Omnitron Systems Technology miConverter GX/T user manual

Summary of the content on the page No. 1

OVERVIEW NOTE: Using the advanced features listed above
Slot 1 (odd) Slot 2 (even) Slot 3 (odd)
requires the use of the Network Management Module Chassis
“A” Link “B” Link
The iConverter GX/T provides 10/100/1000BASE-T UTP
™ Backplane
(NMM) and the NetOutlook Management Software
® to 1000BASE-X Fiber conversion as well as rate
iConverter GX/T User Manual
(or third-party SNMP management software) or Telnet.
A Port B Port A Port B Port A Port B Port
conversion between 10BASE-T, 100BASE-TX,
1000BAS

Summary of the content on the page No. 2

BOARD MOUNTED DIP-SWITCHES NOTE: When the fiber port is in Manual Mode, UTP 10/100 P2 “10/100” DIP-Switch NOTE: Setting the “10-100/1000” DIP-Switch to the sometimes a link-up will not occur with other devices. “1000” position when in Manual mode is not permitted ON When the UTP P2 Auto/Manual DIP-Switch is in the Off = Backplane “A” Enabled Both devices must be set to the same mode (either (per the IEEE 802.3 standard) and will result in BPAEN Auto-Negotiate “AN” position and the “10-100/1000