Summary of the content on the page No. 1
802.11g Wireless
ADSL 2/2+ Router
ADW-4401 A/B
User's Manual
Summary of the content on the page No. 2
Copyright Copyright © 2006 by PLANET Technology Corp. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of PLANET. PLANET makes no representations or warranties, either expressed or implied, with respect to the contents her
Summary of the content on the page No. 3
FCC Caution: To assure continued compliance (example-use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the Following two conditions: (1) This device may not cause harmful interference, and (2) this Device must accept any interfer
Summary of the content on the page No. 4
Safety This equipment is designed with the utmost care for the safety of those who install and use it. However, special attention must be paid to the dangers of electric shock and static electricity when working with electrical equipment. All guidelines of this and of the computer manufacture must therefore be allowed at all times to ensure the safe use of the equipment. Revision User’s Manual for 802.11g Wireless ADSL 2/2+ Router Model: ADW-4401 A/B Rev: 1.0 (Dec. 2005) Part No. EM-
Summary of the content on the page No. 5
Table of Contents 1. INTRODUCTION .....................................................................................................7 1.1 FEATURE...........................................................................................................7 1.2 PACKAGE CONTENTS....................................................................................9 1.3 PHYSICAL DETAILS .......................................................................................9 2. INSTALLATI
Summary of the content on the page No. 6
3.9.4 ADSL Type Setting ...............................................................................32 3.10.1 Static Routing ......................................................................................32 3.10.2 Dynamic Routing.................................................................................33 3.10.3 Routing Table ......................................................................................34 3.11.1 System Status...........................................
Summary of the content on the page No. 7
1. Introduction The PLANET 802.11g Wireless ADSL 2/2+ Router, ADW-4401, provides office and residential users the ideal solution for sharing a high-speed ADSL 2/2+ broadband Internet connection on a 54Mbps wireless network and a 10/100Mbps Fast Ethernet backbone. It can support downstream transmission rates of up to 24Mbps and upstream transmission rates of up to 3.5Mbps. The product supports PPPoA (RFC 2364 - PPP over ATM Adaptation Layer 5), RFC 2684 encapsulation over ATM (bridged or r
Summary of the content on the page No. 8
Fixed or Dynamic IP Address. On the Internet (WAN port) connection, the ADW-4401 supports both Dynamic IP Address (IP Address is allocated on connection) and Fixed IP Address. Advanced Internet Functions Virtual Servers. This feature allows Internet users to access Internet servers on your LAN. The required setup is quick and easy. Firewall. Supports simple firewall with NAT technology and provides option for blocking access from Internet, like Web, FTP, Telnet, SNMP, ICMP. Univer
Summary of the content on the page No. 9
4-Port Switch. The ADW-4401 incorporates a 4-port 10/100Base-TX switching hub, making it easy to create or extend your LAN. DHCP Server Support. Dynamic Host Configuration Protocol provides a dynamic IP address to PCs and other devices upon request. The ADW-4401 can act as a DHCP Server for devices on your local LAN and WLAN. 1.2 Package Contents ‧ ADW-4401 Unit ‧ Power Adapter ‧ Quick Installation Guide ‧ User’s Manual CD ‧ RJ-11 (ADSL) cable ‧ RJ-45 cable 1.3 Physical Detai
Summary of the content on the page No. 10
WLAN Flashing When wireless AP is ready ON Link Flashing TX or RX activity LAN No Link These four LAN (Local Area Network) ports are where you 1-4 OFF will connect networked devices, such as PCs, print servers remote hard drives, and anything else you want to put on your network Rear Panel Rear panel Port and Button Definition Connector Description POWER Power connector with 9V DC 1.5 A Reset The reset button, the router restore the default settings when press this Switch
Summary of the content on the page No. 11
2. Installation This chapter offers information about installing your router. If you are not familiar with the hardware or software parameters presented here, please consult your service provider for the values needed. 2.1 System Requirement 1. Personal computer (PC) 2. Pentium II 233 MHz processor minimum 3. 32 MB RAM minimum 4. 20 MB of free disk space minimum 2.2 Hardware Installation This section describes how to connect and configure the ADW-4401. Power To PC / To ADS
Summary of the content on the page No. 12
Step 3. Connect the Power Adapter to the Router Connect the power adapter to the port labeled POWER on the rear panel of router. Step 4. Connect All Cables to the Network The procedure for connecting cables differs depending on whether or not your telephone equipment is connected to a POTS splitter. 12
Summary of the content on the page No. 13
3 Configuration 3.1 Determine your connection settings Before you configure the router, you need to know the connection information supplied by your ADSL service provider. 3.2 Connecting the ADSL Router to your network Unlike a simple hub or switch, the setup of the ADSL Router consists of more than simply plugging everything together. Because the Router acts as a DHCP server, you will have to set some values within the Router, and also configure your networked PCs to accept the IP Add
Summary of the content on the page No. 14
3.3.1 Quick Setup Guide You can use "Quick Setup" to setup the router as follows, and the router will connect to the Internet via ADSL line. 14
Summary of the content on the page No. 15
Click "Quick Start" to get into the quick setup procedures. Click "RUN WIZARD" to start up this procedure. Step 1 - Click "Next" to setup your new administrator's password. 15
Summary of the content on the page No. 16
Step 2 - Click "Next" to setup your time zone. Step 3 - Click "Next" to setup your Internet connection type. You can have this information from your Internet Service Provider. 16
Summary of the content on the page No. 17
Enter the connection information provided by your ISP. 17
Summary of the content on the page No. 18
3.3.2 System Time Go to Maintenance->Time Zone and select system time as you wish. 18
Summary of the content on the page No. 19
Connecting to a Simple Network Time Protocol (SNTP) server allows the router to synchronize the system clock to the global Internet. The synchronized clock in the router is used to record the security log and control client filtering. 3.3.3 Admin Setting Go to Maintenance-> Administration to set a new user's name and password to restrict management access to the router. The default is admin (User's name) and admin (Password)
Summary of the content on the page No. 20
3.3.4 Firmware Update Go to Maintenance -> Firmware to upgrade the firmware. The new firmware for your router can improve functionality and performance. Enter the path and name of the upgrade file then click the UPGRADE button below. You will be prompted to confirm the upgrade. 3.3.5 System Log Go to Status -> System Log and you can see the system log file. Click “Save Log” to save system log file.
