Furuno TR-1 user manual

Summary of the content on the page No. 1

“The Integrator”
NMEA 0183 to AD10 Converter
for Furuno Radar/Chartplotters
Installation and User Manual
906-2800-00
Ver A01

Summary of the content on the page No. 2

Thank You Thank you for purchasing another quality product from TR-1 Autopilots. TR-1 is confident that you will find this piece of electronic equipment will enhance your autopilot’s ability to make your boating experience safer and more enjoyable. Summary “The Integrator” AD10 Gateway provides the ability to interface with (Furuno) radars/chartplotters that utilize the AD10 data format. The Integrator will allow the owner of a TR-1 Gladiator Autopilot to directly interface with radars/c

Summary of the content on the page No. 3

NMEA Wire Mounting Considerations The Integrator unit is mounted on any fl at surface, using two #6 screws provided, through the mounting holes in the case. The unit should be located so its LED is visible to the helmsman during normal boat operation, but not directly in the line of vision due to the brightness of the LED. Although the Integrator is a completely sealed unit it should be mounted in a location that is not subject to immersion or water from wash down. Installation Installation

Summary of the content on the page No. 4

NMEA Configuration The TR-1 Gladiator’s NMEA output should be set to send at its highest rate (10 Hz). The Gladiator’s default setting is 10Hz. If you have changed this setting or do not know what setting it is on, follow these instruc- tions. Press and release the [Setup] button on the handheld, Setup LED will illuminate. Enter code 49 by Pressing and releasing once to illuminate the 4 LED, and pressing and releasing the