Summary of the content on the page No. 1
PLM mono blocs
INSTRUCTION MANUAL
ENGLISH
PLM
9000E12000E15000E
PLUS HEATER VERSIONS
Summary of the content on the page No. 2
THANK YOU! Thank you for choosing this innovative Amcor air conditioner. We suggest that you keep this manual in a safe place for future reference. It describes the many benefits and advanced features this unique product has to offer. Before you use your new air conditioner you should carefully read these instructions to maximise this product’s performance. For over 50 years Amcor has specialised in complete indoor environmental control, manufacturing and marketing; dehumidifiers, portable
Summary of the content on the page No. 3
SAFETY INSTRUCTIONS IMPORTANT • The unit is designed for indoor operation. • Rating: This unit must be connected to a 220-240 V / 50 Hz earthed outlet. • The installation must be in accordance with regulations of the country where the unit is used. If you are in any doubt about the electrical installation, have it checked and if necessary modified by a qualified electrician. • The air conditioner is safe. However, as with other electrical appliances, use it with care. • Keep out of th
Summary of the content on the page No. 4
PARTS Air outlet Control panel Air inlet Carrying handle Exhaust air outlet Cable storage Water stopper / Caster drainage point wheels Water container Exhaust hose Remote control Air filter Slide bar Telescopic slide bar connector Controls Display ON/OFF COOLING UP FAN HEAT DOWN HOURS:MINUTES MODE TEMPERATURE TIMER SLEEP FAN SPEED 4 4
Summary of the content on the page No. 5
INSTALLATION WARNING! Before using the air conditioner it should be left in an upright position for at least 2 hours. This unit can easily be moved from one room to another. In doing so keep this in mind: – Ensure that the unit is positioned upright, on a level surface and 50 cm away from obstacles. – To place the loose filters in the filter holder. • Take the filter holder out of the air conditioner • Open the filter holder and place the active carbon filter (black) and 3M Filtrete™ filter
Summary of the content on the page No. 6
Setting the temperature If you want to change the set temperature press or to set the temperature. The 2 digit display will indicate the set temperature. Note: Reaching the set temperature depends on the room and outdoor climatic conditions. Mode switch Press the button successively until the icon representing the desired mode is appearing (=> Cool => Fan => Heat => etc). On the LCD-display you will see: Cooling Fan only Heat Each time the unit starts, it starts operating in cool mo
Summary of the content on the page No. 7
Repeat OFF and ON Programming the timer for repeat OFF and ON - when the unit is RUNNING. • Perform the standard steps as described above. • Repeat the above procedure while the digits are still flashing for setting the ON. The circular time scale will be ON between 00:00 to the time set with the timer to OFF and from that time until 24:00. The flashing bar on the time scale indicates the real time and moves a segment ahead every 30 minutes. The unit will operate daily according to the timer
Summary of the content on the page No. 8
Dehumification If the unit will be used mainly as a dehumidifier just let the warm air return in the room. Continuous drainage is then necessary and more efficient. For continuous drainage: • Switch off the unit and remove the plug from the mains. • Remove the water stopper and rubber plug. • Connect a drain tube (ø 20 mm inner dimension) onto the water outlet and extend with extra water tube if needed. • Place the other end in a normal drain. Make sure that the tube is free from twists
Summary of the content on the page No. 9
• Slide out the filter frame from the unit. • Separate the filter fixer from the filter frame (see fig. 1). • Remove the active carbon filter (black) and the 3M Filtrete™ filter (white) from its plastic bag. • Insert the active carbon filter into the filter frame (see fig. 2). • Insert the 3M Filtrete™ filter into the filter frame (see fig. 3). • Fix the filter by reassembling the fixer into the filter frame (see fig. 4). NOTE! • Remove the 3M Filtrete™ filter and active carbon filter
Summary of the content on the page No. 10
CLEANING WARNING! First of all switch off the unit and remove the plug from the wall socket. Clean the housing with a soft, damp cloth. Never use aggressive chemicals, petrol, detergents or other cleansing solutions. Clean the screen filter regularly with a vacuum cleaner. See also “air filter” section. NOTE! Never use the air conditioner without the screen filter. TROUBLE SHOOTING Never try to repair or dismantle the air condition yourself. Incompetent repairs result in loss of warranty an
Summary of the content on the page No. 11
STORAGE Empty the internal water container. Clean the screen filter. Remove 3M Filtrete™ filter and active carbon filter. • Remove the 3M Filtrete™ filter and active carbon filter before end of season storage and install new filters at the beginning of the new season. The old filters can be disposed of in the ‘Non-biological rubbish container’. • Replacement filter packages are available from Amcor. Put the unit in Fan Only mode for a few hours to ensure that the inside becomes completely
Summary of the content on the page No. 12
