Summary of the content on the page No. 1
USER'S GUIDE
OkiLAN 7300e
Summary of the content on the page No. 2
PR PRE EF FA AC CE E PR PRE EF FA AC CE E Every effort has been made to ensure that the information in this document is complete, accurate, and up-to-date. Oki assumes no responsibility for the results of errors beyond its control. Oki also cannot guarantee that changes in software and equipment made by other manufacturers and referred to in this guide will not affect the applicability of the information in it. Mention of software products manufactured by other companies does not necessari
Summary of the content on the page No. 3
Preface 2
Summary of the content on the page No. 4
T TA ABLE O BLE OF F C CO ONT NTENT ENTS S T TA ABLE O BLE OF F C CO ONT NTENT ENTS S Preface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 EEC Compatibility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Intr
Summary of the content on the page No. 5
Management utility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75 System requirement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76 Windows . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76 Supported Browsers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 77 Supported Printers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 77 Supported network interface cards . . . . . . . . . . . . . . . . . 78 I
Summary of the content on the page No. 6
Windows XP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 99 Printer driver configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 Novell NetWare. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 103 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 103 Supported Versions and Modes. . . . . . . . . . . . . . . . . . . . . . 103 Remote Printer Mode . . . . . . . . . .
Summary of the content on the page No. 7
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 135 Self-diagnostic test . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 135 TCP/IP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 136 NetWare. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 137 Remote Server mode . . . . . . . . . . . . . . . . . . . . . . . . . . . 137 Print Server mode . . . . . .
Summary of the content on the page No. 8
CONFIGURATION Introduction The OkiLAN 7300e is a fast 100BASE-TX/10BASE-T network interface card for the OKI C7100, C7200, C7300, C7400, C7500, C9200, C9300, C9400 and C9500 printers. This network interface card supports IEEE802.2, IEEE802.3, Ethernet- II and SNAP and can detect those frame types automatically. Also, the interface card supports major protocols such as TCP/IP, IPX/ SPX (NetWare), EtherTalk and NetBEUI. This section details the OkiLAN 7300e specification and several software utili
Summary of the content on the page No. 9
Specification CPU Falcon Memory Flash ROM: 2 Mbyte RAM: 1 Mbyte Frame types IEEE 802.2 IEEE 802.3 Ethernet-II, SNAP, AUTO Network interface 100BASE-TX 10BASE-T Network protocols TCP/IP Network layer ARP, RARP, IP, ICMP Session layer TCP, UDP Application layer LPR, FTP, TELNET, HTTP, IPP, BOOTP, DHCP, SNMP, DNS, SMTP, POP3 IPX/SPX (NetWare) Remote printer mode (up to eight file servers and 32 queues) Print server mode (up to eight print servers) Encrypted password supported in print server mode
Summary of the content on the page No. 10
Self-diagnostic test With the printer power switched on, press the push-button for more than three seconds and release. The self-diagnostic test results and configuration settings are printed. Printed self-diagnostic test sample EthernetBoard OkiLAN 7300e Version 1.1.0 *** Diagnostic report *** ROM check: Ok stat:7C31 FFFF 0000 0000 RAM check: Ok stat:0000 0000 0000 0000 EEPROM Check: Ok stat:8954 8954 0000 0000 NIC check: Ok addr:00:80:92:00:13 9D 100BASET-TX DIPSW1:OFF(ON:Test use only DIPSW2:
Summary of the content on the page No. 11
NetWare mode:PSERVER FSERVER name 1:““ FSERVER name 2:““ FSERVER name 3:““ FSERVER name 4:““ FSERVER name 5:““ FSERVER name 6:““ FSERVER name 7:““ FSERVER name 8:““ Machine name:“OL000139D“ Password:““ Job polling interval:““ Bindery mode:ENABLE NDS context:““ NDS tree:““ FSERVER name 1:““ FSERVER name 2:““ FSERVER name 3:““ FSERVER name 4:““ FSERVER name 5:““ FSERVER name 6:““ FSERVER name 7:““ FSERVER name 8:““ Job timeout:10 EtherTalk protocol:ENABLE Zone name:“*” NetBEUI protocol:ENABLE Comp
Summary of the content on the page No. 12
Printer Error trap:DISABLE TCP#1 Trap address:0.0.0.0 TCP#2 Trap enable:DISABLE On-line trap:DISABLE Off-line trap:DISABLE Paper Out trap:DISABLE Paper Jam trap:DISABLE Cover Open trap:DISABLE Printer Error trap:DISABLE TCP#2 Trap address:0.0.0.0 TCP#3 Trap enable:DISABLE On-line trap:DISABLE Off-line trap:DISABLE Paper Out trap:DISABLE Paper Jam trap:DISABLE Cover Open trap:DISABLE Printer Error trap:DISABLE TCP#3 Trap address:0.0.0.0 TCP#4 Trap enable:DISABLE On-line trap:DISABLE Off-line trap
Summary of the content on the page No. 13
Reply-To address:““ Signature line 1:““ Signature line 2:““ Signature line 3:““ Signature line 4:““ To Address 1:““ Re-send interval:DISABLE Off Line:DISABLE Consumable Message:DISABLE Toner Low/Out:DISABLE Paper Low/Out:DISABLE Paper Jam:DISABLE Cover Open:DISABLE Stacker Error:DISABLE Mass Storage Error:DISABLE Recoverable Error:DISABLE Service Call Req.:DISABLE To Address 2:““ Re-send interval:DISABLE Off Line:DISABLE Consumable Message:DISABLE Toner Low/Out::DISABLE Paper Low/Out:DISABLE Pap
Summary of the content on the page No. 14
Cover Open:DISABLE Stacker Error:DISABLE Mass Storage Error:DISABLE Recoverable Error:DISABLE Service Call Req.:DISABLE To Address 5:““ Re-send interval:DISABLE Off Line:DISABLE Consumable Message:DISABLE Toner Low/Out:DISABLE Paper Low/Out:DISABLE Paper Jam:DISABLE Cover Open:DISABLE Stacker Error:DISABLE Mass Storage Error:DISABLE Recoverable Error:DISABLE Service Call Req.:DISABLE POP3 protocol:DISABLE POP3 server:““ POP port number:110 POP3 server User ID:““ POP3 server Password:““ User APOP
Summary of the content on the page No. 15
Configuration utility Available utilities You can configure the OkiLAN 7300e by using one of the following methods: Utility Features System requirements Quick Setup Configure the OkiLAN 7300e easily Windows95/98/Me/NT4.0/2000/ and simply without installing any XP (TCP/IP protocol or IPX/SPX software packages into your protocol should be installed). system. You can set the following: To create a NetWare queue, Enable/disable TCP/IP, NetWare, NetWare Client 32 or IntranetWare EtherTalk, NetBEU
Summary of the content on the page No. 16
Using Quick Setup Quick Setup utility allows you to configure the OkiLAN 7300e easily and simply without installing any software packages. You can configure the following: > Enable/disable TCP/IP, NetWare, EtherTalk, NetBEUI protocols. > Set IP address, Subnet Mask and Gateway for TCP/IP manually or by using DHCP. > Set NetWare mode and create Queue/Print Server/Printer objects. > Zone name and Port name for EtherTalk. Configuration requires a PC with Windows 95/98/Me, Windows 2000 Advanced Ser
Summary of the content on the page No. 17
The following explanation uses Windows 98 as an example. 1. Insert the Network Software CD-ROM into the CD-ROM drive. The Setup Utility starts automatically. If it does not start, double- click setup.exe in the Windows folder on the CD-ROM. 2. Select [Network Card Setup] 3. Select [Network Card Quick Setup]. 4. Select the appropriate language. Configuration 16
Summary of the content on the page No. 18
5. Follow the on-screen instructions. > The NetWare Client 32 or IntranetWare Client should be installed on the PC used for the creation of network queues. Installation enables the user to create network queues and perform other functions. 6. If the settings are correct, click [Execute]. The new settings are transmitted to the network card but the network card is still operating with pre-transmission settings. 7. Click [Finish] to validate the new settings. Depending on the model, the printer ma
Summary of the content on the page No. 19
To create a NetWare queue, NetWare Client 32 or IntranetWare Client should be installed on to your system. The following explanation uses Windows 98 as an example. Installation 1. Insert the Network Software CD-ROM into the CD-ROM drive. The Setup Utility starts automatically. If it does not start, double- click autorun.exe in the Windows folder on the CD-ROM. 2. Select [Network Card Setup]. 3. Select [Network Card Standard Setup]. Configuration 18
Summary of the content on the page No. 20
4. Select the appropriate language. 5. Follow the on-screen instructions. If you want to install AdminManager on to your local drive, select [Install and Execute]. Otherwise, select [Execute from CD-ROM].. 6. To run AdminManager, check [Yes] for [Do you wish to execute AdminManager?] and click [Finish]. Otherwise, uncheck [No] and click [Finish]]. Configuration 19
