Summary of the content on the page No. 1
E-Series Routers
Installation and User Guide
Release 5.1.x
Juniper Networks, Inc.
1194 North Mathilda Avenue
Sunnyvale, CA 94089
USA
408-745-2000
www.juniper.net
Part No. 162-00730-00 Rev. A00
Summary of the content on the page No. 2
Juniper Networks is registered in the U.S. Patent and Trademark Office and in other countries as a trademark of Juniper Networks, Inc. Broadband Cable Processor, ERX, ESP, E-series, G1, G10, G-series, Internet Processor, J-Protect, Juniper Your Net, JUNOS, JUNOScript, JUNOSe, M5, M10, M20, M40, M40e, M160, M-series, NMC-RX, SDX, ServiceGuard, T320, T640, T-series, UMC, and Unison are trademarks of Juniper Networks, Inc. All other trademarks, service marks, registered trademarks, or register
Summary of the content on the page No. 3
Canadian Department Of Communications Radio Interference Regulations This Class B (or Class A, if so indicated on the registration label) digital apparatus meets the requirements of the Canadian Interference-Causing Equipment Regulations. Réglement sur le brouillage radioélectrique du ministère des communications Cet appareil numérique de la Classe B (ou Classe A, si ainsi indiqué sur létiquette denregistration) respecte toutes les exigences du Reglement sur le Materiel Brouilleur du Canad
Summary of the content on the page No. 4
Before installing the equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the companys inside wiring associated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above condition may not prevent
Summary of the content on the page No. 5
a SOFTWARE LICENSE AGREEMENT JUNIPER NETWORKS, INC. IS WILLING TO LICENSE THE ENCLOSED SOFTWARE AND ACCOMPANYING USER DOCUMENTATION (COLLECTIVELY, THE PROGRAM) TO YOU ONLY UPON THE CONDITION THAT YOU ACCEPT ALL OF THE TERMS AND CONDITIONS OF THIS LICENSE AGREEMENT. PLEASE READ THESE TERMS AND CONDITIONS CAREFULLY BEFORE COPYING OR USING THE ACCOMPANYING SOFTWARE OR INSTALLING THE HARDWARE UNIT WITH PRE-ENABLED SOFTWARE OR USING THE ACCOMPANYING USER DOCUMENTATION. BY USING THE ACCOMPANY
Summary of the content on the page No. 6
must return the Software, including any User Documentation, and all copies or portions thereof to Juniper Networks. Termination of this License Agreement shall not prejudice Juniper Networks' rights to damages or other available remedy. 5. Limited Software Warranty: Juniper Networks warrants, for your benefit alone, that for a period of ninety (90) days from the date of shipment from Juniper Networks that the Software substantially conforms to its published specifications. The limited warr
Summary of the content on the page No. 7
export or import regulations in other countries. You agree to comply strictly with all such regulations and acknowledge that you have the responsibility to obtain licenses to export, re-export, or import Software. 9. Government Licensees: If any Software or associated documentation is acquired by or on behalf of a unit or agency of the United States government, the government agrees that such Software or documentation is a commercial item as that term is defined in 48 C.F.R. 2.101, consi
Summary of the content on the page No. 8
Summary of the content on the page No. 9
Contents About This Guide E-Series Routers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xv Audience . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xvi Conventions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . xvi Documentation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 10
x Contents CLI Management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-15 SNMP MIB Management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-15 NMC-RX Device Management System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-16 Redundancy Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-16 SRP Modules . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 11
xi E-Series Routers Combinations of Line Modules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4 OC48 Line Modules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4 Replacing and Managing Modules Using the Software . . . . . . . . . . . . . . . . . . 5-5 Hot-Swapping Modules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5 Protecting Modules and Slots . . . . . . . . . . . . . . . .
Summary of the content on the page No. 12
xii Contents Chapter 7 Powering Up E-Series Routers Before You Power Up the System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-1 Powering Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-2 Initialization Sequence . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-3 Status LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 13
xiii E-Series Routers LED Activity During Booting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-7 Abnormal LED Activity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-7 Redundancy Status . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-9 Monitoring Temperatures of Modules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-9 Resetting Line Modules and SRP Modules .
Summary of the content on the page No. 14
xiv Contents Appendix B Installing JUNOSe Software Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-1 Identifying the Software Release File . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-2 Installing Software When a Firewall Exists . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . B-2 Task 1: Obtain the Required Information . . . . . . . . . . . . . . . . . . . . . . . . B-3 Task 2: Divert
Summary of the content on the page No. 15
About This Guide This E-Series Installation and User Guide provides the information you need to install and start the E-series router. Note: If the information in the latest E-series Release Notes differs from the information in this guide, follow the E-series Release Notes. The E-series router is shipped with the latest system software installed. If you need to install a future release or reinstall the system software, refer to the procedures in Appendix B, Installing JUNOSe Software. E-Ser
Summary of the content on the page No. 16
xvi About This Guide Audience This guide is intended for experienced system and network specialists working with E-series routers in an Internet access environment. Conventions Table 1 defines notice icons used in this guide, and Table 2 defines text conventions used throughout the book, except for command syntax. Table 3 provides command syntax conventions used primarily in the E-Series Command Reference Guide. For more information about command syntax, see E-Series System Basics Configur
Summary of the content on the page No. 17
Documentation xvii E-Series Routers Table 2 Text conventions (except for command syntax) (continued) Convention Description Examples Italics Emphasize words. There are two levels of access, user and privileged. Identify variables. clusterId, ipAddress. Identify chapter, appendix, and book names. Appendix A, System Specifications. Table 3 Syntax conventions in Command Reference Guide Convention Description Examples Words in plain text Represent keywords. terminal length Words in
Summary of the content on the page No. 18
xviii About This Guide management access, and general troubleshooting. Describes SRP modules, line modules, and I/O modules available for the E-series routers, and provides information about the compatibility of line modules and I/O modules with software releases. Lists the layer 2 protocols, layer 3 protocols, and applications that line modules and their corresponding I/O modules support. • E-Series System Basics Configuration Guide – Describes planning and configuring your network, manag
Summary of the content on the page No. 19
Comments About the Documentation xix E-Series Routers MIBS Copies of the MIBs available in a software release are included on the JUNOSe Software CD (formerly ERX Edge Routers Software CD) and on the Web. Release Notes Release notes are included on the corresponding software CD and are available on the Web. In the Release Notes, you will find the latest information about features, changes, known problems, resolved problems, and system maximum values. If the information in the Release Notes
Summary of the content on the page No. 20
xx About This Guide Contacting Customer Support For technical support, contact Juniper Networks at support@juniper.net, or at 1-888-314-JTAC (within the United States) or 408-745-9500 (from outside the United States).
