Summary of the content on the page No. 1
EZ Modem SMC3056EM
External Data/Fax/Voice Modem
User Guide
1 Claymore Drive #08-05/06
Orchard Tower (Rear Blk) Singapore 229594 October 200 2
Phone:+65 62386556 Revision Number:R0 1
1
Summary of the content on the page No. 2
FCC Requirements This equipment complies with Part 68 of the FCC Rules. On the bottom of this equipment is a label that contains, among other information, the FCC Registration Number and Ringer Equivalence Number (REN) for this equipment. IF REQUESTED. THIS INFORMATION MUST BE GIVEN TO THE TELEPHONE COMPANY. The REN is useful to determine the quantity of devices you may connect to your telephone line and still have these entire devices ring when your telephone number is called In m
Summary of the content on the page No. 3
Notices to Australian users: The modem card must only be used in a data terminal equipment (DTE) e.g. computer, that has a screw down cover (lid). As unsafe voltages (TNV) exist on the modem card, disconnect the modem card from the telephone line while the cover (lid) of the DTE (computer) is removed. Installation of the modem card in a DTE (computer) which does not require a tool to open the cover (lid) will render the permit void. Disconnect the telephone line before opening th
Summary of the content on the page No. 4
CONTENTS Chapter 1 Introduction...........................................................................7 1.1 Introduction ................................................................................................. 7 1.2 Features ....................................................................................................... 7 Chapter 2 The Appearance of EZ Modem External ..............................8 2.1 EZ Modem External Front Panel...............................
Summary of the content on the page No. 5
SMC’s Limited Warranty Limited Warranty Statement: SMC Networks, Inc. ("SMC") warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All SMC products carry a standard 90-day limited warranty from the date of purchase from SMC or its Authorized Reseller. SMC may, at its own discretion, repair or replace any product not operating as warranted with a similar or functionally equivalent product,
Summary of the content on the page No. 6
IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SMC NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE OR USE OF ITS PRODUCTS.SMC SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THE ALLEGED DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER
Summary of the content on the page No. 7
Chapter 1 Introduction 1.1 Introduction Congratulations on purchasing a state-of-the-art EZ Modem! Your EZ Modem incorporates the latest technological advancement for you to electronically communicate with other computers, information networks, fax machines or other Modems. It embraces most of the industry and commercially popular standards to ensure compatibility with most equipment and application programs. The voice capability renders a wide range of application possibilities
Summary of the content on the page No. 8
Chapter 2 The Appearance of EZ Modem External 2.1 EZ Modem External Front Panel 8
Summary of the content on the page No. 9
2.2 EZ Modem External Back Panel PHONE Telephone RJ-11 jack LINE Line RJ-11 jack RS-232 Serial DB-9 female connector MIC Microphone mini-phone jack SPK Speaker mini-phone jack AC AC jack Power Switch Power on/off 9
Summary of the content on the page No. 10
Installing The EZ Modem Chapter 3 3.1 Checking Your Components Unpack your EZ Modem and make sure you have the following items: 1. The EZ Modem 2. A modular telephone cable to connect your EZ Modem to the telephone line 3. Communication software (included driver and manual) When you open your package, make sure all of the above items are included and not damaged. If you see that any components are damaged, please notify your dealer immediately. 3.2 What Else You Need
Summary of the content on the page No. 11
on the wall outlet, as you would any modular telephone. 3.4 Connecting To Your Telephone Set Your EZ Modem also conveniently provides a second modular jack that lets you connect your telephone to the same telephone line that the EZ Modem is using. This lets you manually dial data calls or make voice calls when you are not using your EZ Modem. Also if you do not have speakerphone and microphone, handset of telephone set can function as an input/output device for voice to verify the
Summary of the content on the page No. 12
3.5 Verifying Your Connection Start a communication program and place the computer into terminal mode. Refer to your computer manual to find out the appropriate command to do so. Then use the following procedure to verify your installation: 1. Type AT[Enter] If your system is operating properly, your EZ Modem sends an OK response to your screen and waits for your next command. 2. Use your communication software to prepare your computer to dial a call. Then type A
Summary of the content on the page No. 13
3.6 Connecting Microphone And Speaker You could either use a handset connected to the EZ Modem, or connect a microphone and a speaker for voice recording and playback. NOTE: Any commercially available microphone is usable. For the speaker, any 8 ohm speaker rated around 1Watt can be driven directly by the audio output. An amplifier is required if you need a higher output volume. 1. Connect the microphone to the mini-phone jack marked MIC. 2. Connect the speaker to the mini-
Summary of the content on the page No. 14
Chapter 4 Software Installation Configuring External Modem With Windows 98/ME/2000/NT4.0/XP 4.1 Windows 98 1. Restart the computer after connecting the modem to PC .When Windows detects the modem ,the message “This wizard searches for new drives for:” “Analog Modem” is displayed. Click Next. 2. Select “Search for the best driver for your device, [Recommended].” and click Next. 14
Summary of the content on the page No. 15
3. Select “CD-ROM drive” ,then select “Specify a location:” and type F:\SMC 3056EM (F is the letter of CD-ROM drive ) and click Next to continue. 4. Windows will find the driver for SMC EZ Modem External Data Fax Voice Modem and click Next. 5. Click OK. 15
Summary of the content on the page No. 16
6. Click Finish to end this installation procedure. . 16
Summary of the content on the page No. 17
4.2 Windows ME 1. The message of Analog Modem will appear. Select “Specify the location of the driver [Advanced]” and click Next. 2. Select “Search for the best driver for your device [Recommended]”, then select Specify a location and type F:\SMC3056EM (F is the letter of CD-ROM drive ) and click Next to continue. 17
Summary of the content on the page No. 18
3. Windows will find the driver for a SMC EZ Modem External Data Fax Voice Modem nd click Next. 4. Click Finish to end this installation procedure. 18
Summary of the content on the page No. 19
4.3 Windows NT 1. Double click “Modems” form Start → → → →Setting → → → →Control Panel. 2. Check “Don’t detect my modem; I will select it from a list “ and then click Next. 3. Click Have Disk. 19
Summary of the content on the page No. 20
4. Indicating the path: F:\SMC3056EM and then click OK. 5. Select the model of your modem and then click Next. 6. Select the COM port that you connect modem to your PC and click Next. 20
