Fisher & Paykel OB76 user manual

Summary of the content on the page No. 1

Installation instructions
Aerotech oven
NZ AU
OB76 models
Important!
SAVE THESE INSTRUCTIONS
The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to our website
www.fisherpaykel.com or contact your local Fisher & Paykel dealer.
1
SAFETY AND WARNINGS
Before you install the oven, please make sure that
WARNING! WARNING!

The oven will rest on a at s

Summary of the content on the page No. 2

OB76 D models OB76 S models 2 3 PRODUCT AND CABINETRY DIMENSIONS PRODUCT AND CABINETRY DIMENSIONS Single oven models Double oven models I I I I I I C E B C E I J I J J J K B K A D A D H Proud install Flush install Proud install Flush install F 16-20 mm 16-20 mm 16-20 mm H 16-20 mm G G G F G 2.5 mm 2.5 mm 2.5 mm 2.5 mm Installation diagrams for illustration purposes only Ensure the cavity is completely sealed with no gaps Ensure the cavity is completely sealed with no gaps Product and cabinetry d

Summary of the content on the page No. 3

4 5 CABINETRY PREPARATION ELECTRICAL CONNECTION Double models featured for illustration purposes only Proud install Flush install OB76 Single Max. current draw: 19.4 A 16-20 mm 38 mm Nameplate Max. load: 4.6 kW OB76 Double Max. current draw: 38.3 A Max. load: 9.2 kW 575 mm 575 mm We recommend that the outlet for the power supply cable is located in the 613 mm right rear corner of the cabinet cavity. This allows the power supply cable to sit inside the rear chamfered corner of the oven

Summary of the content on the page No. 4

7 SECURE THE OVEN TO THE CABINETRY AND REFIT THE DOOR(S) A B Ensure supplied spacer is tted between oven 1 and cabinetry 1 1 2 1 3 1 2 4 Take care not to damage the lower trim of the oven 2 8 FLUSH INSTALLATION ONLY - REPLACE THE LOWER TRIM WITH THE SUPPLIED LONG TRIM A B Unscrew and remove the installed lower trim Replace with the supplied long trim 1 1 Ensure the clips on the long trim locate into the channels 2 Please turn over >

Summary of the content on the page No. 5

9 10 FINAL CHECKLIST TROUBLESHOOTING If the appliance is not functioning correctly after installation, check the Make sure the appliance is level and securely tted to the cabinetry and both following: oven doors open and close freely. Make sure all the internal packaging has been removed from the oven cavity. Check that the circuit breaker has not tripped or the fuse blown. Make sure all oven vents and openings are clear and are free of any Make sure that the electrical connection

Summary of the content on the page No. 6

599510A NZ AU 03.08