Hobart N50 ML-33777 user manual

Summary of the content on the page No. 1

I
N
S
T
N50 MIXER
R
U
C
T
I
O
N
S
N50 MIXER
MODEL
N50 ML-33777
701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
937 332-3000
www.hobartcorp.com FORM 15340 Rev. B (Feb. 2000)

Summary of the content on the page No. 2

Installation, Operation, and Care of N50 MIXER SAVE THESE INSTRUCTIONS GENERAL 1 The model N50 mixer is a 5 quart, countertop mixer equipped with /6 H.P. motor, #10 attachment hub, and cord and plug as standard equipment. There are a variety of attachments and accessories available for the N50, and these are explained in a separate Use and Applications Handbook which is supplied with each mixer. INSTALLATION UNPACKING Immediately after unpacking the mixer, check for possible shipping damage. If

Summary of the content on the page No. 3

OPERATION WARNING: MOVING BEATER IN BOWL. KEEP HANDS, CLOTHING, AND UTENSILS OUT WHILE IN OPERATION. CONTROLS The ON-OFF SWITCH is used to start and stop the mixer. The GEAR SHIFT LEVER (Fig. 1) is used to change speeds. Always stop the mixer before changing speeds. To change speeds, turn the switch Off, move the gear shift lever to the desired speed, and turn the switch back On. NOTE: There is a mechanism which prevents the gear shift lever from being moved with the switch in the ON positio

Summary of the content on the page No. 4

Attachments To install an attachment, loosen the thumb screw on the attachment hub (Fig. 1) and remove the plug. Insert the attachment into the attachment hub making certain that the square shank of the attachment is in the square driver of the mixer. Secure the attachment by tightening the thumb screw. Move the gear shift lever to the desired speed and start the mixer to operate the attachment. The meat and food chopper attachment should be operated in second or third speed. If material in th