American Standard QUINCE 4433.001 user manual

Summary of the content on the page No. 1

Installation
Instructions
QUINCE™
4433.001
SINGLE CONTROL KITCHEN
FAUCET WITH CAST SPOUT
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
Certified to comply with ANSI A112.18.1M
please read these instructions carefully before you begin.
M965115_Rev.1.1
Recommended tools
Phillips Screwdriver
Regular Screwdriver Adjustable Wrench
Plumbers' Putty or Caulking
Turn off hot and cold water
INSTALL FAUCET W

Summary of the content on the page No. 2

MAKE WATER SUPPLY CONNECTIONS 2 Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply to Hot (Marked with a Red Line) 2 and right supply to Cold wall supply. Use adjustable wrench to tighten connections. 1 Do not over tighten. Faucet supplies are 21" long from faucet base. COLD Note: If additional supply length is HOT required, installer must purchase additional p

Summary of the content on the page No. 3

SERVICE 5 Reduced flow. If the flow gradually reduces over a number of months, the AERATOR (12) may have collected debris. To clean, remove AERATOR (12) and rinse with water and remove any debris. Turn on faucet to wash any debris out of the faucet. Thread AERATOR (12) back into spout. Operate faucet. Spout leakage. If fitting leaks above or below SPOUT HUB remove SPOUT as follows and check SPOUT O-RINGS. First turn off water supply. Remove HANDLE BUTTON (2) and loosen SET SCREW (1) with 2.5mm HEX