Summary of the content on the page No. 1
© 2007 REVOLABS, INC. All rights reserved. No part of this
document may be reproduced in any form or by any means
I In ns st ta alllla at tiio on n a an nd d O Op pe er ra at tiio on n
I In ns st ta alllla at tiio on n a an nd d O Op pe er ra at tiio on n
without express written permission from Revolabs, Inc.
Product specifications are subject to change without notice.
G G G Gu u u uiiiid d d de e e e
Revolabs Solo™ Single Channel
Wireless Microphone System
Mo
Summary of the content on the page No. 2
Safety and General Information Table of Contents This section contains important information regarding safe and efficient Safety and General Information.....................................................1 system operation, and declarations of required certification / regulation compliance. Please read this information prior to using your Revolabs Introduction ....................................................................................4 system. System Components .............
Summary of the content on the page No. 3
WEEE Notification: Other Medical Devices If you use any other personal medical device, consult the manufacturer of The Waste Electrical and Electronic Equipment (WEEE) directive your device to determine if it is adequately shielded from RF energy. (2002/96/EC) is intended to promote recycling of electrical and Your physician may be able to assist you in obtaining this information. electronic equipment and their components at end of life. Export Law Assurances This product is controlled u
Summary of the content on the page No. 4
S S S Sy y y ys s s st t t te e e em m m m C C C Com om om omp p p po o o on n n ne e e en n n nt t t ts s s s IIIIn n n nt t t tr r r rod od od odu u u uc c c ct t t tiiiion on on on Your Revolabs Solo™ Single Channel System package Congratulations on the purchase of your Revolabs contains: Solo™ Single Channel wireless microphone system! This wireless system provides high band-width audio • Compact Charger Base from a compact wireless microphone enabling • Solo Wireless Micr
Summary of the content on the page No. 5
Mute Button Pressing the MUTE button toggles between muting (flashing RED LED status) and un-muting (flashing GREEN LED status) on the Wireless Microphone. Note: Press the MUTE button on a Microphone will similarly toggle between mute and un-mute and display on both status LEDs. Power Module The Charger Base requires 5VDC power. Plug the supplied AC adapter into a convenient 110-240VAC, 50-60Hz power outlet and the adapter into the power connector. USB Connection Use the supplied
Summary of the content on the page No. 6
4. Open the Volume settings for Sound recording to view the volume levels selected for the microphone input (Capture) on the computer. The Sounds and Audio Devices Properties dialog will display, as shown. The solo-Desktop device will be selected. 5. Make sure that the level for the Microphone is close to the top (maximum) and that the Mute box is not checked. 6. In the Sound playback section, open the Volume settings for to control the volume you hear in the Microphone’s earp
Summary of the content on the page No. 7
7. At the bottom of the Microphone section, click the Mute box in the Microphone section to prevent the Microphone directly feeding back its own audio to the earpiece (i.e. “sidetone”). It may be necessary to use the Options- Properties menu to display the Microphone volume control. IP telephony and computer telephony applications (e.g., Skype) may also offer options for controlling the audio levels and playback capabilities. Please consult the application guide for the software
Summary of the content on the page No. 8
1. Remove the microphone from the Charger Base. The double-flashing RED LED on the Microphone R R R Re e e ev v v vol ol ol ola a a ab b b bs s s s S S S Sol ol ol olo™ o™ o™ o™ W W W Wiiiir r r re e e elllle e e es s s ss s s s M M M Miiiic c c cr r r rop op op oph h h ho o o on n n ne e e es s s s and Charger Base confirm that the mic is paired Using with Wearable Wireless Microphone and muted. The wireless personal microphone uses encrypted 2. Attach the microphone to cloth
Summary of the content on the page No. 9
LED), to reduce noise while placing the microphone on the table. 2. TableTop microphones should be centered on the table with the integral grill pointed toward the users (uni-directional), or centrally located Turning the dial towards the earpiece, as shown in between users (omni-directional), from 2 to 5 feet the figure, will increase the volume, and turning (.75 to 1.75m) away. It is always better to be as the dial towards the microphone will decrease the close to the person spea
Summary of the content on the page No. 10
microphones for wireless freedom during open mic meetings, Q&A sessions, classrooms, etc. The Adapter does not provide phantom power or bias current so it cannot be used with condenser or electret microphones. 6. With the microphone attached, un-mute the Adapter by pressing and releasing the Mute button 7. 1. Mute button — press to mute, un-mute and pair (confirm by viewing flashing GREEN LED). microphone. Note: If the microphone has an on-board mute 8. 2. Rubber collar — du
Summary of the content on the page No. 11
be re-established to its original state, and the beeping Important: The Lithium Polymer rechargeable battery will cease. If not, the microphone will turn off. that powers the Microphone is not user serviceable. Please see the Revolabs website (www.revolabs.com) for Using with a Solo Executive Multi-channel System information regarding battery replacement and proper The Revolabs Solo™ Single Channel Wearable disposal procedures. Warning: Exposing the Microphone can be paired to a Solo Execu
Summary of the content on the page No. 12
Executive Single Channel system broadcast/receive alternately GREEN and RED for a few seconds and power. turn OFF. If this happens, repeat these steps. Pairing the Microphone to the Charger Base “Pairing” creates an encrypted association between the Wireless Microphone and the Charger Base with a unique electronic serial number. When the Microphone and Charger Base have been previously paired, the Microphone will automatically try to connect to the Charger Base whenever it is lifte
Summary of the content on the page No. 13
W W W Wa a a ar r r rr r r ra a a an n n nt t t ty y y y L L L LE E E ED D D D S S S St t t ta a a at t t tu u u us s s s IIIIn n n nd d d diiiic c c ca a a at t t tiiiion on on ons s s s Revolabs, Inc. warrants this product to be free of manufacturing The following LED patterns are shown on either the defects. Repair or replacement of any defective part or unit (at the Microphone or the Charger Base. discretion of the Seller) will be free of charge for the period of 90 LED Pat
Summary of the content on the page No. 14
S S S Sol ol ol olo o o o S S S Siiiin n n ng g g glllle e e e C C C Ch h h ha a a an n n nn n n ne e e ellll S S S Sp p p pe e e ec c c ciiiif f f fiiiic c c ca a a at t t tiiiion on on ons s s s Dimensions, (L, W, H) and Weight Single Channel Charger Base 3.9” (10 cm) x 2.4” (6 cm) x 1.0” (2.56 cm), 0.5 lb (0.23 kg) Wearable Microphone: 0.9” (2.3 cm) x 0.8” (2.0 cm) x 2.6” (6.6 cm), 0.05 lb (0.02 kg) TableTop Microphone: 1.5” (3.8 cm) x 0.8” (2.0 cm) x 3.3”
