Tascam AVIOM PRO16 DM-4800 user manual

Summary of the content on the page No. 1

IF-AV/DM
Aviom Pro16 A-Net Interface Card
Introduction DM-3200/DM-4800 requirements
Thank you for purchasing the TASCAM IF-AV/DM In order to use the IF-AV/DM card, the DM-4800/DM-3200
Aviom Pro16 A-Net Interface Card. This card allows your must use software version 1.70 or later. The mixer cannot
TASCAM Digital Mixer to feed monitor audio to any recognize the IF-AV/DM card when using earlier versions.
number of Aviom Pro16 A-Net devices such as the A-16II
Check the TASCAM website (http://www.

Summary of the content on the page No. 2

IF-AV/DM Aviom Pro16 A-Net Interface Card A-16D Pro A-Net Distributor • AV-P2 Output Module • Connecting Pro16 devices With the IF-AV/DM card properly installed and configured, you can now connect Pro16 monitoring and audio networking devices. Connecting a Cat-5e cable from the A-Net output of the IF-AV/DM card to the A-Net In on the first Pro16 devices starts an A-Net distribution network. No configuration is required for the Aviom devices. Pro16 A-Net allows both serial (daisy chain) an

Summary of the content on the page No. 3

IF-AV/DM Aviom Pro16 A-Net Interface Card The IF-AV/DM is connected to one or more A-Net NOTE receivers. Using the A-Net out connector of, e.g. a A-16II Personal Mixer to extend the signal does not supply power to the xxx Timeouts: • additional units, which must be powered individually. A problem was encountered. For long distance applications, fiber optic cable can be STEREO LINK ª used to span distances up to 50 miles (80 km) with the Use the up and down arrows and then the ENTER button

Summary of the content on the page No. 4

IF-AV/DM Aviom Pro16 A-Net Interface Card of channels, they must be linked using the Mixer Control screen described earlier. Only adjacent Channels can be linked (Channels 1 and 2, Channels 3 and 4, etc.). When Channels are linked, they act as one source on the Aviom Personal Mixer. When you select either of the two linked Channels on the Mixer, both LEDs will light up, indicating that they are linked. Volume changes affect both Channels simultaneously. Channels that are linked from the D