cabinet as sash. The bottom of the cabinet should be shown in Fig. 3 using four (4) 3/8" (9.5mm)screws. positioned on the “reces

Summary of the content on the page No. 8

Summary of the content on the page No. 9

Remote Control Features Electronic Electronic Display: Displays the following Display A information; A: Remote Control power On/Off and Mode Icons B C B: Clock and Auto-Timer settings 1 D C: Current set temperature 2 D: Fan speed setting 3 Control Buttons 4 5 1. Power switch. 2. Mode 7 3. Fan Speed 6 9 4. Energy Saver 8 5. Auto-Timer 11 6. Used to increase or decrease temperature 10 12 settings in 1° increments on the Celsius or Fahrenheit scale. When adjust the timer or timer To op

Summary of the content on the page No. 10

Summary of the content on the page No. 11

Troubleshooting Guide Frequently, a problem is minor and a service call may not be necessary, use this troubleshooting guide for a possible solution. If the unit continues to operate improperly, call Danby’s Toll Free Number 1-800-263-2629 for assistance, or call one of our service depots listed in the enclosed “Authorized Service Depot” listing provided with this unit. Difficulty Possible Cause Suggested Solution Air conditioner will No power to unit. Check connection of power cord to not ope

Summary of the content on the page No. 12

Summary of the content on the page No. 13