Summary of the content on the page No. 1
PC 6170
17” Pentium-M PANEL PC
User’s Manual
Summary of the content on the page No. 2
Disclaimers The information in this manual has been carefully checked and is believed to be accurate. Acnodes Co., Ltd. assumes no responsibility for any infringements of patents or other rights of third parties, which may result from its use. Acnodes assumes no responsibility for any inaccuracies that may be contained in this document. Acnodes makes no commitment to update or to keep current the information contained in this manual. Acnodes reserves the r
Summary of the content on the page No. 3
Safety Approvals ‹ CE Marking ‹ FCC Class A FCC Compliance This equipment has been tested and complies with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If not installed and used in accordance with proper instructions, this equipment might generate or radiate radio frequency e
Summary of the content on the page No. 4
Safety Precautions Before getting started, read the following important cautions. 1. The PC 6170 does not come equipped with an operating system. An operating system must be loaded first before installing any software into the computer. 2. Be sure to ground yourself to prevent static charge when installing the internal components. Use a grounding wrist strap and place all electronic components in any static-shielded devices. Most electroni
Summary of the content on the page No. 5
5. Do not open the system’s back cover. If opening the cover for maintenance is a must, only a trained technician is allowed to do so. Integrated circuits on computer boards are sensitive to static electricity. To avoid damaging chips from electrostatic discharge, observe the following precautions: 9 Before handling a board or integrated circuit, touch an unpainted portion of the system unit chassis for a few seconds. This will help to discharge any static el
Summary of the content on the page No. 6
This page does not contain any information. vi
Summary of the content on the page No. 7
Table of Contents Chapter 1 Introduction ------------------------------- 1 1.1 General Description ........................................... 1 1.2 Specifications .................................................... 2 1.3 Dimensions ........................................................ 5 1.4 Front View and I/O Outlets ................................ 6 1.4.1 Front Vi ew .............................................................. 6 1.4.2 I/O Out
Summary of the content on the page No. 8
3.2.2 Driver Installation- Wi ndows 98/2000/XP/CE.NET/XP-Embedded ...................... 27 3.2.3 Driver Installati on- DOS ......................................... 29 3.2.4 Driver Installati on- Li nux ........................................ 31 3.3 Dual LAN .......................................................... 33 Chapter 4 Embedded O.S. Installation -------- 35 4.1 Windows XP Embedded ................................... 35 4.1.1 Penmount Touch Scr
Summary of the content on the page No. 9
PC 6170 User’s Manual C h a p t e r 1 Introduction This chapter contains the general information and the detail specifications of the PC 6170. Chapter 1 includes the following sections: „ General Description „ System Specification „ Dimensions „ Front View & I/O Outlets „ Package List 1.1 General Description The PC 6170 is an ultra slim Panel PC which equipped with superior Pentium® M processor and 17"
Summary of the content on the page No. 10
PC 6170 User’s Manual a high stability and high reliable Panel PC. At the same time, with the Ultra Slim case design, customers can easily install PANEL1170-810 everywhere. Easy-to-Maintenance Design: Back Door The back panel of the PC 6170 was anchored by hand- removable fasten screws. Users can install the CPU, Memory, and HDD without using screw driver to open the main cabinet. This modular design helps to minimize system down-time for maintenance. Th
Summary of the content on the page No. 11
PC 6170 User’s Manual I/O System „ Standard I/O: − 3 x serial ports with power; 2 x RS-232, 1 x RS-232/422/485 jumper selectable − 1 x parallel port, SPP/EPP/ECP − 1 x PS/2 for Keyboard Interface − 1 x PS/2 for Mouse Interface − 3 x USB Ports 2.0 compliant(1 at rear; 2 at front panel) − 1 x 15 pin(female) for VGA output „ Ethernet: Realtek 8100C PCI Bus 10/100M Base-T Wake On LAN (via ATX power supply) Equipped with RJ-45 interface Realtek RTL8110S for 10/
Summary of the content on the page No. 12
PC 6170 User’s Manual System Specification „ 17” TFT LCD „ Disk drive housing: − 1x Build-in Slim type FDD, − 1x optional slim type CD-ROM diver, − 1 x internal 3.5” drive (or 2X 2.5” HDD) 180W AC power supply Heat dispensing design One slot for PCI expansion Net weight: − 13.5 Kgs Dimension (main body size): − 482.8 x 354.8 x 105.9 mm Operating temperature: − O° to 45°C ; Relative umidity:50% Relative humidity: − 10% to 85% @ 40° C
Summary of the content on the page No. 13
PC 6170 User’s Manual 1.3 Dimensions The following diagrams show the dimensions and outlines of PC 6170. Introduction 5
Summary of the content on the page No. 14
PC 6170 User’s Manual 1.4 Front View and I/O Outlets 1.4.1 Front View The figure below shows the features and controls on the PC 6170 front panel. 6 Introduction
Summary of the content on the page No. 15
PC 6170 User’s Manual 1.4.2 I/O Outlet The following figure shows the I/O locations of the PC 6170. Most of the I/O connectors are located on the back panel of the PC 6170. 17 9 8 5 4 3 16 12 11 13 15 14 7 6 2 1 10 1: AC inlet 10: VGA 2: Power Switch 11: USB v 2.0 3: Line-in 12: COM3 Port(for T/S) 4: Mic 13: COM1 Port 5: Line-Out 14: COM2 Port 6: Mouse 15: COM4 Port 7: Keyboar
Summary of the content on the page No. 16
PC 6170 User’s Manual 1.5 Package list When you receive the PC 6170 there are following items in the package. 1. P1170-810 x 1 2. CPU cooler x 1 3. AC power cord x 1 (U.S standard) 4. Panel mount kit x 10 5. Desktop kit x 2 6. VESA ARM kit x 1 7. Wall mount kit x 1 8. CD driver x1 8 Introduction
Summary of the content on the page No. 17
PC 6170 User’s Manual C h a p t e r 2 Hardware Installation The PC 6170 provides lots of flexible ways for you to select different configuration such as CPU, CD-ROM and more. The chapter will show you how to install the hardware. It includes: 2.1 CPU and DRAM Installation The standard PC 6170 system was designed Pentium M level CPUs. The build-in CPU board provides one 184-pin DDR DIMM socket that supports system memory up to 1GB. And, there is one
Summary of the content on the page No. 18
PC 6170 User’s Manual 2. Install the CPU, DDR DRAM and Mini-PCI card in the P-1170-810. DRAM CPU Mini-PCI 10 Hardware Installation
Summary of the content on the page No. 19
PC 6170 User’s Manual 2.2 HDD Installation The PC 6170 offers a convenient drive bay module for users to install HDD. The PC 6170 offers one 3.5” HDD drive for users to install. If you want to install two 2.5” HDDs, the PC 6170 also provides the 3.5” to 2.5” drive holder to meet your requirement. Please follow the steps: 1. Open the back door. 2. Unscrew 3 screws and remove the riser card bracket kit.
Summary of the content on the page No. 20
C 6170 User’s Manual 3. Unscrew 1 screw from the HDD drive bracket, and push the HDD bracket kit. (1) Unscrew the screw (2) Push the HDD bracket kit 4. Set the 3.5” HDD (or 2.5” HDD) in the HDD bracket kit and fix it by 4 screws around the bracket kit. 5. Installation complete. 12 Hardware Installation
