TP-Link TL-PA250 user manual

User manual for the device TP-Link TL-PA250

Device: TP-Link TL-PA250
Category: Network Card
Manufacturer: TP-Link
Size: 0.94 MB
Added : 1/3/2014
Number of pages: 29
Print the manual

Download

How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for TP-Link TL-PA250. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with TP-Link TL-PA250.

For your convenience

If looking through the TP-Link TL-PA250 user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manual TP-Link TL-PA250 on full screen, use the button Fullscreen.
  • Downloading to your computer - You can also download the user manual TP-Link TL-PA250 to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
TP-Link TL-PA250 User manual - Online PDF
Advertisement
« Page 1 of 29 »
Advertisement
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual TP-Link TL-PA250 but the selected pages only. paper.

Summaries

Below you will find previews of the content of the user manuals presented on the following pages to TP-Link TL-PA250. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1


TL-PA250
AV200+ Powerline Adapter with AC Pass Through


Rev: 1.0.0
1910010540

Summary of the content on the page No. 2

COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2011 TP-LINK TECHNOLOGIES CO.,

Summary of the content on the page No. 3

FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarante

Summary of the content on the page No. 4

Important Safety Instructions 1. Do not open this product or attempt to service it; it may expose you to dangerous high voltage or other risks. 2. Do not operate this product near water. 3. Do not place or operate this product near a radiator or a heat register. 4. Do not expose this product to dampness, dust or corrosive liquids. 5. Do not connect this product or disconnect it from a wall socket during a lightning or a thunderstorm 6. Do not block the ventilation slots of this product,

Summary of the content on the page No. 5

CONTENTS Chapter 1 Introduction ..................................................................................................... 1 1.1 LED Indicator ................................................................................................................ 2 1.2 Physical Interface ......................................................................................................... 3 Chapter 2 Connecting Mechanism ...............................................................

Summary of the content on the page No. 6

TL-PA250 AV200+ Powerline Adapter with AC Pass Through Chapter 1 Introduction Congratulations on your purchase of this outstanding Powerline Adapter. This device is an AV200+ Powerline Adapter with AC Pass Through which transforms your house’s existing electrical wiring into a ubiquitous networking infrastructure. Simply plug thisAV200+ Powerline Adapter with AC Pass Through into an ordinary AC power outlet which will easily extend your Cable/xDSL broadband connection or existing Ethern

Summary of the content on the page No. 7

TL-PA250 AV200+ Powerline Adapter with AC Pass Through 1.1 LED Indicator The LED indicator displays information about the device’s status. Item Status Indication Solid The adapter is on. Blinking The adapter is in power-saving mode. Power LED Off The adapter is off. Solid The adapter is connecting to a Powerline network. Blinking The adapter is sending or receiving data. Powerline LED The adapter has not connected to Powerline network or Off is in power-saving mode. The Ether

Summary of the content on the page No. 8

TL-PA250 AV200+ Powerline Adapter with AC Pass Through 1.2 Physical Interface There are four physical interfaces on this Mini Powerline Adapter. Integrated Electrical Socket Power Plug Ethernet Port Pair Button Interface Description It is a 10/100Mbps Ethernet port on the AV adapter for connecting it Ethernet Port to the PC or the broadband device with the network cable. Power Plug* A Power Plug connected to any 100V ~ 240V AC power socket After you plug in your new AV ada

Summary of the content on the page No. 9

TL-PA250 AV200+ Powerline Adapter with AC Pass Through Chapter 2 Connecting Mechanism 2.1 Introduction The Powerline Adapter supports up to 200Mbps data rate. With this high speed connection rate, this Powerline Adapter allows you to setup a high speed home network by using your home existing electrical wiring. Simply plug this Powerline Adapter into an ordinary power outlet to extend your Cable/xDSL broadband connection or existing LAN network to any other electrical outlet in any room

Summary of the content on the page No. 10

TL-PA250 AV200+ Powerline Adapter with AC Pass Through 2.3 Hardware Connection – Computer For those computers you wish to be networked by Powerline Adapter, each of the computers must be properly connected with a Powerline Adapter through an Ethernet (RJ-45) cable. Following are the steps to properly connect the Powerline Adapter to your computer: 1 . Connect one end of the provided Ethernet (RJ-45) cable to the Powerline Adapter’s Ethernet port. 2 . Connect the other end of the Ethernet

Summary of the content on the page No. 11

TL-PA250 AV200+ Powerline Adapter with AC Pass Through Note: Where the MAINS plug or an appliance coupler is used as the disconnected device, the disconnect device shall remain readily operable. The idle wall sockets or electrical outlets in your household electrical circuit can be used normally without interference from the network. 6

Summary of the content on the page No. 12

TL-PA250 AV200+ Powerline Adapter with AC Pass Through Chapter 3 Installing Management Utility Please verify that no other Powerline Adapter or any Encryption Management Utilities are installed before installing the provided software. If other Powerline Utilities are installed, uninstall them and restart your personal computer before installing this provided software. Note: Please make sure that you have installed the WinPcap (the version of which should be beyond 4.1.1 inclusive) o

Summary of the content on the page No. 13

TL-PA250 AV200+ Powerline Adapter with AC Pass Through 8

Summary of the content on the page No. 14

TL-PA250 AV200+ Powerline Adapter with AC Pass Through 9

Summary of the content on the page No. 15

TL-PA250 AV200+ Powerline Adapter with AC Pass Through Step 3: After the installation, a shortcut to the “TL-PA250 Powerline Utility” application icon is provided on the windows desktop. 10

Summary of the content on the page No. 16

TL-PA250 AV200+ Powerline Adapter with AC Pass Through Chapter 4 Using the Management Utility After you’d successfully installed the Powerline Adapter hardware and Management Utility software, you can set up or configure the devices according to your need. This Powerline Adapter Configuration Utility enables the users to identify powerline devices on the powerline network, measure data rate performance, ensure privacy and perform diagnostics by setting user-defined secure powerline net

Summary of the content on the page No. 17

TL-PA250 AV200+ Powerline Adapter with AC Pass Through Local Device(s) on your computer: This shows all local Powerline Ethernet Adapter found connected to the computer’s LAN card. In most cases, only one device will display in this panel. Click and select the local device shown on the screen then click “Connect” tab to manage the Powerline Ethernet Adapter. The status message shown above the “Connect” button indicates that your PC is connected to the same device. Once the chosen Power

Summary of the content on the page No. 18

TL-PA250 AV200+ Powerline Adapter with AC Pass Through Note: The parameter information of PIB will restore to the factory defaults after resetting the Powerline Adapter. To upgrade the device's firmware, follow these instructions: 1. Download PIB file and firmware upgrade file from TP-LINK website (http://www.tp-link.com). 2. Enter the path name or click Browse… to select the downloaded files on the computer into the corresponding blanks. 3. Click the OK button. Note: Do not turn

Summary of the content on the page No. 19

TL-PA250 AV200+ Powerline Adapter with AC Pass Through 4.1.2 Enter Password Enter the password of the remote Powerline Adapters, and then you can set the network name of these devices on Privacy configuration homepage. The password can be found on the back of the device. Select the Powerline Adapter from the list, click the Enter Password button and then the following screen will display. Enter your Password (Take note of the password format) and click “OK” after setup. 14

Summary of the content on the page No. 20

TL-PA250 AV200+ Powerline Adapter with AC Pass Through Note: The Powerline Adapter device must be present on the power line (plugged in) in order for the password to be confirmed and added to the network. If the Powerline Adapter device could not be located, a warning message will be shown. 4.1.3 Add Device The following dialog box will pop up when clicking the “Add” button under the Main configuration homepage. The dialog box allows you to enter both the selected device’s name and pa


Alternative user manuals
# User manual Category Download
1 TP-Link 200Mbps Powerline Ethernet Adapter TL-PA201 User manual Network Card 2094
2 TP-Link MC112CS User manual Network Card 124
3 TP-Link TF-3239D User manual Network Card 8
4 TP-Link TF-3200 User manual Network Card 39
5 TP-Link MC111CS User manual Network Card 62
6 TP-Link MC100CM User manual Network Card 112
7 TP-Link TG-3468 User manual Network Card 34
8 TP-Link 54Mbps Wireless Access Point TL-WA501G User manual Network Card 123
9 TP-Link High-Power Wireless USB Adapter TL-WN422G User manual Network Card 25
10 TP-Link TG-3269 User manual Network Card 20
11 TP-Link TF-3239DL User manual Network Card 11
12 TP-Link MC110CS User manual Network Card 37
13 TP-Link TL-POE200 User manual Network Card 15
14 TP-Link TL-WA5110G User manual Network Card 165
15 TP-Link TL-WN321G User manual Network Card 155
16 Sony BTA-NW1A User manual Network Card 2
17 Sony BKMW-E3000 User manual Network Card 2
18 Sony AC-SQ950D User manual Network Card 0
19 Sony BBV RX100 User manual Network Card 3
20 Sony CLIE A-AVZ-100-11 User manual Network Card 1