Summary of the content on the page No. 1
PORTABLE
COMPACT DISC PLAYER
WITH ANTI-SHOCK 45SEC.
INSTRUCTION MANUAL
PLEASE READ CAREFULLY BEFORE USING YOUR UNIT
MODEL: JX-CD530
Summary of the content on the page No. 2
LOCATION OF CONTROLS CD MODE BUTTON ESP CD SKIP ( ) BUTTON PROGRAM BUTTON DC IN 4.5V ADAPTER JACK LCD (Liquid Crystal Display) (NOT INCLUDED) HOLD STOP BUTTON SWITCH (power off) PLAY/PAUSE (power on) BATTERY DOOR LINE OUT JACK PHONES JACK DOOR OPEN VOLUME BASS BOOST CONTROL SWITCH CONTROL OPERATION AND FUNCTION POWER SUPPLY Your CD player requires 2 size “AA” alkaline batteries (not included), or use the AC adapter (not included) AC ADAPTER OPERATION Plug one end of the AC adapter into
Summary of the content on the page No. 3
USE ONLY THE AC ADAPTER FOR CHARGING. 4. After 15 hours, please unplug the AC adapter and slide the recharge switch to normal position. DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO CAN CAUSE THE PERFORMANCE OF THE RECHARGEABLE BATTERIES TO DETERIORATE. NOTE: You may play DISC’S whilst charging the batteries. If the operating time decreases drastically even when the rechargeable nickel- cadmium batteries are properly recharged, purchase a new set of rechargeable nickel-cadmium batter
Summary of the content on the page No. 4
1. Plug the cord of headphone/earphone into the PHONES jack. 2. Slide the Door Open button to open the CD door. 3. Hold the disc with the label side up and press it onto the spindle until it “clicks” into place. 4. Close the disc compartment, press PLAY/PAUSE button, the disc will begin to spin, the display will indicate “01”, play will begin immediately from track number 1. 5. Adjust the volume as desired. 6. Set the BASS BOOST function as desired. 7. To stop play temporarily, press the PLAY/PA
Summary of the content on the page No. 5
5. After programming is finished, press the PLAY/PAUSE Button. Note: Programmed play will begins automatically if you program 24 tracks. “PROG” shows steady in the display and programmed play begins. 6. The player stops automatically after all programmed tracks have been played. To play the same program again, press the PLAY/PAUSE Button. The programming will be cleared if 1. Open the door 2. Power off 3. After random play 4. To check the program, press the STOP Button and then the PROGRAM butto
Summary of the content on the page No. 6
THE ANTI-SKIP MEMORY FUNCTION (45SEC.) The digital anti-skip function uses semiconductor memory to prevent the sound from skipping when the unit is subjected to shocks and vibration during play. 1. When the ESP button is pressed during play, the indicator appears in the ANTI-S display and the digital anti-skip function turns on. The digital data equivalent to approximately 3 seconds (45 seconds) of music is stored in a read-ahead memory buffer before it is decoded and played. The display change
Summary of the content on the page No. 7
CLEANING THE CABINET Wipe with a soft cloth. If the cabinet is very dirty, dampen (not dripping wet) the cloth with a weak solution of soap water, and then wipe clean. HANDLING COMPACT DISCS COMPACT 1. This unit is designed to play compact discs bearing the identifica- tion logo to the right. Discs that do not carry this logo may not DIGITAL AUDIO conform to the CD standard and may not play properly. 2. Dirty, scratched or warped discs may cause skipping or noise. Pay attention to the following:
Summary of the content on the page No. 8
TROUBLE SHOOTING GUIDE SYMPTOM CAUSE SOLUTION Dead or weak batteries. Replace both batteries. CD Player will not The AC adapter not Check the AC adapter connection at AC turn on. connected properly. outlet and side of set. Disc inserted incorrectly Re-insert disc with label side facing up. Defective or wrong type Try another audio compact disc. compact disc. Close lid securely (push down left corner Disc will not play. CD door not closed. of door) Take out the CD and leave the CD door Moisture h
