Summary of the content on the page No. 1
IQ Probe
Frame Relay
Monitoring Probe
USER MANUAL
IQ Probe Unit 1200214L1
ESP 4-wire SW56 DBU Card 1204001L1
ESP V.34 DBU Card 1204002L1
ESP ISDN DBU Card 1204004L1
ESP External DCE Card 1204006L1
61200214L1-1A
August 1998
Summary of the content on the page No. 2
Trademark Information: OpenView is a registered trademark of Hewlett-Packard Company. SunNet Manager is a registered trademark of Sun Microsystems, Inc. Netview is a registered trademark of IBM. IQ View is a trademark of ADTRAN, Inc. This product includes software developed by the University of California, Berkeley, and its contributors. 901 Explorer Boulevard P.O. Box 140000 Huntsville, AL 35814-4000 Phone: (256) 963-8000 © 1998 ADTRAN, Inc. All rights reserved. Printed in USA.
Summary of the content on the page No. 3
ABOUT THIS MANUAL This manual is arranged so you can quickly and easily find the information you need. The following is an overview of the contents of this manual: • Chapter 1, Introduction, familiarizes you with frame relay networks and IQ Probe highlights. • Chapter 2, Installation, describes the IQ Probe connectors (pin assignments are given in Appendix A) and provides an installation diagram. • Chapter 3, Operation, explains how to operate your IQ Probe using either the front panel or a ter
Summary of the content on the page No. 4
Notes provide additional useful information. Cautions signify information that could prevent service interruption. Warnings provide information that could prevent damage to the equipment or endangerment to human life. IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS When using your telephone equipment, please follow these basic safety precautions to reduce the risk of fire, electrical shock, or personal injury: 1. Do not use this product near water, such as near a bath tub, wash bowl, kitch
Summary of the content on the page No. 5
FCC regulations require that the following information be provided in this manual: 1. This equipment complies with Part 68 of the FCC rules. On the bottom of the ESP DBU card is a label that shows the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, provide this information to the telephone company. 2. If this equipment causes harm to the telephone network, the telephone company may temporarily discontinue service. If possible, advance notification
Summary of the content on the page No. 6
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual
Summary of the content on the page No. 7
CANADIAN EQUIPMENT LIMITATIONS Notice: The Canadian Industry and Science Canada label identifies certified equipment. This certification means that the equipment meets certain telecom- munications network protective, operational, and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfac- tion. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company.
Summary of the content on the page No. 8
ISDN Service Ordering Information for the ADTRAN IQ Probe With ISDN Dial Backup For ADTRAN IQ Probe ISDN dial backup applications, the following guide can be used as an aid in ordering basic ISDN service from your local telephone company. The ADTRAN IQ Probe ISDN includes NT1 and Terminal adapter functionality and supports data rates up to 128 kbps. Request an ISDN Basic Rate Interface (BRI) line with the following features: U-interface reference point 2B1Q line coding 1B+D Service (supports up
Summary of the content on the page No. 9
Turn the Following Features Off: Packet Mode Data Multi-line Hunt Multiple Call Appearances Electronic Key Telephone Sets (EKTS) Shared Dictionary Numbers Accept Special Type of Number Intercom Groups Network Resource Selector (Modem Pools) Message Waiting Hunting InterLata Competition For service offered from a Northern Telecom DMS-100, request a Point-to-Point Multi-Point line with the following features: Line Type: Basic Rate, Functional Electronic Key Telephone Sets (EKTS): No Call Appearan
Summary of the content on the page No. 10
Table of Contents
Summary of the content on the page No. 11
Table of Contents Table of Contents Chapter 1. Introduction Product overview ................................................................................................................... 1 Understanding Frame Relay ................................................................................................. 2 SNMP Management ............................................................................................................... 3 Network Manager ................................
Summary of the content on the page No. 12
Table of Contents Numeric Keypad .................................................................................................... 14 Next, Prev, Add, Delete ......................................................................................... 14 Shift .......................................................................................................................... 14 LED Descriptions .................................................................................................
Summary of the content on the page No. 13
Table of Contents Chapter 6. DTE Port Configuration Physical Layer Options (PHYS LYR OPTS) ............................................................... 44 Interface Type ......................................................................................................... 44 Flow Control ........................................................................................................... 44 None ........................................................................................
Summary of the content on the page No. 14
Table of Contents Management DLCI 1 and 2 Mode (DLCI 1 and 2 MODE) ...................................... 52 Maximum PVC Count (MAX PVC COUNT) ............................................................ 53 History Interval Count (HIST INT COUNT)............................................................. 53 PVC Options (PVC CONFIG) ...................................................................................... 53 DLCI .....................................................................
Summary of the content on the page No. 15
Table of Contents SPID 1/2 ........................................................................................................... 62 LDN 1/2 ........................................................................................................... 62 DCE Options ........................................................................................................... 62 Interface Type .................................................................................................. 62 DBU
Summary of the content on the page No. 16
Table of Contents V=View by Day/View by Interval ............................................................... 72 DTE Port Statistics ......................................................................................................... 73 DCE Port Statistics......................................................................................................... 76 DBU Port Statistics ........................................................................................................ 81
Summary of the content on the page No. 17
Table of Contents List of Tables Table 4-A Example Settings for Dial Backup Options ................................................. 36 Table 4-B Example Settings for PVC Configuration Table ......................................... 36 Table A-A Pin Assignments for 10baseT Connector ................................................... 107 Table A-B Pin Assignments for Control Connector .................................................... 108 Table A-C EIA-232 Connector Pin Assignments ..........
Summary of the content on the page No. 18
Table of Contents Figure 10-5 DCE Port Statistics (View by Day)................................................................ 79 Figure 10-6 DBU Port Statistics (View by Interval) ......................................................... 83 Figure 10-7 DBU Port Statistics (View by Day) ............................................................... 84 Figure 10-8 DLCI Statistics for a Specific DLCI (View by Interval) .............................. 86 Figure 10-9 DLCI Statistics Summary for All
Summary of the content on the page No. 19
Chapter 1. Introduction Chapter 1 Introduction PRODUCT OVERVIEW The ADTRAN IQ Probe provides the visibility and control needed for both the physical and logical connections made in frame relay networks. The IQ Probe provides logical layer monitoring and management for frame relay. Each permanent virtual circuit (PVC) accessed through an IQ Probe is managed end-to-end as if it were a leased line connection. Real-time statistics on throughput, bandwidth utilization, availability, bursting, con
Summary of the content on the page No. 20
Chapter 1. Introduction information rates (CIRs), and excess burst rates on each PVC • True non-intrusive, in-band transmission of statistics • Embedded SNMP and TELNET through the DTE, DCE, or SLIP/PPP port • Embedded SNMP and TELNET access available through the integrated 10baseT ethernet port • Control port provides SLIP and async PPP access to SNMP or VT 100 terminal configuration • Dial backup (DBU) available with ESP DBU cards; options include 4-wire Switched 56 (SW56), V.34, ISDN, and e
