Summary of the content on the page No. 1
User Manual
EUROPOWER
PMP1000/PMP4000/PMP6000
500/1600-Watt 12, 16 and 20-Channel Powered Mixer
with Multi/Dual Multi-FX Processor and FBQ Feedback
Detection System
Summary of the content on the page No. 2
2 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual Table of Contents Important Safety Instructions ...................................... 3 Legal Disclaimer ............................................................. 3 Limited Warranty ........................................................... 3 1. Introduction ............................................................... 5 1.1 Before you get started ...................................................... 5 1.1.1 Shipment ...................
Summary of the content on the page No. 3
3 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual 9. Do not defeat the safety purpose of the polarized Limited Warranty Limited Warranty Important Safety Important Safety or grounding-type plug. A polarized plug has two blades Instructions Instructions § 1 Warranty with one wider than the other. A grounding-type plug (1) This limited warranty is valid only if you purchased has two blades and a third grounding prong. The wide the product from a BEHRINGER authorized dealer in the blade or the
Summary of the content on the page No. 4
4 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual (2) Subsequently, the product must be returned in (7) Any repair or opening of the unit carried out by § 9 Amendment its original shipping carton, together with the return unauthorized personnel (user included) will void the Warranty service conditions are subject to change without authorization number to the address indicated by limited warranty. notice. For the latest warranty terms and conditions MUSIC Group. (8) If an inspection of the pr
Summary of the content on the page No. 5
5 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual 1. Introduction The mains connection is made using the enclosed power cord and a standard IEC receptacle. It meets all of the international safety certification requirements. Congratulations! With the PMP1000/PMP4000/PMP6000 you have acquired a state-of-the-art power mixer that sets new standards. Right from the very start ◊ Please make sure that all units have a proper ground connection. it has been our goal to design a revolutionary unit that
Summary of the content on the page No. 6
6 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual (57) (58) (61) (62) (65) (55) (18) (35) (19) (22) (20) (60) (64) (2) (1) (21) (27) (3) (26) (4) (30) (6) (32) (31) (33) (8) (34) (36) (9) (43) (39) (37) (11) (44) (56) (42) (13) (14) (52) (40) (29) (16) (17) (47) (46) (54) (48) EUROPOWER PMP1000 FRONT PANEL
Summary of the content on the page No. 7
7 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual (56) (55) (57) (58) (59) (62) (18) (23) (63) (19) (64) (22) (20) (65) (60) (61) (26) (27) (43) (44) (2) (1) (21) (3) (4) (24) (31) (5) (34) (32) (6) (25) (30) (33) (8) (9) (54) (35) (10) (36) (38) (53) (11) (37) (42) (13) (14) (40) (52) (15) (45) (16) (41) (17) (46) (47) (48) (49) EUROPOWER PMP4000 FRONT PANEL
Summary of the content on the page No. 8
8 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual (56) (55) (57) (58) (59) (62) (18) (23) (63) (19) (64) (22) (20) (65) (60) (61) (26) (27) (28) (29) (2) (1) (21) (3) (4) (34) (24) (31) (5) (32) (6) (25) (33) (7) (8) (54) (35) (9) (36) (53) (37) (10) (38) (52) (11) (42) (39) (50) (12) (43) (40) (41) (13) (14) (51) (44) (15) (45) (16) (17) (46) (47) (48) (49) EUROPOWER PMP6000 FRONT PANEL
Summary of the content on the page No. 9
9 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual (66) (69) (70) (67) (68) (72) (71) EUROPOWER PMP6000 REAR PANEL 2. Control Elements (12) The PMP6000 has two FX controls (FX 1 and FX 2), so that you can use two effects simultaneously. Accordingly, the PMP6000 also has two effect aux A detailed description of all functions of your power mixer can be found in the buses, which have one output jack in common (see (46) and (64)). following chapters. Please also refer to the enclosed sheet with
Summary of the content on the page No. 10
10 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual ◊ PMP1000: This does not apply to the mono/stereo combination (27) The AMP MODE switch determines the mode of operation of the channels 5/6 and 7/8. PMP amplifier stage: (20) INSERT I/O. Insert points or simply inserts are used to process a signal with PMP1000: dynamic processors or equalizers. They are pre-fader, pre-EQ and pre-MON/ MAIN: In the “MAIN” position the mixer works as a stereo amplifier. FX SEND. Unlike reverb and other effects, whic
Summary of the content on the page No. 11
11 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual (31) Press the FBQ IN switch to activate the Feedback Detection (42) The FX 1/2 TO MAIN control allows you to determine the effect intensity of system (the FBQ will be active only if you have switched on the multi-effects processor in the main mix. No effect is sent to the main mix the equalizer (33) before). Frequencies causing feedback are with this control turned fully counter-clockwise. shown by brightly lit fader LEDs. All other LEDs will
Summary of the content on the page No. 12
12 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual 2.4.1 Connectors ◊ Please note: The SEND signal is in parallel with the FX SEND jacks and with the effects processor, so that both can be controlled together by (55) Use the CD/TAPE INPUT jacks (RCA) to connect an external stereo signal, one control. such as a CD player, tape deck or other line-level sources. ◊ For the FX signals, use a 1/4" stereo plug connected as follows : (56) The VOICE CANCELLER filters vocal-specific frequencies from F
Summary of the content on the page No. 13
13 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual Effect Presets of EUROPOWER PMP6000 No. EFFECT Description No. EFFECT Description HALL 00-09 DELAY 50-59 00 SMALL HALL 1 approx. 1.0s reverb decay 50 SHORT DELAY 1 Like a short shattering 01 SMALL HALL 2 approx. 1.2s reverb decay 51 SHORT DELAY 2 1-2 short impulse(s) 02 SMALL HALL 3 approx. 1.5s reverb decay 52 SHORT DELAY 3 1-2 short impulse(s) 03 MID HALL 1 approx. 1.8s reverb decay 53 MID DELAY 1 Classical Delay for up-tempo music (115-125 BPM)
Summary of the content on the page No. 14
14 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual 4. Installation Balanced ¼" TRS connector 4.1 Mains connection strain relief clamp The mains connection is made using the enclosed power cord and a standard IEC sleeve receptacle. It meets all of the international safety certification requirements. ring Blown fuses must be replaced by fuses of the same type and rating. tip ◊ Please make sure that all units have a proper ground connection. For your own safety, never remove or disable the groun
Summary of the content on the page No. 15
15 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual ¼" TRS footswitch connector Professional speaker connector strain relief clamp sleeve ring tip 1+ 1+ 1- 2- 1- 2- sleeve 2+ 2+ ground/shield front view rear view ring FX2 Fig. 4.6: Professional speaker connector with polarity allocation tip FX1 Please be sure to only use commercial cables (type NL4FC) for connecting your loudspeakers to the power mixer. Please check the pin assignment of your loudspeakers and cables dependent on the PMP speaker o
Summary of the content on the page No. 16
16 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual 5. Wiring Examples Subwoofer F.O.H. mix Monitor mix Loudspeaker connection (monitor mix) PMP1000 PMP4000 PMP6000 Rear panel EUROPOWER EP2000 PMP1000 PMP4000 PMP6000 (part view) 2 x BEHRINGER EUROLIVE Stack (B1800X & B1220, both passive) EUROLIVE VP1520 Loudspeaker connection (monitor mix) front panel (part view) EUROLIVE B1800X Subwoofer 2 x BEHRINGER F1220D Footswitch (active) Link Output 2 x BEHRINGER F1220D Fig. 5.2: Bridged mono operat
Summary of the content on the page No. 17
17 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual Loudspeaker connection for F.O.H and monitor mix (mono) Keyboard ULTRA-G GI100 V-AMP2 Electric bass Vocal mics Stereo channel PMP1000/PMP4000/PMP6000 Electric guitar 13/14 Rear panel (excerpt) CD player Mono DAT recorder channel 5 Mono channel 6 Mono channels 1-4 CD/tape CD/tape in out 2 x BEHRINGER EUROLIVE VP1220F 2 x BEHRINGER EUROLIVE VP1520 (passive) (passive) Fig. 5.3: Dual mono operation For a dual mono operation, the AMP MODE switch
Summary of the content on the page No. 18
18 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual BEHRINGER EUROLIVE VP1220 BEHRINGER EUROLIVE VP1220 BEHRINGER BEHRINGER PMP1000/PMP4000/ EUROLIVE B1800X EUROLIVE B1800X PMP6000 Rear panel Output B Output A B1800-Pro Active BEHRINGER Drums/percussion Subwoofer EUROPOWER EP2000 Vocals/voice MAIN 1 OUT BEHRINGER BEHRINGER B-2 PRO XM1800S MONO OUT Stereo inputs PHONS/CTRL OUT Keyboard Headphone amplifier BEHRINGER POWERPLAY PRO-XL HA4700 BEHRINGER MON 1/2 OUT V-AMP 3 Drum Computer CD/TAPE IN B
Summary of the content on the page No. 19
19 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual 6. Specifications PMP1000 Microphone Inputs Stereo Outputs Type XLR, electronically balanced input circuit Type RCA Mic E.I.N. (20 Hz - 20 kHz) Impedance approx. 1 kOhm @ 0 Ohm -134 dB / 136 dB A-weighted Max. input level +21 dBu source resistance Loudspeaker Outputs @ 50 Ohm -131.5 dB / 134 dB A-weighted source resistance Type Professional locking connector @ 150 Ohm -129 dB / 155 dB A-weighted Load impedance: source resistance MAIN L/R 4 -
Summary of the content on the page No. 20
20 EUROPOWER PMP1000/PMP4000/PMP6000 User Manual PMP4000 Power Supply Microphone Inputs Mains voltage Type XLR, electronically balanced input circuit USA/Canada 120 V~, 60 Hz Mic E.I.N. (20 Hz - 20 kHz) China/Korea 220 V~, 50/60 Hz @ 0 Ohm -134 dB / 136 dB A-weighted source resistance Europe/Australia 230 V~, 50 Hz @ 50 Ohm -131.5 dB / 134 dB A-weighted Japan 100 V~, 50 - 60 Hz source resistance Fuse 100 - 120 V~ T 5 A H 250 V @ 150 Ohm -129 dB / 155 dB A-weighted Fuse 220 - 240 V~ T 5 A
