Summary of the content on the page No. 1
INSTALLATION INSTRUCTIONS.
WAVE/HOOD
WAVE-CONVECTION
instructions Installation
These Save And Read
106 KHMC MODEL: HOOD MICRO
105 KHMS MODEL: MICRO
BUlLT4N 30”
KitchenAid@
’
Summary of the content on the page No. 2
TWO to If a a -1 installed. is MicrowaveB-lood the before electrician qualified by connected be should it required, is outlet electrical new product. this in-iall required are PEOPLE System. Microwave/Hood installing before thoroughly instructions all read Please INTRODUCTION -.
Summary of the content on the page No. 3
on a ,30” I 66” J For of for or a of of 3 System. Microwave/Hood the bottom the and backsplash range the top the between necessary is space 2-inch servicing, cleaning cover bottom System Microwave/Hood the removal t- FLOOR FROM MORE OR BACKSPLASH SURFACE COOKING FROM MORE OR below. shown as wall space mounting requires System Microwave/Hood SPACE MOUNTING
Summary of the content on the page No. 4
. WALL a If not to fill for Wall a of 2” x 4” or or to a of 2” x 4” For of a of 140 90 of of find of a 4 a to to find a a x 4” WOOD 31Sf’ WALL or of a to find of a of 16” or 24” from 4 mark. this be will studs adjacent any center The edges. the between way half mark placing then and stud the edges the nail small with wall the probing by located be can stud the center The PLASTER/LATH DRY STUDS installation. stud B. indicate will This sound. solid surface mounting the ac
Summary of the content on the page No. 5
from for door, door or or on door. of do not if In of short of for a cord a a of a of If to cord, a cord a a on of cord 115-120 15 or cord It not of or front of a or if not or if to cord to a 60 15 or 20 5 location. mounting System Microwave/Hood the above directly cabinet the inside located be should receptacle The receptacle. grounded single circuit, branch Amp. Hz, 120-Volt, AC separate connected be must plug and supply power The grounded. properly is appliance the whether
Summary of the content on the page No. 6
hood to a x 10” If round a not a 6” If or to to or to For x 10” or 6” round not 140 WALL to flow to a of When of of of of ELBOW 90° ELBOW 10 5 5 ELBOW 10” WIDE ELBOW ELBOW I I 25 5 10 1 I WALL 40 24 6 FT. FT. CAP ROOF CAP FT. FT. FT. 90’ 4.5O FT. FT. FT. ADAPTOR TRANSITION 45O @a DUCT EXHAUST ducts. typical some length equivalent feet approximate the shows below diagram The sections. duct straight all lengths the plus adaptors and transitions all lengths equ
Summary of the content on the page No. 7
5/8”, 3/32” l-1/2” Wood to (if for of for @ @ -~ I @ Wood 0 3/16 0 @ 30mm 0 @ 0 @ Damper Draft Back Grommet Hanger Cord Power 4xl2mm Screw Tapping Dia. Washer Flat 5x55mm Screw inch Bolts Toggle 5x30mm Screw - ~ NAME QUANTITY following: the include should product the with packed ) - ( hardware installation The HARDWARE INSTALLATION protectim. carton part use may You range. and product cloth drop Protective needed) opening exhaust cut Saw Bit Tape Bit Drill Drill E
Summary of the content on the page No. 8
1. a of or to from 2. on 1. 1 3. 2). 2 8 Figure SCREW HEAD PHILLIPS HEXAGONAL (Fig. openings) filter grease (inside screws head Philiips hexagonal two save and Remove Figure \ OPENINGS FILTER CREASE / / / SIDE FRONT Fig. in shown as side its unit the Stand damaged. being outercase the protect material other some carton the portion Use PLATE MOUNTING REMOVING PRODUCT OF PREPARATION
Summary of the content on the page No. 9
LOWER 3 4. out to from from of of of for to to to sides,) lower and upper both at outercase attached is plate (Mounting right. the it slide and you toward plate mounting pull Gently wall. the unit the mounting cedure pro- proper the aware be will you so levers mountrng the operation the with yourself Familiarize outercase. surface back plate mounting release will action This hooks. sliders release levers two Pull Figure SLIDERS LEVERS HOOKS
Summary of the content on the page No. 10
FOLLOWING (3) OF for of for follow to if If to 11; or for to 13. for on 2 4). to of Wall 14. 4 10 Figure page Cabinet Top and Preparation Proceed (Fig. provided screws tapping with cabinet case outer the Damper Backdraft the Attach Exhaust. Vertical assembled shipped is unit The Exhaust Vertical VENTILATION: OUTSIDE A. EXHAUST ALTERNATE FOR UNIT FAN HOOD ADAPTING page proceed exhaust, recirculating page proceed Exhaust, Horizontal prefer you Exhaust. Vertical desire you Damper
Summary of the content on the page No. 11
1. 9 5). 5 2. 6). 6 3. 7) 7 11 Figure (Fig. turn ‘/4 unit fan hood Rotate Figure (Fig. carefully unit fan hood Withdraw Figure (Fig. stay rear Remove screws. save and Remove Exhaust Horizontal VENTILATION: OUTSIDE B.
Summary of the content on the page No. 12
4. 8). 8 5. 2 9). up. 9 6. 7 10). 10 7. 15 12 installation. Damper Backdraft for page See Figure exhaust. horizontal for rotated now is unit fan hood The (Fig. screws remaining using Secure, Figure line not will screw safety the and placed improperly is unit fan hood the precisely, plate back the to stay rear attach cannot you If screw. this remove not Do installation. improper prevent to stay rear the on located is Screw Safety proceeding. before stay rear the in openings
Summary of the content on the page No. 13
t. I. 9 5 pg. 2. unit. 6 pg. 3. 11). 11 4. 12). 5. 2 9 pg. im- up. 3 & 4 12 6. 7 10 pg. It a time. 13 later at upon decided be venting outside should saved be Damper Backdraft the that recommended is exhaust. recirculating for required not is Damper Backdraft NOTE: 12). (Fig. screws remaining using Secure Figure again. steps Check line not will screw safety the and placed improperly is unit fan hood the precisely, plate back the to stay rear attach cannot you If screw.
Summary of the content on the page No. 14
WALL follow on Wall WALL 1. on of a of 140 If not to fill for 2. Wall for of 66” from floor 30” from For to hood of 2” of WALL 14 TEMPLATES. CABINET TOP AND TO CO range. backsplash above least at be should System Microwave/Hood bottom the lamp the access easier surface. cooking the and the least at is template wall top sure Make template. wall the as same the be should installation space installation. proper flat be must plate Mounting gaps, spacers use flat, is wall pounds. min
Summary of the content on the page No. 15
1. nuts. 2. mounting A, B, C D put nut 13). a stud, 3. 4. 1. mount- 2 14). 2. duct. 4. nut 14 nut 15). mounting nut nut 5. 6. mounting a minimum stud a c -WALL 15 15 15a Figure Figure Thickness Wall Than More Space 14a Figure (Open) (Closed) A-A Section A-A Section provided. screw wood with one of to plate Secure 15a). (Fig. tighten to clockwise bolt toggle Turn wall. of side other the on open not will toggle space, this leave not do you If tion). posi- closed
Summary of the content on the page No. 16
1. 16 2. 16. 3. 4. mounting mounting 6. mounting up. 16 back levers Push plate. to unit Press down. levers Pull plate. the from out slightly unit wall. the to xqsed P- hold and upward unit Lift plate. the of bottom the at hooks the on unit the people,hang (2) two Using cabinet. top of bottom the at hole the through cord supply power Thread Fig. in shown as blocks Styrofoam of top on system microwave/hood Place Figure range/cooktop of surface top on pieces) (2 blocks packing Styrof
Summary of the content on the page No. 17
7. mounting 8. 18). 18 9. 18). 10. 17 filters. grease Replace (Fig. screws tighten not, If fixed. securely are (a) levers both that Check Figure (Fig. opening) filter grease (inside levers to screws head Phillips hexagonal Screw support. your remove you when hooks lower and upper both at plate the to secure is unit the sure be to Check
Summary of the content on the page No. 18
10. fc) (d) for 19). 19 a of cord, to cord A short cord to from sur- or from if If cord (1) of cord of (2) cord a cord, (3) cord not or on or 18 accidentally. over tripped children by pulled be can it where surface cooking countertop the over drape will it that so arranged be should extension the and 3-wire grounding-type be must extension the appliance, the rating electrical the as great as least at be should extension the rating electrical marked the used, is extension an use. t
Summary of the content on the page No. 19
. 1. to 2. from 3. cord. 4. 5. for 1. (307931). for 19 exhaust. recirculating used is Filter KIT FILTER CHARCOAL ACCESSORIES use. inspector’s electrical local the instructions installation Keep Manual. Care and Use Read power in Plug oven. the material packing all Remove instructions according installed been has unit sure Make INSTALLATION FOR LIST CHECK
Summary of the content on the page No. 20
(f/74735 49085 MI Joseph, St. Inc. KitchenAid, MS032 km
