Summary of the content on the page No. 1
Models 2603, 2621, and 2635
IPLink Series High Speed Routers
Getting Started Guide
Sales Office: +1 (301) 975-1000
Technical Support: +1 (301) 975-1007
E-mail: support@patton.com
WWW: www.patton.com
Document Number: 03328U1-001 Rev. A
Part Number: 07M2600Ser-GS
Revised: March 24, 2006
Summary of the content on the page No. 2
Patton Electronics Company, Inc. 7622 Rickenbacker Drive Gaithersburg, MD 20879 USA Tel: +1 (301) 975-1000 Fax: +1 (301) 869-9293 Support: +1 (301) 975-1007 Web: www.patton.com E-mail: support@patton.com Copyright © 2003–2006, Patton Electronics Company. All rights reserved. The information in this document is subject to change without notice. Patton Elec- tronics assumes no liability for errors that may appear in this document. Warranty Information The software described in this
Summary of the content on the page No. 3
Summary Table of Contents 1 General Information...................................................................................................................................... 17 2 Product Overview.......................................................................................................................................... 24 3 Initial Configuration................................................................................................................................
Summary of the content on the page No. 4
Contents Summary Table of Contents ......................................................................................................................... 3 Contents ......................................................................................................................................................... 4 List of Figures ............................................................................................................................................... 10 Li
Summary of the content on the page No. 5
Contents Models 2603, 2621, and 2635 Getting Started Guide Installing an interface cable on the IPLink 2635’s V.35 interface port .......................................................33 Installing the AC power cord ..........................................................................................................................34 Installing the Ethernet cable .....................................................................................................................
Summary of the content on the page No. 6
Models 2603, 2621, and 2635 Getting Started Guide Contents Remote Site Configuration .................................................................................................................63 Central site configuration ...................................................................................................................66 7 Security .................................................................................................................................
Summary of the content on the page No. 7
Contents Models 2603, 2621, and 2635 Getting Started Guide Website Settings ..................................................................................................................................................101 Error Log.............................................................................................................................................................102 SNMP Daemon ............................................................................
Summary of the content on the page No. 8
Models 2603, 2621, and 2635 Getting Started Guide Contents Sync Serial Interface ............................................................................................................................................119 T1/E1 Interface ...................................................................................................................................................119 Protocol Support ...............................................................................
Summary of the content on the page No. 9
Contents Models 2603, 2621, and 2635 Getting Started Guide 9
Summary of the content on the page No. 10
List of Figures 1 IPLink Series Router (Model 2635 shown) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 2 Sync Serial Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 3 T1/E1 Application . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26 4 Re
Summary of the content on the page No. 11
Models 2603, 2621, and 2635 Getting Started Guide 48 New Policy link to configuration webpage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 73 49 Deleting a Security Policy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74 50 Defining ICMP port filter for ping . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 12
List of Tables 1 General conventions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 2 Status LED descriptions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 3 LMI Implementation on the IPLink . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 58 4 Fe
Summary of the content on the page No. 13
About this guide This guide describes installing and configuring Patton Electronics IPLink Series High Speed Routers. The instructions in this guide are based on the following assumptions: • The router may connect to a serial DTE device or T1/E1 line • There is a LAN connected to the Ethernet port of the router Audience This guide is intended for the following users: • Operators • Installers • Maintenance technicians Structure This guide contains the following chapters and appendices:
Summary of the content on the page No. 14
Models 2603, 2621, and 2635 Getting Started Guide About this guide Precautions Notes, cautions, and warnings, which have the following meanings, are used throughout this guide to help you become aware of potential problems. Warnings are intended to prevent safety hazards that could result in per- sonal injury. Cautions are intended to prevent situations that could result in property damage or impaired functioning. Note A note presents additional information or interesting sidel
Summary of the content on the page No. 15
Models 2603, 2621, and 2635 Getting Started Guide About this guide For AC powered units, ensure that the power cable used with the device meets all applicable standards for the country in which it is to be installed, and that it is connected to a wall outlet which has earth ground. WARNING For units with an external power adapter, the adapter shall be a listed Lim- ited Power Source. WARNING Hazardous network voltages are present in WAN ports regardless of whether power to the unit
Summary of the content on the page No. 16
Models 2603, 2621, and 2635 Getting Started Guide About this guide • Model 2603/T—T1 configuration. RJ-48C (100-ohm) interface • Model 2603/K—E1 configuration. RJ-48C (120-ohm) and dual-BNC interface (75-ohm) Typographical conventions used in this document This section describes the typographical conventions and terms used in this guide. General conventions The procedures described in this manual use the following text conventions: Table 1. General conventions Conventi
Summary of the content on the page No. 17
Chapter 1 General Information Chapter contents IPLink Series High Speed Routers overview ..........................................................................................................18 General attributes ............................................................................................................................................18 Ethernet .............................................................................................................................
Summary of the content on the page No. 18
Models 2603, 2621, and 2635 Getting Started Guide 1 • General Information IPLink Series High Speed Routers overview The IPLink Series of gateway routers/bridges combine full set of high-speed IP routing features and WAN access via PPP/IP/FR protocols. All IPLink routers come with an auto-sensing full-duplex 10/100Base-T Ethernet port, MDI-X cross-over switch, console port, and internal or external power supply. There are three versions in the IPLink series corresponding
Summary of the content on the page No. 19
Models 2603, 2621, and 2635 Getting Started Guide 1 • General Information Ethernet • Auto-sensing full-duplex 10Base-T/100Base-TX Ethernet. • Standard RJ-45 connector • Built-in MDI-X cross-over switch. • IEEE 802.1d transparent learning bridge • 2 IP address/subnets on Ethernet interface. Protocol support • Complete internetworking with IP (RFC 741), TCP (RFC 793), UDP (RFC 768), ICMP (RFC 950), ARP (RFC 826). • IP router with RIP (RFC 1058), RIPv2 (RFC 2453) • Up to 64 static routes. • Buil
Summary of the content on the page No. 20
Models 2603, 2621, and 2635 Getting Started Guide 1 • General Information • Logging via SYSLOG, and VT-100 console. Console port set at 9600 bps 8/N/1 settings no flow control. Security • Packet filtering firewall for controlled access to and from LAN/WAN. Support for 255 rules in 32 filter sets. 16 individual connection profiles. • DoS Detection/protection. Intrusion detection, Logging of session, blocking and intrusion events and Real- Time alerts. Logging or SMTP on event. • Password protected sy
