Summary of the content on the page No. 1
INSTRUCTION MANUAL
INSTRUCTION MANUAL
● ● L La ab bo or ra at to or ry y M Mo od de ell # # 4 44 42 20 00 0 ● ● A Ad dv va an nc ce ed d M Mo od de ell # # 4 44 42 20 02 2
● Professional Model # 44204 ● Professional Model # 44206
● Professional Model # 44204 ● Professional Model # 44206
Summary of the content on the page No. 2
Table of Contents Introduction …………………………………………………………………………………. 2 Laboratory Model # 44200 …………………………………………………………………. 3 Advanced Model # 44202 ………………………………………………………………….... 5 Professional Model # 44204 ………………………………………………………………… 8 Professional Model # 44206 ………………………………………………………………… 12 Care and Maintenance ……………………………………………………………………… 16 Warranty …………………………………………………………………………………….. 17 Introduction Congratulations on your purchase of a Celestron
Summary of the content on the page No. 3
Laboratory Microscope – Model # 44200 1. Head 11. Eyepiece 2. Pillar Stand Safety Screw 10. Eyepiece Tube 3. Pillar Stand 4. Pillar Stand Locking Knob 9. Objective Lens Housing 5. Focus Knob 8. Specimen Slide 6. Base 7. Stage Plate Figure 1 Standard Accessories Included with your Microscope
Summary of the content on the page No. 4
Assembling Your Microscope 1. Take the Styrofoam container out of the cardboard box. 2. Remove the tape from the Styrofoam container holding the two sections together. 3. Carefully remove the microscope and other parts and set them on a table, desk, or other flat surface. 4. Remove the plastic bag covering the microscope. 5. Install the stage plate (7) by putting it in the circular opening in the base (6). 6. Make sure the head (1) is parallel to the base (6). If it is not, then hold
Summary of the content on the page No. 5
Advanced Microscope – Model # 44202 1. Eyepiece & Rubber Eyecup 2. Diopter Ring 15. Pillar Stand Safety Screw 3. Head 14. Pillar Stand 4. Binocular Head Tension Screw 5. Objective Lens Housing 13. Pillar Stand Locking Knob 6. Specimen Slide Holder Clips 12. Focus Knob 7. Stage Plate 11. Top Light Illuminator 10. Power Cord 8. Base 9. Illuminato
Summary of the content on the page No. 6
Assembling Your Microscope 1. Take the Styrofoam container out of the cardboard box. 2. Remove the tape from the Styrofoam container holding the two sections together. 3. Carefully remove the microscope and other parts and set them on a table, desk, or other flat surface. 4. Remove the plastic bag covering the microscope. 5. Install the frosted/opaque stage plate (7) by putting it in the circular opening in the base (8). 6. Make sure the head (3) is parallel to the base (8). If it is no
Summary of the content on the page No. 7
Focusing To achieve the best focus for your microscope, not only can you make adjustments with the focus knobs, but you can also adjust the left diopter ring (2) of the left eyepiece (1) as well as the interpupillary distance between the eyepieces: 1. Rotate the knurled ring on the objective lens housing (5) to the 2x position (as seen looking straight at the microscope). It is best to begin viewing a specimen at low power, then switch to high power when needed. 2. Turn the focus knob (
Summary of the content on the page No. 8
Professional Model # 44204 1. Diopter Ring 2. Top Illuminator 16. Rubber Eyecups 15. Eyepiece 3. Pillar Stand 14. Head 4. Illuminator Lock Screw 13. Head Lock Screw 5. Pillar Locking Knob 12. Objective Lens Housing 6. Focus Knob 11. Specimen Slide Holder Clips 10. Stage Plate 7. Base
Summary of the content on the page No. 9
Magnification Table Objective Lens 2x 4x 20 Power 40 Power 10x Eyepieces 15x Eyepieces 30 Power 60 Power Assembling Your Microscope 1. Take the Styrofoam container out of the cardboard box. 2. Remove the tape from the Styrofoam container holding the two sections together. 3. Please note that one set of eyepieces will be on the top outer (UP) Styrofoam piece with tape over them. So make sure you remove these. 4. Carefully remove the microscope and other parts and set them o
Summary of the content on the page No. 10
Microscope Operation Viewing a Specimen To view a slide specimen without using the electric illuminator: 1. Carefully place a specimen slide under the specimen holder clips (11) and center the slide directly in the middle of the stage plate (10). For specimen slides, you should use the black/white stage plate. 2. Illuminate the specimen slide by using a nearby desk lamp, table lamp, bright overhead light, or use natural light if located near a window. 3. To focus on your speci
Summary of the content on the page No. 11
Focusing To achieve the best focus for your microscope, not only can you make adjustments with the focus knobs, but you can also adjust the left diopter ring (1) of the left eyepiece as well as the interpupillary distance between the eyepieces: 1. Rotate the knurled ring on the objective lens housing (12) to the 2x position (as seen looking straight at the microscope) all the way until it stops. It is best to begin viewing a specimen at low power, then switch to high power when needed.
Summary of the content on the page No. 12
Professional Model # 44206 16. Eyepiece 1. Diopter Ring 2. Top Illuminator 15. Head 3. Pillar Stand 14. Zoom Power Knob 4. Illuminator Lock Screw 13. Head Lock Screw 5. Pillar Locking Knob 12. Objective Lens Housing 6. Focus Knob 11. Specimen Slide Holder Clips 7. Base 10. Sta
Summary of the content on the page No. 13
Assembling Your Microscope 1. Take the Styrofoam container out of the cardboard box. 2. Remove the tape from the Styrofoam container holding the two sections together. 3. Carefully remove the microscope and other parts and set them on a table, desk, or other flat surface (See Figure 4a) 4. Remove the plastic bags from the stage plate (which is installed on the base) and from the binocular head (15). 5. Put the frosted stage plate (10) back into the circular hole in the base (7). 6. Re
Summary of the content on the page No. 14
Microscope Operation Viewing a Specimen To view a slide specimen without using the electric illuminator: 1. Carefully place a specimen slide under the specimen holder clips (11) and center the slide directly in the middle of the stage plate (10). For specimen slides, you should use the black/white stage plate. 2. Illuminate the specimen slide by using a nearby desk lamp, table lamp, bright overhead light, or use natural light if located near a window. 3. To focus on your speci
Summary of the content on the page No. 15
Focusing and Changing Power To achieve the best focus for your microscope, not only can you make adjustments with the focus knobs, but you can also adjust the left diopter ring (1) of the left eyepiece as well as the interpupillary distance between the eyepieces: Start with the zoom power knob (14) at the 0.7x position on the dial which is the lowest power (10x). It is usually best to begin viewing a specimen at low power, then zoom to high powers. The maximum power is 67x (dial at 4.5x)
Summary of the content on the page No. 16
Care and Maintenance Your Celestron microscope is a precision optical instrument and should be treated with care at all times. Follow these care and maintenance suggestions and your microscope will need very little maintenance throughout its lifetime. • When you are done using your microscope, remove any specimens left on the stage. • Turn off any electric illuminator knobs or switches. • Unplug any power cords being used. • Always place the dust cover over the microscope whe
Summary of the content on the page No. 17
C Ce elle es sttr ro on n T Tw wo o Y Ye ea ar r W Wa ar rr ra an ntty y A. Celestron warrants this microscope to be free from defects in materials and workmanship for two years. Celestron will repair or replace such product or part thereof which, upon inspection by Celestron, is found to be defective in materials or workmanship. As a condition to the obligation of Celestron to repair or replace such product, the product must be returned to Celestron together with proof-of-purchas
Summary of the content on the page No. 18
MANUAL DE INSTRUCCIONES MANUAL DE INSTRUCCIONES ● ● M Mo od de ello o d de e lla ab bo or ra at to or riio o N Nº º 4 44 42 20 00 0 ● ● M Mo od de ello o d de e lla ab bo or ra at to or riio o N Nº º 4 44 42 20 02 2 ● Modelo profesional Nº 44204 ● Modelo profesional Nº 44206 ● Modelo profesional Nº 44204 ● Modelo profesional Nº 44206
Summary of the content on the page No. 19
Índice Introducción ............................................................................................................................... 2 Modelo de laboratorio Nº 44200 ............................................................................................... 3 Modelo avanzado Nº 44202 ....................................................................................................... 5 Modelo profesional Nº 44204 ..........................
Summary of the content on the page No. 20
Microscopio de laboratorio – Modelo Nº 44200 1. Cabezal 11. Ocular 2. Tornillo de seguridad de la columna 10. Tubo del ocular 3. Columna 4. Perilla de traba de la columna 9. Alojamiento del objetivo 5. Perilla de enfoque 8. Pinzas sujetadoras del portaobjetos 6. Base
