Stanton Professional performance mixer SK SIX user manual

Summary of the content on the page No. 1

FAD ER C LE A N I N G
The SK SIX faders may need lubrication from time to time. This will extend the
fader life and eliminate any potential damage due to extended heavy usage.
SK SIX Professional performance mixer
Cleaning Instructions cable coming from the mixer.
1. Remove the 3 fader knobs and 4 screws 3. Spray a small amount of cleaner or
located in the corners of the PROTEKTª lubricant into both ends of the fader and
(see Ò Ó inside) panel slide the fader back and forth a few times
and take

Summary of the content on the page No. 2

T RO U B LE S H O OT I N G Thank you for making Stanton your first choice in professional DJ mixers. Problem Cause Solution This new, innovative family of mixers has been developed with input from the profes- Excessive hum when using Poor ground connection. Properly connect turntable sional DJ community, bringing to the marketplace a previously unavailable, afford- phono source. ground wire to mixer ground able combination of user-friendly, functional design, rugged construction, and pro- termin

Summary of the content on the page No. 3

D E S C R I P TIO N OF F U N C TI O N S 1. Mic level control: Controls the overall microphone output level. 2. Send: Controls the level of the effect send output. this is used to set the level of the signal going to the outbpard effects processor or stomp box. 3. Return: Controls the level of the effect return input. This is used to control the level of the processed signal going back into themixer 4. FX: Effect ON/OFF for each channel, MIC, and cue. 5. Gain: Controls the input level of eac

Summary of the content on the page No. 4

F U N C TI O NS ( c o n t Õd) T E C H N I C A L S P E C I FI C AT I O NS Line inputs: 2 (RCA), 150 mV / 27K ohm Phono inputs: 2 (RCA), 3 mV / 47K ohm Semd: 2 (1/4Ó), 150 mV / 27K ohm Return: 2 (1/4Ó), 775 mV / 1K ohm DJ mic input: 1 (1/4 inch), 1.5 mV / 3K ohm Master output: 1 (1/4Ó TRS Balanced/RCA unbalanced), 1.2 V / 100 ohm Record output: 1 (RCA), 245 mV / 100 ohm Headphone output: 1 (1/4 inch), 32 - 200 ohms recommended Crossfader type: VCA Frequency Response: 20 Hz - 20 kHz, +/- 2 dB Tone