Summary of the content on the page No. 1
302403-C.mkr Page -1 Monday, May 24, 1999 4:30 PM
Installing Media
Dependent Adapters
(MDA)s
Part No. 302403-C Rev 00
June 1999
TM
Summary of the content on the page No. 2
302403-C.mkr Page 0 Monday, May 24, 1999 4:30 PM © 1999 by Nortel Networks, Inc. All rights reserved. Trademarks Nortel Networks is a registered trademark and BayStack is a trademark of Nortel Networks, Inc. All other trademarks and registered trademarks are property of their respective owners. Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, Nortel Networks, Inc. reserves the right to make changes to the products described
Summary of the content on the page No. 3
302403-C.mkr Page 1 Monday, May 24, 1999 4:30 PM Introduction This guide shows how to install media dependent adapters (MDAs) into supported Nortel Networks products. Table 1 lists the available MDA models. Table 1. MDA Models Interface Type Model Refer to: 10/100BASE-TX (UTP) • 400-4TX MDA page3 • 8100-4TX MDA 100BASE-FX (Fiber) • 400-2FX MDA page 6 • 8100-2FX MDA • 400-4FX MDA • 8100-4FX MDA 1000BASE-SX • 450-1SR MDA page 12 (Shortwave gigabit fiber) • 450-1SX MDA 1000BASE-LX • 450-1LR
Summary of the content on the page No. 4
302403-C.mkr Page 2 Monday, May 24, 1999 4:30 PM Table 2. Supported Products BayStack BayStack Accelar Model 1 350 /450 410 8132TX 400-4TX MDA Yes Yes No 400-2FX MDA Yes Yes No 400-4FX MDA Yes Yes No 450-1SR MDA Yes No Yes 450-1SX MDA Yes No Y es 450-1LR MDA Yes No Y es 450-1LX MDA Yes No Y es 8100-4TX MDA Yes Yes Yes 8100-2FX MDA Yes Yes Yes 8100-4FX MDA Yes Yes Yes 1 BayStack 350 10/100/1000 Series switches only. Note: The MDAs are not hot-swappable. Power down the BayStack switch or dis
Summary of the content on the page No. 5
302403-C.mkr Page 3 Monday, May 24, 1999 4:30 PM 10/100BASE-TX MDAs There are two 10/100BASE-TX MDA models (Figure 1): 1 2 400-4TX MDA 100 10 F Dx Activity 400-4TX MDA 5 4 3 1 2 8100-4TX MDA 100 10 F Dx Activity 8100-4TX MDA 5 4 3 BS45042B Figure 1. 10/100BASE-TX Models 3
Summary of the content on the page No. 6
302403-C.mkr Page 4 Monday, May 24, 1999 4:30 PM • 400-4TX MDA Not supported on the Accelar Series Modules (see Table 2 on page 2) • 8100-4TX MDA Supports BayStack 350/450, BayStack 410, and Accelar Series Modules (see Table 2 on page 2) Both models use four 10/100BASE-TX RJ-45 (8-pin modular) port connectors to attach Ethernet devices. The RJ-45 ports are configured as media-dependent interface-crossover (MDI-X) connectors. These ports connect over straight cables to the network inter
Summary of the content on the page No. 7
302403-C.mkr Page 5 Monday, May 24, 1999 4:30 PM Table 3. 10/100BASE-TX MDA Item Label Description 1 100 100BASE-TX port status LEDs (green): On: The corresponding port is set to operate at 100 Mb/s. Off: The link connection is bad or there is no connection to this port. Blinking: The corresponding port is management disabled. 2 10 10BASE-T port status LEDs (green): On: The corresponding port is set to operate at 10 Mb/s. Off: The link connection is bad or there is no connection to t
Summary of the content on the page No. 8
302403-C.mkr Page 6 Monday, May 24, 1999 4:30 PM (continued) Table 3. 10/100BASE-TX MDA Item Label Description 4 Activity Port activity LEDs (green): Blinking: Indicates the network activity level for the corresponding port. A high level of network activity can cause LEDs to appear to be on continuously. 5 10/100BASE-TX RJ-45 (8-pin modular) port connectors. For installation instructions, see “Installing an MDA” on page 22. 100BASE-FX MDAs Warning: Fiber optic equipment can emit lase
Summary of the content on the page No. 9
302403-C.mkr Page 7 Monday, May 24, 1999 4:30 PM Avertissement: L’équipement à fibre optique peut émettre des rayons laser ou infrarouges qui risquent d’entraîner des lésions oculaires. Ne jamais regarder dans le port d’un connecteur ou d’un câble à fibre optique. Toujours supposer que les câbles à fibre optique sont raccordés à une source lumineuse. Advertencia: Los equipos de fibra óptica pueden emitir radiaciones de láser o infrarrojas que pueden dañar los ojos. No mire nunca e
Summary of the content on the page No. 10
302403-C.mkr Page 8 Monday, May 24, 1999 4:30 PM There are four 100BASE-FX MDA models: • 400-2FX MDA Not supported on the Accelar Series Modules (see Table 2 on page 2) • 8100-2FX MDA Supports BayStack 350/450, BayStack 410, and Accelar Series Modules (see Table 2 on page 2) The 400-2FX MDA and the 8100-2FX MDA (Figure 2) each use two longwave 1300 nm SC connectors to attach devices over 62.5/125 micron multimode fiber optic cable. • 400-4FX MDA Not supported on the Accelar Series Modul
Summary of the content on the page No. 11
302403-C.mkr Page 9 Monday, May 24, 1999 4:30 PM 1 2 400-2FX MDA 100BASE-FX 100BASE-FX Link F Dx Activity TX RX TX RX 400-2FX MDA 4 3 1 2 8100-2FX MDA 100BASE-FX 100BASE-FX Link F Dx Activity TX RX TX RX 8100-2FX MDA 4 3 BS45071A Figure 2. 100BASE-FX MDA Models (1 of 2) 9
Summary of the content on the page No. 12
302403-C.mkr Page 10 Monday, May 24, 1999 4:30 PM 1 400-4FX MDA Link F Dx 2 Activity 400-4FX MDA 4 3 1 8100-4FX MDA Link F Dx 2 Activity 8100-4FX MDA 4 3 BS45072A Figure 3. 100BASE-FX MDA Models (2 of 2) Table 4 describes the 100BASE-FX MDA components and LEDs. 10
Summary of the content on the page No. 13
302403-C.mkr Page 11 Monday, May 24, 1999 4:30 PM Table 4. 100BASE-FX MDA Description Item Label Description 1 Link Communications link LEDs (green): On: Valid communications link. Off: Invalid communications link or no connection to this port. Blinking: The corresponding port is management disabled. 2 F Dx Full-duplex port status LEDs (green): On: The corresponding port is in full-duplex mode. Off: The corresponding port is in half-duplex mode. 3 Activity Port activity LEDs (green): B
Summary of the content on the page No. 14
302403-C.mkr Page 12 Monday, May 24, 1999 4:30 PM 1000BASE-SX MDAs Warning: This is a Class 1 Laser/LED product. It contains a laser light source that can injure your eyes. Never look into an optical fiber or connector port. Always assume that the fiber optic cable or connector is connected to a laser light source. Vorsicht: Dieses Laser/LED-Produkt der Klasse 1 enthält eine Laserlichtquelle, die zu Augenverletzungen führen kann. Sehen Sie nie in einen Lichtwellenleiter oder Glasfa
Summary of the content on the page No. 15
302403-C.mkr Page 13 Monday, May 24, 1999 4:30 PM Avvertenza: Questo è un produtto laser/LED di Classe 1 e contiene una sorgente luminosa a laser che può danneggiare gli occhi. Non guardare mai all’interno di una port a fibra ottica o di una porta connettore. Dare sempre per scontato che il cavo di fibra ottica o il connettore siano collegati ad una sorgente luminosa a laser. 13
Summary of the content on the page No. 16
302403-C.mkr Page 14 Monday, May 24, 1999 4:30 PM There are two 1000BASE-SX (shortwave gigabit) MDA models (Figure 4): 1 2 450-1SR MDA (1-port redundant) 1000BASE-SX 1000BASE-SX Link Phy Select Activity TX RX TX RX 450-1SR MDA 4 3 1 2 450-1SX MDA (single port) 1000BASE-SX Link Phy Activity TX RX 450-1SX MDA 4 3 BS45044A Figure 4. 1000BASE-SX MDA Front Panels 14
Summary of the content on the page No. 17
302403-C.mkr Page 15 Monday, May 24, 1999 4:30 PM • The 450-1SR MDA is a single MAC MDA with a separate redundant Phy (backup Phy port). Only one Phy port can be active at any time. If the active Phy port fails, the redundant Phy port automatically becomes the active port. • The 450-1SX MDA is a single PHY MDA. Both models conform to the IEEE 802.3z 1000BASE-SX standard and use shortwave 850 nm fiber optic connectors to connect devices over multimode (550 meter) fiber optic cable. Ta
Summary of the content on the page No. 18
302403-C.mkr Page 16 Monday, May 24, 1999 4:30 PM Table 5. 1000BASE-SX MDA Description Item Label Description 2Phy Phy status LEDs (green): (or) Phy Select On: The corresponding Phy port is active. Off: The corresponding Phy port is in backup mode or there is no connection to this port. 3 Activity Port activity LEDs (green): Blinking: Indicates network activity level for the corresponding port. A high level of network activity can cause LEDs to appear to be on continuously. 4 1000BA
Summary of the content on the page No. 19
302403-C.mkr Page 17 Monday, May 24, 1999 4:30 PM 1000BASE-LX MDAs Warning: This is a Class 1 Laser/LED product. It contains a laser light source that can injure your eyes. Never look into an optical fiber or connector port. Always assume that the fiber optic cable or connector is connected to a laser light source. Vorsicht: Dieses Laser/LED-Produkt der Klasse 1 enthält eine Laserlichtquelle, die zu Augenverletzungen führen kann. Sehen Sie nie in einen Lichtwellenleiter oder Glasfa
Summary of the content on the page No. 20
302403-C.mkr Page 18 Monday, May 24, 1999 4:30 PM Avvertenza: Questo è un produtto laser/LED di Classe 1 e contiene una sorgente luminosa a laser che può danneggiare gli occhi. Non guardare mai all’interno di una port a fibra ottica o di una porta connettore. Dare sempre per scontato che il cavo di fibra ottica o il connettore siano collegati ad una sorgente luminosa a laser. 18
