Summary of the content on the page No. 1
™
UNO -S2 Keypad
Rev. 2
Summary of the content on the page No. 2
SAFETY INFORMATION UNO-S2 Keypad 1. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. 2. Retain Instructions - The safety and operating instructions should be retained for future reference. 3. Heed Warnings - All warnings on the appliance in the operating instructions should be adhered to. 4. Follow Instructions - All operating and user instructions should be followed. 5. Water and Moisture - The appliance should not be used near water
Summary of the content on the page No. 3
TABLE OF CONTENTS UNO-S2 Keypad Front Panel......................................................................................4-5 Normal Operation ..............................................................................6 User Menu ......................................................................................7-8 Settings ............................................................................................9 Update Port .......................................................
Summary of the content on the page No. 4
USER GUIDE UNO-S2 Keypad Front Panel 1 7 2 6 3 5 4 4
Summary of the content on the page No. 5
USER GUIDE UNO-S2 Keypad Front Panel 1 LCD PANEL - 12-character backlit display shows status of the room, source, volume, and more 2 SOURCE SELECT BUTTON - Scrolls through the sources directly connected to the CAV6.6. Press and hold brings up the USER MENU for Loudness, Bass, Treble, etc. 3 VOLUME UP/DOWN BUTTONS - Raises and lowers the volume for the room 4 IR RECEIVER - Receives IR signals and passes them to the controller and source equip- ment. Also used when operating the UNO Keypad by usin
Summary of the content on the page No. 6
USER GUIDE UNO-S2 Keypad Normal Operation 1 2 3 / 4 / MODE: 1 “DND”- Do Not Disturb “SHARED”- Same source selected in multiple rooms “SYS-ON”- Indicates system on “PARTY”- Party Mode enabled “MASTER”- Master Keypad in Party Mode 2 12-character display 3 Volume Indicator 4 Indicates the middle of setting range 6
Summary of the content on the page No. 7
USER GUIDE UNO-S2 Keypad User Menu Zone On/Off Source Select Button Press and release to turn on the UNO scrolls through the six A/V source System Keypad. This also turns on the cor- inputs and the Aux source. To change responding CAV6.6’s room, and any pre- sources, press and release . As the sets previously assigned will be activated, sources are sequentially selected, each including settings for bass, volume, last source's name appears on the keypad LCD source selected, etc. Press and releas
Summary of the content on the page No. 8
USER GUIDE UNO-S2 Keypad User Menu The following keys are used to navigate button until SAVED is displayed on the and make changes while using the User LCD panel. Now a press and release of the Menu: button will recall the favorite preset. To set a favorite numbered disc or channel, use To enter the User Menu, press and hold during normal operation. or to select a disc or channel (e.g., channel 45). Wait for the keypad to show To exit the User Menu, press and release . the source name, then pre
Summary of the content on the page No. 9
USER GUIDE UNO-S2 Keypad Settings Feature and Setting: a Master Keypad (if enabled) but only one 1. BASS -10 < Bass:Flat > +10 Master Keypad may exist at a time in Party 2. TREBLE -10 < Treble:Flat > +10 Mode. Selecting Master Keypad mode from another keypad will transfer Master Keypad 3. LOUDNESS (more bass, fuller sound) control to that room and release it from the On or Off first. When the source selected in the Master 4. BALANCE Left -10 < Center > Right +10 Keypad room is changed then th
Summary of the content on the page No. 10
Summary of the content on the page No. 11
INSTALLER GUIDE UNO-S2 Keypad Rear Panel 2 3 1 4 1 EXTERNAL IR RECEIVER IN CONNECTOR - Connection for an external IR Receiver. 2 OS UPDATE JUMPER - Selects “Run” or “OS Update” mode. 3 RESET BUTTON - Reset whenever changing from RUN to OS update 4 110 PUNCHDOWN CONNECTOR - Termination for CAT-5 connection between the UNO-S2 Keypad and the CAV6.6 controller. 11
Summary of the content on the page No. 12
Summary of the content on the page No. 13
INSTALLER GUIDE UNO-S2 Keypad Location The best infrared remote performance is double-gang electrical box. achieved with the keypad installed away Route CAT-5 wire to the junction box from from any direct sunlight, plasma TV, and low the CAV6.6. voltage lighting controls. Also consider con- Use the supplied 110 punchdown tool to venience when choosing a location. connect each wire to its corresponding Choose a place that is easily seen from color labeled on the punchdown terminal the position wh
Summary of the content on the page No. 14
INSTALLER GUIDE UNO-S2 Keypad Connections Punchdown Tool Jumper Setting (back of keypad) CAT-5 Connections (back of keypad) Punchdown Tool OS Update Port (front of keypad) 14
Summary of the content on the page No. 15
INSTALLER GUIDE UNO-S2 Keypad Connections CAT-5 Connection OS Update Port The UNO-S2 Keypad uses a 110-punch- The OS Update Port is is used to update the down terminal to provide a simple installa- UNO-S2 Keypad operating system software tion and strong connection for CAT-5 in the future. When an update is released, it cable’s eight conductors. Punchdown ter- will be available online through the Document minals require the use of a punchdown Center at www.russound.com. Look for the tool which ha
Summary of the content on the page No. 16
INSTALLER GUIDE IR Receiver Connection Back of UNO-S2 Back of Russound 858 The UNO-S2 keypad has an EXTERNAL IR RECEIVER IN terminal for connecting an external IR Receiver such as the Russound 858, SaphIR Eye, or SaphIR Phantom. Use 2 twisted pair wire with one pair connecting GND (GROUND) and IR (SIGNAL) and the other pair con- necting ST (STATUS) and V+ (+12VDC). Connect the shield or drain to ground at the UNO-S2 only. 16
Summary of the content on the page No. 17
TECHNICAL SPECIFICATIONS Technical Specifications Dimensions: 3.65"W x 1.125"D x 4.3"H (9.2 x 10.9 x 2.8 cm) Fits 2 Gang UL/CSA Approved Junction Box Weight: 9 oz. (255 g) Power Requirements: 12 VDC 180mA CAT-5 Connection: 110 punchdown 17
Summary of the content on the page No. 18
WARRANTY Warranty Repair The Russound UNO-S2 is fully guaranteed against all defects in materials and workman- ship for two (2) years from the date of purchase. During this period, Russound will replace any defective parts and correct any defect in workmanship without charge for either parts or labor. For this warranty to apply, the unit must be installed and used according to its written instructions. If service is necessary, it must be performed by Russound. The unit must be returned to Russou
Summary of the content on the page No. 19
WARRANTY Russound sells products only through authorized Dealers and Distributors to ensure that customers obtain proper support and service. Any Russound product purchased from an unauthorized dealer or other source, including retailers, mail order sellers and online sell- ers will not be honored or serviced under existing Russound warranty policy. Any sale of products by an unauthorized source or other manner not authorized by Russound shall void the warranty on the applicable product. Damage
Summary of the content on the page No. 20
Russound 5 Forbes Road, Newmarket, NH 03857 tel 603.659.5170 • fax 603.659.5388 e-mail: tech@russound.com www.russound.com Rev. 2 28-1141
